Oliso PRO VS95A Manuale utente
DTP-1106-004718_CTP01-2015-06-16_OLISOPRO_SVS_MANUAL_REVA_R2_SIZE:209.2X147.6MM_COLOR:K
VS95A, VS97A
SAVE THESE INSTRUCTIONS
MANUAL: www.oliso.com/manuals/smartvacuumsealer
USER MANUAL
reinvented for you™
SMART VACUUM SEALER
OLISO® PRO™ DUAL SEAL
Contact Oliso® Customer Service
Call: 1.800.899.5157
For more information visit
Office Hours: Mon-Fri 8:30am-4:30pm PST
E-mail: customerservic[email protected]om
Thank you for purchasing the Oliso® PRO™
Smart Vacuum Sealer. You are just a few
steps away from a whole new way of
storing your food.
Important Safety Instructions ..............................
Introducing the Oliso® PRO™ Smart Vacuum
Sealer ..........................................................................
Simple Steps to Vacuum Sealing .........................
Vacuum Sealing on the MOIST Setting ..............
Vacuum Sealing with the Flexi Tube ...................
Control Panel ............................................................
How to Reuse a Vac-Snap® Bag ..........................
Using the 12Volt DC Cord ......................................
Care and Maintenance ............................................
Quick Shopping Guide ...........................................
Troubleshooting .......................................................
Quick Tips ..................................................................
Warranty ....................................................................
Contents Thank You!
www.Oliso.com
QUESTIONS?
2
3
4
5
6
7
8
9
10
11
12
13
14
Read all instructions before using this product.
When using your Smart Vacuum Sealer, the following basic safety precautions should always be observed:
Use the Oliso® PRO™ Smart Vacuum Sealer only for its intended purpose.
To protect against the risk of electric shock, do not immerse the Oliso® PRO™ Smart Vacuum Sealer, plug or
power cord in water or other liquids.
Never tug cord to disconnect from the outlet. Grasp plug and pull to disconnect. Do not unplug the Oliso®
PRO™ Smart Vacuum Sealer when in use. Only unplug the unit when the READY light is illuminated.
To reduce the risk of injury, unplug the Oliso® PRO™ Smart Vacuum Sealer before removing the drip tray to
clean the drip tray and bag sealing area.
Clean the Oliso® PRO™ Smart Vacuum Sealer drip tray and bag sealing area after handing raw meats,
seafood and poultry to prevent bacterial contamination. Always empty and clean the drip tray between
uses. Do not allow the drip tray to overflow.
See page 10 for instructions on cleaning the drip tray and bag sealing area.
The Oliso® PRO™ Smart Vacuum Sealer contains a very sharp, concealed blade. Please take caution when
cleaning the bag sealing area.
The Oliso® PRO™ Smart Vacuum Sealer’s heat coil located in the bag sealing area stays warm for a few
seconds after use. Please take caution when removing the drip tray immediately after a vacuum cycle.
Keep Vac-Snap® bags away from infants and children.
Do not allow children to use the Oliso® PRO™ Smart Vacuum Sealer. Close supervision is necessary for any
appliance being used near children.
To reduce risk of electric shock, the Oliso® PRO™ Smart Vacuum Sealer has polarized plugs (one blade is
larger than the other). This is intended to fit in a polarized outlet only one way. If the plug does not fully fit
in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper
outlet. Do not alter the plug in any way.
The Oliso® PRO™ VS97A Smart Vacuum Sealer comes with a 12 Volt DC cord. Use only the DC cord supplied
with the unit. Make sure your vehicle has a 10 amp rated fuse or higher before using the 12 DC cord option.
While running off of the 12 Volt DC cord, the vehicle should be turned on, with lights, air conditioning and
radio turned off.
