Nutrifaster ZuMEX MULTIFRUIT Manuale utente
■PREVENTATIVE MAINTENANCE
■CLEANING INSTRUCTIONS
■FILTER & GRATING DISC
■TROUBLESHOOTING GUIDE
Unit 7, 62-66 Newton Road, Wetherill Park, NSW, 2164
P: 02 9729 2011 │F: 02 9729 2012 │E: service @ nutrifaster.com.au
N U T R I
F A S T E R
C O M. AU
MULTIFRUIT
1
2
3
4
5
6
8
7
9
10
12
11
Ensure all components are accounted for.
■PREVENTATIVE MAINTENANCE
■CLEANING PROCEDURES / INSTRUCTIONS
How to dissemble for cleaning:
■FILTER AND GRATING DISC &consumables
Suggestion: for optimal yield/performance
Replace 6 to 12 months (depending on usage)
REPLACEMENT cost $297.00 +GST
Order code: Z-S3210420-02
Suggestion: for optimal yield/performance
Replace 48+ months or as needed
(ensure to clean it daily)
REPLACEMENT cost $350.00 +GST
Order code: Z-S3210020-01
Anti-drip tap: if lost or can’t be unblocked
Replace when necessary (ensure to clean it daily)
REPLACEMENT cost $35.00 +GST
Order code: Z-S3210050-01
Filter Driver & Nut: if lost or damaged
Replace when necessary (don’t fit it by force)
REPLACEMENT cost $82.00 +GST
Order code: Z-S3210040-00
Caution! For a correct cleaning process please follow the above
instructions. Always ensure the juicer is unplugged from electrical mains.
Zumex strongly recommends cleaning the
equipment at least once or twice a day,
(this would depend on usage) and necessary in order to maintain the
juicer at its optimal levels of hygiene, performance and condition.
1
2
3
4
5
6
7a
8
oWASH ALL COMPONENTS (DAILY) IN WARM SOAPY WATER
oDO NOT SRUB THE FILTER WITH HARSH OR ABRASIVE CLEANING AIDS
7b
■TROUBLE SHOOTING GUIDE
PROBLEM: juicer not working / turning on - LED is OFF
POSSIBLE CAUSE
CORRECTIVE ACTION
The equipment is unplugged
Connect equipment to mains power
No power reaches the plug
Check the socket or contact an electrician
Cover is not placed correctly
Ensure its sitting correctly in its recess
Handle not locking correctly
Ensure it's not obstructed and locks in
Fuse might be blown
Replace using spare fuse provided (see user manual)
internal damage
Please contact an authorized/approved technician
PROBLEM: juicer not working / turning on - LED is FLASHING
POSSIBLE CAUSE
CORRECTIVE ACTION
The waste bucket has separated from the
machine body
Place waste bucket into correct position at rear of unit
Anomaly inside the machine
Please contact an authorized/approved technician
PROBLEM: juicer is working, but LED is OFF
POSSIBLE CAUSE
CORRECTIVE ACTION
Anomaly inside the machine
Please contact an authorized/approved technician
PROBLEM: Equipment often gets blocked when juicing
POSSIBLE CAUSE
CORRECTIVE ACTION
Clogged Filter from excessive pulp
Review cleaning frequency and procedures
Clogged Filter from excessive pulp
Your Grating Disc might be blunt, consider replacing it
Not enough voltage is detected
Ensure the operating voltage is the same as stated on manual
PROBLEM: Juicer vibrates a lot when juicing
POSSIBLE CAUSE
CORRECTIVE ACTION
Filter is unbalanced from fruit/pulp build-up
disassemble/remove the filter and clean it
PROBLEM: Juice has too much pulp
POSSIBLE CAUSE
CORRECTIVE ACTION
The inside cover of the lid is full of waste
disassemble/remove the cover and clean it
PROBLEM: The Anti-Drip outlet/tap gets obstructed
POSSIBLE CAUSE
CORRECTIVE ACTION
The juice has pips or too much pulp
Remove the outlet/tap and clean it.
Use speed [1] for soft produce
Use speed [2] for hard produce
IMPORTANT : Always unplug the appliance from the power supply before carrying out any operations or functions to
unblock or remove any obstructions. If, after following this troubleshooting guide, the appliance still does not operate or
functions, please contact Nutrifaster Technical Support on 02 9729 2011 (option 2)
Indice
Altri manuali Nutrifaster Spremiagrumi
