5
Unpack the curtain rail and check that all parts have been delivered: 1 curtain rail, 1
remote control, 2 or 3 wall brackets, 2 or 3 stop screws for brackets, 2 or 3 screws, and
2 or 3 rawlplugs and power supply.
1. Measure and mark on the wall where the wall brackets are to be placed. On concrete
or plaster walls, drill out holes for rawlplugs. Use rawlplugs suited for the wall on
which the wall brackets are to be mounted. The delivered rawlplugs are for concrete
walls.
2. Insert the screw in the pipe of the bracket and fasten the bracket into the wall with a
screw driver suited for the delivered screws.
3. The curtain rail is delivered including the number of gliders that according to
standard procedure are used for the length of the curtain rail in question. I.e. one
glider per 5 cm. To remove or insert gliders, do as follows. Loosen the end glider
and simple remove or add gliders, and then put the end glider back into its place.
4. Carefully hang the curtain rail on to the wall brackets. Screw the small stop screws
into the holes on top of the brackets to ensure proper fastening of the curtain rail.
5Now, you can hang the curtains on the curtain hooks of the rail. The curtain rail is
intendedforcurtainswithheadingtape andconventionalcurtain hooksfor
standardgliders.
6. Connect the power supply into the socket at the rear of the curtain rail. Connect the
power supply into wall socket (220V).
CAUTION:DONOTPULLTHECURTAINMANUALLY,THISMIGHT
DAMAGETHEMECHANICSINSIDETHERAIL.
7. The curtain rail can also be ceiling-mounted - in this case angled brackets are
delivered (figure 4) Screw the screw from beneath and up into the ceiling and hang
the curtain rail on to the brackets the same way as with the wall brackets.
MOUNTING
16
TEMPERATURE CONTROL
Model de Luxe has built-in temperature control, which can draw the curtains forth, if it
gets too hot in a room. Go to menu item:
By pressing the middle button, you get to the menu item:
Press enter again to choose, whether temperature control should be On or Off:
Nextmenu itemis
:
In this menu item, you set at which temperature the curtains should be drawn back:
Set the temperature with the upper or lower button and press enter (middle button),
when the desired temperature is shown on the display. Next menu item is:
In this menu item, you set at which temperature the curtains should be drawn forth:
Set the temperature with the upper or lower button and press enter (middle button),
when the desired temperature is shown on the display. In this case, the curtains will be
drawn forth, when the temperature is 28°C in the room and back again, when the
temperature is 21°C in the room. Last menu item is:
Press the middle button, and the display will show the actual temperature in the room.
Forexample:
Temp.
Activate
Temp.Off
Temp. On
Temp.back
°Cback: 21
Temp.forth
°Cforth:28
Showtemp.
23,0°C
