1 rev. 051112
Model NJS0301
3 Ton Capacity Jack Stands (Pair)
For Technical Questions, Call: 1-800-879-7316
WARNING INFORMATION
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THESE STANDS, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using these stands. It is also the responsibility of the stand
owner to keep this manual intact and in a convenient location for all to see and read. Contact PowerStation, LLC for a replacement label if your
stand's label is not readable. If the operator is not uent in English, the product and safety instructions shall be read to and discussed with the opera-
tor in the operator's native language by the purchaser/owner or his designee, making sure that the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
The use of portable automotive lifting and support devices is subject to certain hazards that cannot be prevented by mechanical means, but only
by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use and operation
of the equipment who are careful, competent, trained, and qualied in the safe operation of the equipment and its proper use. Examples of hazards
are dropping, tipping or slipping of loads caused primarily by improperly secured loads, overloading, off-centered loads, use on other than hard level
surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
• Read, study, understand and follow all instructions before using.
• Inspect the jack stands before each use. Do not use if damaged, altered, modied, in poor condition, or have loose or missing
hardware or parts. Make corrections before using the stands.
• Wear eye protection that meets ANSI Z 87.1 and OSHA standards.
• Do not use beyond rated capacity. Do not shock load.
• Use only on a hard level surface capable of supporting the load.
• Stands are to be used in matched pairs to support one end of a vehicle only. Do not simultaneously support both ends
or one side of a vehicle.
• Apply the emergency brake, put the gear shift lever in park or gear if a manual shift transmission, and chock the tires that will not
be lifted off the ground.
• Center load on saddle. Do not use saddle lugs to support the load.
• Check the stands for solid contact with the ground and vehicle. Make sure the stands' locking pins are fully engaging the saddle columns'
and support columns' holes.
• Consult the vehicle manufacturer for the proper frame support locations.
• This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. Wash hands
thoroughly after handling.
• Failure to heed these warnings may result in personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS could
cause accidents resulting in serious or fatal personal injury and/or property damage.
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
WARNING
WARNING
WARNING
WARNING
