5
ADDITIONAL SAFETY RULES FOR TOOL
1. Wear eye protection.
2. Keep hands out of path of saw blade. Avoid
contact with any coasting blade. It can still cause
severe injury.
3. Do not operate saw without guards in place.
Check blade guard for proper closing before each
use. Do not operate saw if blade guard does not
move freely and close instantly. Never clamp or tie
the blade guard into the open position.
4. Do not perform any operation freehand. The
work piece must be secured firmly against the
turn base and guide fence with the vise during
all operations. Never use your hand to secure the
work piece.
5. Never reach around saw blade.
6. Turn off tool and wait for saw blade to stop
before moving work piece or changing settings.
7. Unplug tool before changing blade or servicing.
8. Always secure all moving portions before
carrying the tool.
9. Stopper pin which locks the cutter head down
is for carrying and storage purposes only and not
for any cutting operations.
10. Do not use the tool in the presence of
flammable liquids or gases.
11. Check the blade carefully for cracks or
damage before operation. Replace cracked or
damaged blade immediately.
12. Use only flanges specified for this tool.
13. Be careful not to damage the arbor, flanges
(especially the installing surface) or bolt. Damage
to these parts could result in blade breakage.
14. Make sure that the turn base is properly
secured so it will not move during operation.
15. For your safety, remove the chips, small
pieces, etc. from the table top before operation.
16. Avoid cutting nails. Inspect for and remove all
nails from the work piece before operation.
17. Make sure the shaft lock is released before the
switch is turned on.
18. Be sure that the blade does not contact the
turn base in the lowest position.
19. Hold the handle firmly. Be aware that the saw
moves up or down slightly during start-up and
stopping.
20. Make sure the blade is not contacting the
work piece before the switch is turned on.
21. Before using the tool on an actual work
piece, let it run for a while. Watch for vibration or
wobbling that could indicate poor installation or a
poorly balanced blade.
18. Use outdoor extension leads. When tool
is used outdoors, use only extension cords
intended for outdoor use.
19. Stay alert. Watch what you are doing. Use
common sense. Do not operate tool when you
are tired.
20. Check damaged parts. Before further use
of the tool, a guard or other part that is damaged
should be carefully checked to determine that it
will operate properly and perform its intended
function. Check for alignment of moving parts,
free running of moving parts, breakage of
parts, mounting and any other conditions that
may affect its operation. A guard or other part
that is damaged should be properly repaired
or replaced by an authorized service center
unless otherwise indicated in this instruction
manual. Have defective switches replaced by an
authorized service facility. Do not use the tool if
the switch does not turn it on and off.
21. Do not use other accessories. The use of
any accessory or attachment, other than those
recommended in this instruction manual may
present a risk of personal injury.
22. Have your tool repaired by a qualified
technician. This electric tool is in accordance
with the relevant safety requirements. Repairs
should only be carried out by qualified persons
using original spare parts, otherwise this may
result in considerable danger to the user.
23. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety
24. Children should be supervised to ensure
that they don’t play with the tool.
25. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similar qualified person in order to avoid a
hazard.