Always unplug your Oliso® PRO™ Smart Vacuum Sealer when not in use.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
Introducing the Oliso® PRO™ Smart Vacuum Sealer
This port should only be
used with accessories such
as canisters, bottleguards or
Mason jar attachments. If
you inadvertently plug in the
Flexi Tube and attempt to
vacuum seal a Vac-Snap®
bag, the FLEXI TUBE and
DONE lights will flash. You
must remove the Flexi Tube
before you can vacuum seal
a Vac-Snap® bag.
This area contains the cutting blade and
heat seal. We recommend wiping this
area with warm water and antibacterial
soap every time you clean the drip tray.
Note: There is a sharp, concealed
cutting blade. Please use caution
when cleaning this area.
Your Oliso® PRO™ Smart Vacuum Sealer has a drip tray that catches liquids pulled and vacuumed out of the bag as you are
vacuum sealing. This tray allows you to vacuum seal moist food such as beef, lamb and some types of fish. The tray and gasket
insert can be hand washed with warm, soapy water. Always empty and clean the tray between uses. Do not allow the drip tray
to overflow. Please refer to Page 10 of this manual for cleaning instructions.
Flexi Tube Valve Port
Liquid Drip Tray
DUAL SEAL Area
DUAL SEAL Area
Flexi Tube
Valve Port
Indicator
Lights
FLEXI TUBE
Button
MOIST FOOD
Button
DRY FOOD
Button STOP VACUUM
Button
CAUTION: Do not pull on the drip tray while the Oliso® PRO™ Smart Vacuum Sealer is operating.
Doing so will cause damage to the drip tray.
Simple Steps to Vacuum Sealing
INCOMPLETE SEAL
COMPLETE SEAL
AIR
Vac-Snap® bags work with Oliso® PRO™ Smart Vacuum Sealer products. They are specifically designed for vacuum sealing.
Zipper storage or freezer bags are not durable enough for this process.
Press out excess air before closing
bag. Shift food away from the edge
you wish to seal.
Zip shut using your Zip Disc®. You can
only get a great vacuum if all the air is
out of the bag, so the zipper must be
perfectly sealed.
Select MOIST or DRY setting. Note:
Oliso® Smart Vacuum Sealer defaults
to the DRY setting for quick vacuum
sealing.
Lay the bag flat, placing the
indicator circle directly over the
arrow on the drip tray.
Slide bag forward until you reach the
“BAG EDGE” line on the drip tray.
When the Oliso® PRO™ Smart Vacuum
Sealer stops, you will hear two beeps
and see the DONE light illuminate.
Remove bag and check seal.
AIR OUT
Below are tips and tricks to use when sealing items on the MOIST setting. Following directions will ensure an airtight seal and
minimize air bubbles inside the bag.
Vacuum Sealing on the MOIST Setting*
Seal area should be clean and
dry, with no liquids coating the
area meant for sealing.
Make sure to hold Vac-Snap®
bag in place until vacuum motor
starts.
For Sous Vide users especially:
To prevent air pockets, it is
highly recommended that users
hang the bag over counter edge
while vacuum sealing.
Check to make sure that heat
seal coil is clean. Residue on the
heating coil sometimes prevents
a complete seal.
Package moist items on a flat surface to prevent vacuum pump damage and poor sealing.
If vacuum sealing moist items, it is best to empty drip tray afterwards to prevent overflow.
*NOTE: This feature applies to specific Oliso® PRO™ Smart Vacuum Sealer models.
Useful Tips
Vacuum Sealing with the Flexi Tube
This hose lets you vacuum seal a variety of Freshkeeper® accessories. Instructions for using a bottleguard are illustrated below.
See the instruction booklet included with your accessory for specific details on that attachment.
After the FLEXI TUBE light
illuminates, press the FLEXI TUBE
button to start the vacuum.
Insert Freshkeeper® bottleguard into
your bottle of wine or cooking oil.
Connect one end of the Flexi Tube to
the accessory valve port on the
bottleguard.
