Onyx RCR Manuale
SERVICE NOTES
Visit www.ONYXmotorbikes.com for more information and good vibes. 1
SVC001_Recommended Maintenance Schedule_RCR and CTY_v01
ONYX Motorbikes Maintenance and
Service Interval Guide
APPLICABLE MODELS
Take care of your ONYX Motorbike, and it will take care of you…! This document provides reference information, procedures,
and other supporting information for a suggested regular maintenance schedule that can be used as a general guideline.
CAUTION
If you are not confident in your ability to successfully and safely perform maintenance or repair tasks, we
recommend having the work performed by a local, certified, and reputable bike mechanic. Contact ONYX
Motorbikes for assistance with finding a suitable service shop near you.
CHECKS TO DO BEFORE YOUR FIRST RIDE
Check and adjust your ONYX according to the schedule below unless service is needed otherwise:
WARNING
Use of the ONYX Motorbike can result in serious damage, injury, or death. Read and understand the ONYX
RCR User Manual before operating and riding the bike.
Before Your FIRST Ride OR After Any Major Service
At minimum, do the following on your bike before every ride:
oCheck All Handlebar Hoses, Cables, and Wire Connections
NOTE: Wires and hoses should not be pinched, pulled, or get in the way at all when the handlebars are turned to the left and right.
oCheck the Headlight, Tail Light, & Any Other Installed Lighting for Proper Operation
oCheck Tire Rotation –Should Spin Smooth & Straight (NOTE: Some light brake pad rub with new pads and/or rotors is normal.)
oCheck Tire Pressure (32 psi Front &Rear)
oCheck Front & Rear Brake Operation
oCheck Battery Charge Level (ideally a full charge, but at least more than 60 volts)
oCheck & Torque Fork, Axle, Handlebar, & Suspension Nuts (see RCR or CTY Torque Specs Table)
oCheck & Adjust Front Brake (if necessary)
oCheck & Adjust Rear Brake (if necessary)
oCheck Front Brake Fluid Level (DOT3 Brake Fluid Only)
oCheck for Tight & Secure Battery Strap to Ensure that Battery Will Not Move
oCheck for Complete & Secure Battery Cable Connection
oCheck Rear Wheel & Motor Alignment
oCheck & Adjust Bicycle Chain Tension
oCheck Tightness of ALL Nuts and Bolts (see RCR or CTY Torque Specs Table)
SERVICE NOTES
Visit www.ONYXmotorbikes.com for more information and good vibes. 2
SVC001_Recommended Maintenance Schedule_RCR and CTY_v01
RECOMMENDED BASIC REGULAR MAINTENANCE SCHEDULE
Your ONYX Motorbike will last you forever if you properly service and maintain it. However, the frequency of your service
checks and part replacements will vary depending on how much
fun
you have with your ONYX Motorbike. Under normal
circumstances, check and adjust your ONYX according to the schedule below at minimum:
CAUTION
Always take note of any component wear such as cracks, scratches, or changes in color or operation. These
changes may indicate that a part needs to be serviced or replaced. If the useful life of a component is
surpassed it can cause unexpected loss of function, which can result in damage, serious injury, or even
death.
