• Devices of protection class 1 must be connected to the protective conductor of
the electrical installation, which is at earth potential. Make sure that the protective
earth installation is carried out correctly at the connection point!
• Only use cables and equivalents recommended by Nubert
• When laying the mains cable, make sure that it cannot be damaged (e.g. due to
heating or mechanical stress)! Pay particular attention to the areas of the plugs and
distributors!
Danger!
Danger of an explosion!
• Unplug the power cord before doing any wiring on the system
especially cannot be swallowed!
Accesories!
• Only use the device in a dry place!
Danger!
more and keep it away from children.
• Do not bring the remote control and the battery into contact with water or other liquids!
• in areas where there is a risk of fire or explosion!
Overvoltages in the power supply (e.g. due to lightning) can damage or destroy the
device and power pack.
• Do not place any containers with liquids (eg flower vases) on the device
• For the connections, only use the cables or plug connections provided! Otherwise
damage or malfunctions may result.
• If you do not use the device for a long time or if the batteries are exhausted, remove
the batteries from the remote control to prevent discharge, acid leakage or explosion.
• All mains supply or antenna systems that are connected to the device must comply
with the applicable laws and regulations and be installed professionally by an
authorized installer.
• in the vicinity of easily combustible materials!
• Do not use the device during rapid changes in temperature!
Danger of electric shock!
• No objects or foreign bodies may get into the device.
Danger of internal chemical burns!
3
change!
• Keep new and used batteries away from children.
Improper handling can lead to property damage.
Installation in unsuitable locations can cause explosions.
• at extremely low or extremely high temperatures!
• If you suspect that batteries have been swallowed or have entered the body in any
other way or have been inserted into any part of the body, contact a doctor
immediately!
• Do not operate or store the remote control and battery in places with high humidity
or particularly high or low temperature!
• If you want to disconnect connections on the device, always pull on the
• An overvoltage protection element can offer a certain level of security against
excessively high voltages in the power grid.
• Leaking batteries must be replaced immediately.
• Use only the supplied power cord to connect the device.
The mains cable and its plug must not be modified under any circumstances.
• Should the device come into contact with liquids or should
Swallowing batteries can cause severe internal burns and death within a short period
of time.
The device carries mains voltage inside and voltages in excess of 35 V AC or DC in
areas. It has no special protection against the ingress of liquids or objects into the
system. There is therefore a risk of fatal electric shock.
• Make sure that all connections have been made correctly and that all plugs are firmly
seated in the sockets before you connect the device to the mains!
• If the battery compartment does not close securely, do not use the product
• Do not drop the remote control!
Do not use the device and the remote control
Danger of electric shock!
• Do not operate it outdoors or in damp rooms!
• in the vicinity of flammable gases or vapours!
or in the immediate vicinity!
This product comes with a remote control and a battery. The following must be
observed when handling remote controls and batteries:
• However, the best possible protection against damage can only be provided by
completely disconnecting your devices from the power supply and the antenna
systems. Therefore, in the event of a thunderstorm or the risk of lightning , pull the
mains cable out of the socket and any antenna plugs from your hi-fi system!
• If you find a leaking battery, do not touch the leaking material and dispose of the
batteries immediately! • Do not touch leaking batteries! • If
your skin, eyes or mouth come into contact
with the spilled material , immediately clean the affected area with water and contact
a doctor immediately!
plug, never on the cable!
The crossed-out wheeled bin symbol on batteries reminds you not to throw
them away with household waste. Observe the Disposal and battery return section at
the end of these operating instructions.
If the batteries are discharged, the range of the remote control decreases
significantly. In such a case, replace the batteries immediately. Always use high-quality
CR2025 lithium button cells as replacement batteries . When inserting the battery into
the battery compartment, pay attention to the correct polarity by paying attention to
the + and - signs in the battery compartment!
• If the device is not used for a long period of time or is left unattended, the power
supply should be disconnected. Pull the mains plug out of the socket!
General connection instructions
• Make sure that the mains voltage in your area corresponds to the requirements of
the device! The correct power supply can be found on the label on the back of the
device. It must not be connected to other power supplies.
If objects got inside, please unplug the power cord immediately and contact Nubert
• Take care that batteries do not enter your body in any way,
• Never touch the device with wet hands!
Danger!
• The device must be protected against liquids of all kinds, including dripping and
splashing water.
Leaking or exploding batteries can pose a risk to your health and cause property
damage.
Faulty mains supply systems or excessive mains voltage can cause electric shocks.
• in the vicinity of heavy dust!
• If the device is brought from a cold environment into a warm room, condensation
may form inside the device. Wait at least 6 hours before switching on the device
until it has reached room temperature and is dry!
• Make sure that all plugs are firmly seated in the sockets!
remote control and battery
Connection instructions
06/2021 · nuConnect ampX
Machine Translated by Google
