SQUEALER-WRL –manual
The device works with SIM cards of different operators after the security PIN and PUK have been removed. To avoid problems in
operating the unit, it is recommended to read this manual thoroughly before using it. Do not interfere with construction or carry
out repairs yourself. Maintenance or repair work should be carried out by qualified personnel (installer or company service). The
manufacturer assumes no responsibility for any damage resulting from improper assembly, malfunction (device, software) or
damage to the controller. If the alarm module is equipped with an additional battery, after its service life, do not dispose of it
but dispose of it in accordance with the applicable regulations.
NOTE: The unit starts 60 seconds after the power supply to stabilize the sensor.
System description based on SQUEALER controller.
SQUEALER controller is a modern microprocessor device for continuous monitoring of the status of selected probes (MAX,
OILER, SLUDO). Basic functions of the siren:
• 3 sensor inputs (overflow, oil level, grease, petroleum and
sludge);
• 1 relay output
• Status of the controller, sensors and alarms can be
controlled (on the front panel (LEDs), beeps of the buzzer,
SMS messages)
• In the event of an alarm, the controller converts the signal
from the sensors, from the measurement zone to the visual
signal (LEDs on the housing), activates the acoustic signal
(internal buzzer) and activates one potential-free output
• Battery power
• USB port programming via NCONFIG software
• Sending SMS messages to 4 phone numbers (built-in GSM
module)
• memory of the last 255 events
• TMP - additional tamper input
The battery alarm module is used to measure and
control levels of sludge, oil, oil, petroleum and
tank overflows. It is equipped with a GSM
communication module, which enables
notification of tank status.
