OHAUS Scout Pro Balance Manuale utente
Quick Start Guide Scout
Pro Balance
Ohaus Corporation www.ohaus.com iScout
Pro Balance Quick Start Guide
PREPARATION FOR USE
Release Shipping Lock on top of the balance
Turn the pointer 90°counter-clockwise.
Install the Platform
Rectangular platform: Place diagonally on sub-
platform and rotate counter-clockwise until it locks.
Round platform: Set straight down on subplatform.
Draft Shield models: Position draft shield
on top and rotate it until it faces forward.
Connect Power
Ensure voltage identification label matches
local line voltage. If not, do not connect the unit.
Contact Ohaus or your dealer.
Battery Installation
Install the Four “AA” batteries with polarity
as shown in the battery compartment.
Balances with leveling
feet and bubble must
be leveled before
using. (Bubble is at
rear, next to AC
Adapter Input Jack.)
SELECTING THE LOCATION:
Place on a firm, steady surface with sufficient space.
Avoid excessive air current, vibrations, heat sources, or rapid temperature changes.
SAFETY PRECAUTIONS
•Before plugging in the balance, verify that local power supply matches voltage printed
on power adapter. (Use only the adapter provided with the balance.)
•Disconnect the balance from the power supply when cleaning.
•Do not operate this product in hazardous or unstable environments.
•Do not drop loads on the pan.
•Use only approved accessories and peripherals, as available.
•Operate the product only under ambient conditions specified in the Instruction Manual.
•Service should be performed by authorized personnel only.
Pointer
Locked
position
Unlocked
position
Subplatform
Adapter jack
Scout
Pro Balance Quick Start Guide
Scout
Pro Balance Quick Start Guide ii Ohaus Corporation www.ohaus.com
CONTROLS
Button Functions
ON/ZERO
Off
Short Press (when off)
Short Press:(when on)
Long Press
Extended Long Press
Short press in Menu mode
Turns scale on.
If balance is on, sets display to zero.
Turns scale off.
During power up, enters Menu mode.
Accept setting on display.
PRINT
Menu
Short Press
Press and Hold
Short press in Menu mode
Sends print command to COM interface port.
If Display Hold or Totalize mode is active,
short press enters that mode.
Scroll through Units. Release on desired unit.
“No” (toggles through available settings)
Locking the Menu
The Lock Switch is used to lock out the
menu mode, preventing unauthorized
changes.
To lock the menus, position the Lock Switch
next to the tab on the bottom of the balance
as shown.
Stability
indicator
Battery charge
indicator
Symbols for weighing
modes:
G– Specific Gravity
N– Newtons
% – Percent
PC – Pieces
kg – Kilograms, g– grams
dwt – (not used)
lb:oz – (not used)
ct – (not used)
t– Totalize mode (or taels*)
*Unit varies by model
Unlocked
Locked
Quick Start Guide
Scout
Pro
Balance
Ohaus Corporation www.ohaus.com iii Scout
Pro Balance Quick Start Guide
OPERATION
Weighing
Start with the balance on.
1
(Rezero the display)
(Place sample on platform)
(Example 50g)
Taring a Container’s Weight
Taring zeros the container weight. With balance on, place an empty container on the platform.
(Container weight)
1
(Container weight tared)
(Place material in container)
(Material and container removed)
(50g sample)
To remove tare, press ON/ZERO Off again.
ADDITIONAL OPERATIONS
Use the Units Menu to activate Parts Counting or Percent Weighing.
(See back page.)
To enable Display Hold, Totalize and Specific Gravity, use the Setup/Mode submenu.
Parts Counting has two modes:
(See Instruction Manual for more details.)
Normal: balance determines quantity based on average weight of parts in original
reference quantity.
Enhanced: additional parts can be added to the platform ( ≤the original number).
The additional reference quantity produces a more accurate average part weight.
Percent Weighing: place a reference weight on the balance, then view other loads as a
percentage of the reference. The reference weight equals100%.
Display-Hold mode captures and stores the highest stable value. When displayed, the stability
indicator blinks. Note: Units cannot be changed when in Display-Hold mode.
Totalize allows storage of a series of weight measurements. Totalize mode has been initiated
when “t” and the current unit are displayed together. When totalized weight is shown, the “t”
indicator blinks. Note: Units cannot be changed when in Totalize mode.
The Specific Gravity mode allows calculating the specific gravity of a sample.
(SPEC.GR mode must be turned ON before removing platform and installing hook.)
Scout
Pro Balance Quick Start Guide
Scout
Pro Balance Quick Start Guide iv Ohaus Corporation www.ohaus.com
MENU NAVIGATION
There are four main menus in the balance: .C.A.L., .S.E.T.U.P., .U.N.I.T.S. and .E.N.D.
(Start with the balance off and the Lock Switch off: see page ii)
.
The sequence is shown below.
5
(Release button)
1
(Acquiring zero value)
1
1
1
(Weigh Mode)
MENU STRUCTURE
Accepting/Bypassing Menu Items
Start with menu item displayed.
1
= YES Accept
1
= NO
1
(Short presses
advance through
menu)
Cal
CalCal
Cal
−Yes/No
S
SS
Setup
etupetup
etup
−Auto-Off
-On/Off
−Lin Cal
-Yes/No
−mMode
-Hold
-Totalize
-Specific Gravity
Off
−End
-Yes/No
Units
Units Units
Units
−
-On/Off
−k
-On/Off
−oz
-On/Off
−lb
-On/Off
−PC
-Count
-Cnt.Enh
Off
−
%
-On/Off
−End
-Yes/No
End
EndEnd
End
−Yes/No
*80253128*
P/N 80252993
Altri manuali per Scout Pro Balance
2
Indice
Altri manuali OHAUS Scala
OHAUS
OHAUS Scout Pro Series Manuale utente
OHAUS
OHAUS PX Series Manuale utente
OHAUS
OHAUS Ranger RP Compact Scales Manuale utente
OHAUS
OHAUS Harvard Junior Manuale utente
OHAUS
OHAUS DISCOVERY BALANCE Manuale utente
OHAUS
OHAUS Navigator NVT1601M Manuale utente
OHAUS
OHAUS ES series Manuale utente
OHAUS
OHAUS Harvard Trip 1450-SD Manuale utente
OHAUS
OHAUS 5000 Manuale utente
OHAUS
OHAUS Pioneer PA64 Manuale utente
OHAUS
OHAUS Scout SPX Manuale utente
OHAUS
OHAUS Defender 3000 Manuale utente
OHAUS
OHAUS AV412 Manuale utente
OHAUS
OHAUS Navigator NV212 Manuale utente
OHAUS
OHAUS BC Series Manuale utente
OHAUS
OHAUS YA102 Gold Manuale utente
OHAUS
OHAUS Adventurer Pro AV***M Series Manuale utente
OHAUS
OHAUS Valor 1500 Series Manuale utente
OHAUS
OHAUS Compass CX Series Manuale utente
OHAUS
OHAUS BW1.5US Manuale utente
