Oce ColorWave 300 Manuale utente

Océ

ColorWave® 300

Jump to One

User manual

Safety information

in any form or by any means without written permission from Océ.

Océ makes no representation or warranties with respect to the contents hereof and specifi-

cally disclaims any implied warranties of merchantability or fitness for any particular purpose.

Further, Océ reserves the right to revise this publication and to make changes from time

to time in the content hereof without obligation to notify any person of such revision or

changes.

Edition: 2009-10

Contents

Chapter 1

Safety information..............................................................................................5

Instructions for safe use............................................................................6

Chapter 2

Regulation notices............................................................................................11

Regulation notices (country dependent)................................................12

Chapter 3

General information.........................................................................................17

Caution labels and notations...................................................................18

Chapter 4

Miscellaneous....................................................................................................19

Addresses of local Océ organisations ...................................................20

Contents

Chapter 1

Safety information

Instructions for safe use

Introduction

All the products have been tested in accordance with the strictest international safety

standards. Please read the following sections before you connect the machine to the

power supply. These sections contain important information with regard to the user

safety and the prevention of equipment problems. Make sure that you observe the safety

rules hereinafter. This helps to assure that you can work with the product safely. Make

sure that you observe all the precautions mentioned below.

Note:

Some parts of the contents of this section may not be applicable to your product.

Note:

Please refer to the corresponding Safety Data Sheets for specific safety information. You

can download the Safety Data Sheets from the support site of your product at

http://global.oce.com/support/.

Warning and Caution Symbols

Caution:

Ignoring this warning could cause serious injury or even death.

Attention:

Ignoring this warning could cause injury or damage to property.

Note:

Indicates additional important information.

The indicators above are used on the warning labels or in the manuals to categorize the

level of safety warnings.

Disassembly and Modification

Warning

Chapter 1 - Safety information6

Instructions for safe use

■Do not remove covers and panels that are fixed to the machine. Some machines have

a high-voltage component or a laser beam source inside that could cause an electric

shock or blindness

■Do not modify this machine, since this could cause fire, electric shock, or breakdown.

If the machine contains a laser, the laser beam source could cause blindness.

Caution

■Do not carry out maintenance activities on components and maintenance materials

other than the components and materials that are mentioned in the user manual.

■Do not place any liquids on the machine.

■Do not open any door while the machine starts up or runs, unless the operator panel

displays a message asking you to open one or more doors.

■Only use maintenance materials or other materials for their intended purpose.

■To avoid any risk, only properly qualified and trained service technicians are allowed

to modify the machine.

■Do not bridge any mechanical or electrical circuit breakers.

Note

■Keep maintenance materials away from children.

Power cord

Warning

■Do not scratch, abrade, heat, twist, bend, place a heavy object on or cause any other

damage to the power cord. The use of a damaged power cord (exposed core wire,

broken wire, for example) could result in a fire or breakdown. If you find any of these

conditions, immediately turn OFF the power switch and unplug the power cord from

the power outlet. Then call your authorized service representative.

■Only use the mains connector cable that was supplied with the machine.

Power source

Warning

■Do not connect the machine to a mains voltage that differs from the value as stated

on the power marking label.

Note

■If connection to a different mains voltage is required, contact your authorized service

representative.

Power plug

Warning

Chapter 1 - Safety information 7

Instructions for safe use

■For machines that are connected via a wall socket: Place the machine close to a wall

socket that is easily accessible. The power plug is intended to serve as a disconnect

device.

Grounding

Warning

■Connect the power cord to an electrical outlet (wall socket) that is equipped with a

grounding terminal.

Installation

Warning

■Make sure that the machine is placed on a level, horizontal surface of sufficient strength.

Do not place this machine on an unstable or tilted bench.

■Do not place this machine in a location that is subject to lots of vibrations and shocks.

■Do not use flammable sprays, liquids or gases near this product, because this could

cause a fire.

Ventilation

Caution

■The machine can produce odors of exhaust air when you:

- use this machine in a poorly ventilated room for a long time

- produce large amounts of copies or print

Therefore, make sure that you ventilate this room well. Do not block the ventilation

openings of the machine.

■Do not place the machine in rooms which are too small and insufficiently ventilated.

See the Product Safety Data Sheet of the machine for the ventilation requirements.

Actions in response to troubles

Warning

■When a piece of metal, water or any other similar foreign matter gets inside the ma-

chine, immediately turn OFF the power switch and unplug the power cord from the

power outlet. Then call your authorized service representative.

■Immediately stop using the machine if the machine becomes excessively hot, emits

smoke, or produces unusual odors or noises. Immediately turn OFF the power switch

and unplug the power cord from the power outlet. Then call your authorized service

representative.

Caution

■Stop using the machine if the machine was dropped or a cover was damaged. Imme-

diately turn OFF the power switch and unplug the power cord from the power outlet.

Then call your authorized service representative.

Chapter 1 - Safety information8

Instructions for safe use

■LCD display. Do not rub, press or touch the display surface with hard material, because

the polarizer at the surface can be easily scratched. The LCD module consists of glass.

Therefore, the LCD module can damage when you drop, pinch strongly or punch

the module. When glass breaks, be careful that you do not get injured by glass pieces.

Call Customer Service.

Consumables, supplies and maintenance materials

Warning

■Do not throw ink containing or contaminated parts into an open flame.

Caution

■Do not leave ink containing or contaminated parts in a place within reach of children.

■Always use the materials which the manufacturer recommended and which are devel-

oped for this machine. Materials not approved by the manufacturer may result in

faults in your machine.

Moving the Machine

Caution

■Make sure that you disconnect the power cord and other cables before you move the

machine.

■Make sure that you check the documentation for the space requirements before you

move the machine.

Holidays

Caution

■Unplug the machine if you will be using it for a long period of time.

Chapter 1 - Safety information 9

Instructions for safe use

Chapter 1 - Safety information10

Instructions for safe use

Altri manuali per ColorWave 300

Indice

Manuali Stampante tutto in uno popolari di altre marche

Triumph Adler

Triumph Adler DC 2016 Manuale

Epson

Epson WorkForce WF-2510 Guida utente

Epson

Epson Stylus Scan 2000 Manuale di installazione e funzionamento

Epson

Epson PictureMate Snap PM 240 Manuale di istruzioni

Konica Minolta

Konica Minolta bizhub C35 Manuale utente

Brother

Brother MFC-J430w Manuale utente

Konica Minolta

Konica Minolta BIZHUB 558 Manuale utente

Lexmark

Lexmark MX710 Series Manuale

Brother

Brother MFC-9760 Manuale utente

Lexmark

Lexmark XC8155 Manuale utente

Lexmark

Lexmark X642E Manuale utente

Sharp

Sharp MX-2310U Guida

Aficio

Aficio 200 Manuale utente

Canon

Canon ImageCLASS 2300 Manuale

Ricoh

Ricoh Pro C900 Manuale utente

Lexmark

Lexmark X925 Manuale utente

Brother

Brother Business Smart MFC-J4510dw Manuale utente

Epson

Epson Stylus CX8400 Series Manuale utente