Ocea Soft OCEABridge Manuale utente
USER GUIDE
OCEABridge
Installation and operation
Introduction
OCEABridge User Guide Page 2
User guide
Notices and safety
Disclaimer and limitation of liability
OCEASOFT assumes no responsibility for any loss or claims by third parties which may arise
through the use of this product. In particular, users must not use the product in any manner
not specifically indicated by OCEASOFT. OCEASOFT shall not be held liable for improper use
of this product. This document is non-contractual and subject to change without notice.
Safety instructions
IMPORTANT: Do not use this product for protection or as part of an automated emergency
system or as for any other application that involves protecting people and/or property.
Customers and users of OCEASOFT products are responsible for making sure that the product
is fit for the intended usage. Do not open the product casing and do not disassemble or
modify internal components in any manner. OCEASOFT products do not contain any internal
components that require user intervention or repair. If the device shows signs of improper
operation, disconnect it immediately from its power source or remove the battery and
contact OCEASOFT technical services.
Introduction
OCEABridge User Guide Page 3
User guide
Standards and approvals
Bluetooth®:
•EC
•FCC: QOQBLED112
•IC: 5123A-BGTBLED112
•KCC (Korea): KCC-CRM-BGT-BLED112
•MIC (Japan): 003WWA111471
WiFi:
•EC
•FCC: ZHZHEe
Cellular data:
•ANATEL
•AT&T, EC, FCC, IC, JATE, NBTC, PTCRB, RCM, Rogers, TELEC
EC:
•EMC: EN 301 489-17 V.3.1.1 in compliance with EN 301 489-1 V2.1.1.
•RF radiation: EN 300 328 V2.1.1
Safety:
•EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011 + A2:2013
Caution: Any changes or modifications not expressly approved by OCEASOFT could void the
user’s authority to operate the equipment.
Introduction
OCEABridge User Guide Page 4
User guide
Environmental protection
Please respect local regulations concerning disposal of packaging, unused
wireless devices and their accessories, and promote their recycling.
RoHS compliance
The wireless device is in compliance with the restriction of the use of
certain hazardous substances in el
ectrical and electronic equipment
Directive 2002/95/EC (RoHS Directive). Do not dispose of this product
with household trash. OCEASOFT recycles this product under certain
conditions. Please contact us for more information.
Europe
North America
OCEASOFT SA
720 rue Louis Lépine
34000 Montpellier
Tel: +33 (0)4 99 13 67 30
Fax: +33 (0)4 67 42 84 13
France
OCEASOFT, Inc.
250 Phillips Boulevard
Ewing, NJ 08618
Tel: +1-609-589-1668
Fax: +1-609-589-1669
USA
© 2018 OCEASOFT S.A. All rights reserved. OCEASOFT, the OCEASOFT logo, OCEABridge, OCEASOFT Emerald,
OCEASOFT Atlas, and OCEAView are the exclusive property of OCEASOFT. All other brands mentioned are the
property of their respective owners. This is a non-contractual document. Product photos
and features may vary.
November 2018 Ref: ING-INS-179-EN Rev. 01
Introduction
OCEABridge User Guide Page 5
User guide
Contents
1Introduction.................................................................................................... 7
1.1 OCEABridge™ solution overview................................................................................. 7
Main features......................................................................................................... 7
Architecture ........................................................................................................... 8
Package contents ................................................................................................... 9
1.2 Gateway presentation............................................................................................... 10
Overhead/front view ........................................................................................... 10
Front view ............................................................................................................ 11
Side view (right-hand side) .................................................................................. 12
Back/bottom ........................................................................................................ 12
2Starting the gateway ..................................................................................... 13
2.1 Prerequisites ............................................................................................................. 13
2.2 Plugging in OCEABridge............................................................................................. 14
2.3 Connecting to the configuration application ............................................................ 15
2.4 Gateway properties................................................................................................... 16
2.5 Gateway settings....................................................................................................... 17
Cloud server ......................................................................................................... 17
Operating mode................................................................................................... 18
3Wireless network management ..................................................................... 20
3.1 Connecting to a WiFi network................................................................................... 20
3.2 Adding a wireless network........................................................................................ 22
3.3 Configuring WiFi connection..................................................................................... 22
3.4 Enabling an existing wireless network ...................................................................... 23
