3
1. INSTALLATION
Connect one end of the coil cord to the handset and the
other end to the socket located in the bottom of the
phone.Replacethehandsettothecradle.
NOTE: You will need to remove the wall mount
brackettoaccessthissocket.
Connect the small plug of the telephone line cord to the
socket at the back of the unit and the other plug to the
telephonesocketatthewall.
NOTE: If the RJ-11 to RJ-11 line cord is used, please
ensure that the Blue plug is connected to the wall
socket.
After connecting the telephone to the line socket, the
handset should be lifted to check dial tone is being
received. If the handset is not lifted, the telephone will
take about 15 seconds to power up during which time
anyincomingcallswillnotringtheunit.
2. OPERATION
2.1 Dialling
Lift the handset and dial the number. The telephone is
Installation & Operation
pre-setattonemode.
To terminate a phone call, simply replace the
handset.
If you want to terminate a call and make another call
immediately, you may press the NEW CALL key
once. The unit will terminate a call and let you dial
thenumberforanothercall.
2.2 ToneorPulseOption
Tofindoutwhetheryouareonadigitalexchangethat
accepts tone dialling, locate switch number 2 which
is the TONE/PULSE switch inside the switch
compartment of the unit. First try dialling out with
the switch in the TONE position. If this is
unsuccessful,switchbacktothePULSEposition.
2.3 Mixed Mode dialling (how to switch from
pulsetotoneinmid-call)
Even if your local exchange only allows pulse
dialling, there may still be occasions when you need
tone dialling. For instance, when you call into a
bank's computer system, you may be asked to enter
numbercodes.Youcanonlydothisifyourtelephone
2
Operation
sendsouttoneswhenyoupressthekeypad.
The TONE button helps you make change over from
pulsetotonediallinginthemiddleofacall.
What you do: Pulse-dial the telephone numbers you
require. When you are connected, press the "TONE"
button
What you do: Dial the rest of the sequence you
require.
What you hear: Each number you dial emits a tone.
When the handset is replaced, the unit goes back to
pulse dialling.
2.4 OtherNetworkServices
The NRX EVO 150 is fully compatible with many
telephone network services, which provides a number
of useful additional facilities, including three way
calling, call diversion, call waiting etc. It you are
connected to one of the digital exchanges, you can
access these services via the RECALL button on the
keypad. For further details, please contact your local
PTTSalesOffice.
2.5 MessageWaiting
The NRX EVO 150 has built in message waiting
indicators that are compatible with most types of
PABX with such a facility. By correct setting of
switches 4 and 5 in the switch compartment located
in the base of the phone, the telephone can be set to
detectanumberofmessagewaitingsignals.
Message Waiting Signal Switch 4 Switch 5
Polarity Normal OFF 1
Polarity Reversed OFF 2
90V or above DC orAC ON (Default) OFF (Default)
Thetelephoneissuppliedsettothedefaultsetting.
2.6 LastNumberRedial
If you dial a number and find it is engaged or there is
no reply, replace the handset. The number will be
retained in the memory until you dial a different
number. Toredialthelastnumberautomatically.
What you do: Lift the handset or press the 'NEW
CALL' key
Press the "REDIAL" button