Connect other end to the FLEXI
TUBE valve port on the Oliso® PRO™
Smart Vacuum Sealer. Press firmly
while twisting slightly.
When the Oliso® PRO™ Smart
Vacuum Sealer stops you will hear
two beeps and see the DONE light
illuminate. Twist to disconnect hose.
NOTE: Keep the Flexi Tube
connected to the Oliso® PRO™
Smart Vacuum Sealer if you want
to continue using accessories.
You must disconnect the Flexi
Tube from the vacuum sealer
before using a Vac-Snap® bag.
Control Panel
Flexi Tube Button Flexi Tube Valve Port
Press this button to start
the vacuum to the
attached accessory.
NOTE: The Flexi Tube must
be properly inserted in the
flexi tube port for this
button to be activated.
This button provides a
longer seal time and is
suitable for vacuuming
meat and fish.
This button provides a
shorter seal time and is
suitable for dry goods.
Press this button to stop
the vacuum immediately.
MOIST
Select MOIST or DRY
before inserting a
Vac-Snap® bag.
FOOD TYPE READY
WAIT
DONE
STATUS
(Indicator Lights)
DRY
Caution: Wait until the DONE light illuminates before removing the bag.
To connect the flexi tube,
press firmly while twisting
slightly.
Turns green when Oliso®
PRO™ Smart Vacuum Sealer
is ready to use or is able to
be unplugged.
Turns amber when Oliso®
PRO™ Smart Vacuum Sealer
is operating. DO NOT unplug
the unit when light is
illuminated.
Turns red immediately after
Oliso® PRO™ Smart Vacuum
Sealer finishes a vacuum
cycle. Two short audible
beeps also let you know the
cycle is finished.
How to Reuse a Vac-Snap® Bag
THE BASICS
USE AN ALIGNMENT
CIRCLE
USE A NEW ALIGNMENT
CIRCLE
LINE UP
Reusing a Vac-Snap® bag is one of the
great features of the Oliso® PRO™ Smart
Vacuum Sealer. Thoroughly wash the
inside of the bag between uses. Let the
bag air dry upside down. When the bag
is dry, you can reuse it. You can also
wash the bag in the top rack of your
dishwasher by opening the zipper and
placing it upside down on a cup spindle.
NOTE: when dish washing Vac-Snap®
bags, the low heat cycle should be used.
Vac-Snap® bags come in a variety of
sizes. Each bag has a series of circles or
arrows that indicate the best sealing
locations along the perimeter of the
bag. Remember, never vacuum along
the zipper edge!
To begin, we recommend starting with a
circle at the bottom of the bag. The next
time you reseal the bag, use the next
closest circle. This will ensure that you
get the maximum volume out of the bag.
Caution: Do not reuse indicator circles or overlap heat seals. Doing so will not allow the bag to be resealed.
The first time you use a bag, we
recommend starting with a circle
at the bottom of the bag.
After vacuum sealing, the bag
will be melted around the
alignment circle, creating an
airtight seal.
To vacuum seal a bag again, use
a different alignment circle.
Used Unused
Unused
Using the 12 Volt DC Cord (VS97A Only)
Your Oliso® PRO™ VS97A Smart Vacuum Sealer comes with a 12 Volt DC cord for use in cars, RVs, trucks and boats. ONLY use
the 12 Volt DC cord that comes with your vacuum sealer.
Plug the 12 Volt DC cord into the Oliso® PRO™ VS97A Smart Vacuum Sealer.1.
Plug the 12 Volt DC cord into the DC power source in your vehicle. Make sure that your vehicle has a 10 amp rated fuse or
higher before use.
2.
3. When using the 12 Volt DC cord, make sure that your vehicle’s engine is on and the lights, radio and air conditioner are off.
NOTE: Only use supplied 12 Volt DC Adapter (Oliso® part number VSA201)
DC JACK
Insert DC adapter into
car power source
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Oliso Salva-cibo