BEFORE Every Ride
At minimum, do the following on your bike before every ride:
AFTER Every Ride
At minimum, do the following on your bike after every ride:
oCheck the Headlight, Tail Light, & Any Other Installed
Lighting for Proper Operation
oCheck Tire Rotation –Should Spin Smooth & Straight
oCheck Tire Pressure (32 psi F&R)
oCheck Front & Rear Brake Operation
oCheck Battery Charge Level
oCheck & Torque Fork, Axle, Handlebar, and Suspension
Nuts (see RCR or CTY Torque Specs Table)
oWipe Down & Dry Frame & Rest of Bike Parts Using a
Soft Cloth
oCarefully Check Tires for Any Debris
oIf Storing Outside, Cover The Bike, Install Lock, & Set
Alarm
oCheck Basic Care Items (see Basic Care)
1 Month (or 30 Hours)
After you have had 1 month (or 30 hrs) of fun, do all of the
following:
6 Months (or 100 Hours)
After you have had 6 months (or 100 hrs) of great times, do all of
the 1 Month Service items as well as all of the following:
oCheck & Adjust Front & Rear Brake
oCheck Front Brake Fluid Level (DOT3)
oCheck Battery Strap to Make Sure Battery Is Secure
oLube Bicycle Chain & Freewheel
oCheck Rear Wheel & Motor Alignment
oCheck & Adjust Bicycle Chain Tension
oLube Rear Brake Cable
oInspect & Clean Frame
oCheck Rear Hub Motor Cable Condition and Clearance
oLube All Moving Parts & Bearings
12 Months (or 200 Hours)
After you have had 12 months (or 200 hrs) of awesome journeys, do
all of the 6 Month Service items as well as all of the following:
24 Months (or 400 Hours)
You and your bike have been through a lot. After you have had 24
months (or 400 hrs) of amazing adventures, do all of the 12 Month
Service items as well as all of the following:
oCheck Battery Connections
oCheck Tire Tread Depth
oChange Alarm Key Fob Battery
oCheck Tightness of ALL Nuts and Bolts (see RCR or CTY
Torque Specs Table)
oChange Front Brake Fluid (DOT3)
oChange Front Brake Pads
oChange Rear Brake Pads
oCheck & True Front and Rear Wheel Rims
SERVICE NOTES
Visit www.ONYXmotorbikes.com for more information and good vibes. 3
SVC001_Recommended Maintenance Schedule_RCR and CTY_v01
BASIC CARE –THE BARE BONES BASICS
1. Regularly clean and lubricate all moving parts, tighten nuts/bolts, and adjust as required. This includes all
steering, bicycle pedals, suspension, and wheel parts. See the RCR Hardware and Torque Specs Service
Notes document for hardware and tightening information for your ONYX Motorbike.
2. Keep your bike clean by wiping the frame with a damp cloth. If needed, apply a mild cleaner or soap
mixture to the damp cloth and wipe the frame. Dry your bike by wiping with a clean, dry cloth. Never hose
down or submerge the bike or any components in water or liquid as the electrical system may be
damaged.
3. Occasionally check wiring and connectors, especially up and around the handlebars, to ensure there is no
damage and that the connectors are secure. Also check the condition of any wire wrap and cable ties to
make sure that they are intact. Replace any that are loose, frayed, or partially cut.
4. Properly maintain your battery by keeping it charged or charging before use. Please note that it is
possible and normal for the battery to lose some charge if it is left sitting for a few days, so it may be
necessary to top it off for as long as a couple of hours if you need the battery to have a full charge for your
intended ride.
If you know that you will not be riding for more than one week, keep the battery charged to more than a
50% level and keep the battery at room temperature. See the BATTERY CARE/MAINTENANCE/SAFETY
TIPS section of your RCR User Manual for more useful information about battery use and care.
5. Whenever possible, store your ONYX Motorbike under shelter or cover it with a quality cover. Even using a
large barbecue cover can work well! Otherwise, avoid leaving the bike in the rain or exposed to corrosive
materials. If exposed to rain, dry your bike afterwards and apply anti-rust treatment to chain and other
unpainted steel surfaces.
6. Riding on and near the beach in coastal areas or even in areas that may use road salt for ice and snow can
expose your bike to salt, which is very corrosive. If you ride in these areas, wipe down your bike frequently
and wipe or spray all unpainted parts with anti-rust treatment.
Please note that damage due to corrosion is NOT covered under warranty so special care should be given
to extend the life of your bike when used in coastal areas or areas with salty air or water.
7. If the front hub, front fork, or swing arm bracket have been submerged in water or liquid, they should be
taken apart to be cleaned and greased with a quality grease. Even though the rear hub motor is protected
and sealed against dirt and water intrusion to an IP54 level, it should not be submerged in water. A splash
through a small creek or large puddle is normally fine, but it doesn’t mean that you should trudge across a
river. If you do plunge into excessive amounts of water with the rear hub motor, try to get it to a dry
environment as soon as possible, dry it off, and let it air dry as long as possible.
8. If the paint has become scratched or chipped in the metal, use colored touch up paint or even clear nail
polish on the scratch to help prevent rust. If rust has already started, carefully clean the rust off with a
small wire brush or emery cloth, and coat the scratch with touch up paint.
Altri manuali per RCR
1
Questo manuale è adatto per i seguenti modelli
1
Altri manuali Onyx Motociclo