3.5 Configuring a 3G/4G connection............................................................................... 24
3.6 Configuring the network LED .................................................................................... 27
4Managing network interfaces ........................................................................ 28
4.1 WAN and WLAN interface......................................................................................... 29
General Setup ...................................................................................................... 29
Advanced Settings................................................................................................ 30
4.2 Cellular data interface............................................................................................... 32
Introduction
OCEABridge User Guide Page 6
User guide
5OCEABridge maintenance.............................................................................. 34
5.1 Changing the password............................................................................................. 34
5.2 Updating OCEABridge data collection firmware....................................................... 34
5.3 Backing up and updating system firmware............................................................... 35
Archiving your data.............................................................................................. 35
Restoring an archived backup.............................................................................. 36
Complete firmware upgrade................................................................................ 36
5.4 Restarting OCEABridge.............................................................................................. 37
6Diagnostics and statistics............................................................................... 38
6.1 Platform information ................................................................................................ 38
6.2 Module statistics ....................................................................................................... 39
6.3 Real-time network traffic .......................................................................................... 41
6.4 Start log ..................................................................................................................... 43
7Annexe 1 – Technical specifications ............................................................... 44
Introduction
OCEABridge User Guide Page 7
User guide
1Introduction
Congratulations and thank you for choosing the OCEABridge™ wireless gateway solution.
This guide provides a general description of the OCEABridge solution as well as practical
instructions for installation and easy setup of your device.
OCEABridge is designed to interact with the following OCEASOFT products and applications:
•Emerald™ modules: Bluetooth-enabled data loggers for monitoring temperature
during shipping.
•Atlas™ modules: limited duration Bluetooth™- enabled data logger for monitoring
the cold chain on-the-go.
•OCEAView: Web application dedicated to OCEASOFT’s Bluetooth™-enabled Atlas™,
Emerald™, and Phoenix™ solutions.
For more information about these products (sold separately), please read the specific
instructions provided with each one.
1.1 OCEABridge™ solution overview
Main features
•Ethernet wired or WiFi wireless connectivity
•Optional 3G/4G cellular data connectivity
•Automatic detection of compatible OCEASOFT data loggers within Bluetooth®
coverage zone
•Data collected and sent automatically to OCEACloud Cloud platform
•Integrated web interface for easy OCEABridge gateway configuration
•Unlimited storage for sensor readings on OCEACloud
Introduction
OCEABridge User Guide Page 8
User guide
Architecture
The OCEABridge™ Bluetooth® gateway automatically detects all compatible OCEASOFT data
logger within wireless range and collects the data stored in their memory.
The gateway is continually connected via the Internet to the OCEACloud platform, where
data is transferred and available to users with the OCEAView™ web application.
The diagram below shows the how the OCEABridge™ gateway functions:
Figure 1 – Data flow from wireless modules to OCEACloud via OCEABridge™
Step
Description
•Simply install your OCEABridge gateway in a loading or unloading zone, or
product handling area.
•Use the embedded web application to set up your OCEABridge gateway.
Data is collected automatically and sent to the server.
•Whenever OCESOFT Bluetooth-enabled data loggers pass withing range,
OCEABridge retrieves their stored data wirelessly.
•Data on the OCEACloud platform is accessible using the OCEAView
application.
1
2
3
4
Introduction
OCEABridge User Guide Page 9
User guide
Package contents
•OCEASOFT OCEABridge™ gateway
•AC power adapter
•Bluetooth dongle
To be ordered separately (depending on your gateway model):
•OCEASOFT wireless data loggers
•3G/4G cellular data module
•Micro SIM card for cellular data
Introduction
OCEABridge User Guide Page 10
User guide
1.2 Gateway presentation
Overhead/front view
Figure 2 – OCEABridge gateway overhead view
1.2.1.1 Description of status LEDs
The OCEABridge gateway has 6 LEDs with colors and blinking patterns that vary with the
device’s status and network traffic:
LED Description
WLAN. Indicator for WiFi or 3G/4G wireless activity (see section 0
Configuring the network LED, page 27).
WAN. RJ-45 port for sending information.
LAN. RJ-45 port for OCEABridge configuration.
System. This LED blinks while OCEABridge is booting (about 15 seconds) and
remains on during normal operation.
Status LED
3G/4G antenna (for
use with optional
d)
Indice
