6
Auto-Dialer Operation Procedures
Self-test after Being Turned ON:
After self-test, the instrument is ready to work and the decimal point at the lower right corner on the 7 segment
display will turn ON and OFF (continuously blink). If configuration (phone numbers and voice message) already
exists, the AUTO-DIALER will alarm automatically upon receiving an alarm signal. To setup or change the
configuration, please follow the procedures below to save and check telephone numbers and passwords as well as
to record and play back recorded files:
1. Log into the Programming Mode:
First press P, then put in the Private Password (0-6 digits), then press ENTER
Note: The Default Password is 911
For instance: Log into the Programming Mode as follows:
P 911 ENTER
If the password you put in is correct, The LED will illuminate the lower half “□”, and then log into the Programming
Mode and display “S” ,
If the password you put in is incorrect, The LED will display “E” and return to the working mode. Repeat the
procedure to try again.
2. Program the telephone numbers to be dialed
A. While in the Programming Mode (the screen displays “S”):
Press E1+ the phone number + ENTER
For instance, if the telephone number is 93953399, the procedure is as follows:
Press E1+939533399+ENTER
After pressing ENTER to save the number, if “□”is displayed, it means the number was saved correctly. The
display will then return to Programming Mode (“S”);
However, If “E” is displayed, it indicates the number failed to be saved correctly; and the Dialer will return to the
Programming Mode (“S”). Repeat the procedure.
To change a programmed number, follow the same procedure. Entering a new set of numbers will overwrite the
first set of numbers.
If desired, to delete a telephone number and leave it blank, press E1 followed immediately by ENTER.
B. You can dial to an automated broadcast telephone exchange where you need to automatically dial to an
extension after the initial call is picked up. For example, supposed the extension number is 12, then program the
saved telephone numbers as follows:
E1+ initial phone number+ P+1+2+ENTER
Pressing Ponce causes the dialer to pause for two seconds before sending the additional numbers. If additional
time is needed, press Ptwice for four seconds.
To program numbers for E2, E3 and E4, follow the same steps above, substituting the corresponding E# for the
number being programmed.
