Okina 56SM-AV Manuale utente
www.okinausa.com
1
Operation Manual
Features:
A, This Model, 56SM-AV is a controlled by O.S.D (On Screen Display) micro-computer to
adjust Contrast, Brightness, Color, Tint, Volume and O.S.D Display position. Also with
EEPROM that could save the original setting while power turn off.
B, 56SM-AV sets up with power switch that could reverse right or left up or down car rear-
audio switch, NTSC/PALAuto switch, support AV1/AV2 double input, for variety use.
5.6” TFT LCD Service Monitor kit Included:
One 5.6” TFT LCD Monitor
One Power Adaptor / Transformer Output: 13V DC 800mA~ 1A with LED Light.
One Leather Case (9.5 x 6 x 2.6)
Two Belts for the Case
Rechargeable Battery (10 Batteries Built in one pack)
Two BNC Male to RCA Male Connecter for Video
One Power Code for Monitor & Rechargeable Battery Pack
Power Adaptor Rechargeable Battery 12V/1800m
Note: For longer Battery Life. Please Do Not Change Your Battery, More than two hours each time.
When battery full the LED light will be turn off. Note:
The charger adaptor is for purpose of charging, it cannot be used as a power source, and the
Monitor will not work without Rechargeable battery.
5.6
”
TFT LCD Service M
onitor
56
SM
-
AV
Charge
www.okinausa.com
2
DC IN Rechargeable Battery 12V DC/1800mA
Operation
a) Connect Audio/Video cable into either AV1or AC2 properly (see Figure A & B)
b) Plug in DC 12V into DC jack
c) Turn Main Power “On” & Press Power “On”
d) Select AV1 or AV2 by press
e) Press” Mode” to select Volume ÆBrightness ÆContrast ÆColor ÆTiny (NTSC only) Æ
Mute ÆMirror. Press or to adjust from 0 to 100(Mirror ON/OFF)
f) To reset all setting: Switch off the LCD Monitor ( Main Power must” OFF”), Press” Mode”
And at the same time and Power” On” by the Main Power switch ( on the side) then
press “Mode” to access Factory, without doing any adjustment, Power OFF and ON again by
press Main Power switch. The monitor is now reset to original factory setting.
g) Auto Power Off: The monitor will automatically turn off when video lose for more than 3
minutes, please push “Power” again to turn on the monitor.
h) The monitor is on Stand by Mode when Power is off, please shut the Main Power Off or
disconnect the power cable when intend to stop using this equipment for period of the time.
Drawing of WringApplication
AV2
AV1
DC IN Rechargeable Battery 12V DC/1800mA
AV1
AV2
www.okinausa.com
3
Specification
Model 56SM-AV
Display 5.6" Color TFT LCD
Number of dots 960(W) x 234(H)
Display Area 113.28(W) x 84.708(H)
Dot Pitch 0.118(W) x 0.362(H)
System NTSC/PAL(auto-switch)
Back Light CCFL
Viewing angle Left/Right:+45deg.(H)
Top/Bottom:+10/30deg(V)
Response Time Tr: 15 ms max. Tf: 20ms max
Input Signal 1.0Vp-p=composite at 75
Rechargeable Battery 12V DC / 1800mA
Power Source 12v DC 800mA ~ 1A
Operating Temperature 0°C ~ 60°C
Storage Humidity -25°C ~ 80°C
Power Consumption 7.0W
Dimension (mm) 152(W) x 105.6(H) x 38.6(D)
Weight 468+10g max.
Note: For longer Battery Life. Please Do Not Change Your Battery, More than two hours each time.
When battery full the LED light will be turn off. Note:
The charger adaptor is for purpose of charging, it cannot be used as a power source, and the
Monitor will not work without Rechargeable battery.
5.6
”
TFT LCD Service Monitor
Indice
Altri manuali Okina Monitor
