Oplink SOK01 Manuale utente
Oplink Communications
User Guide
I. Product Introduction
Shock sensor is a 433MHz wireless remote control. When the monitor device
shock exceed 1 G, and it will send arm/disarm/panic signal to the system.
Stand by
Montor device
Was strongly
impact
Vibration strength
more than trigger
threshold
Transmit RF
singal
Receiver
Y
N
Oplink Communications
II. Installation
(1) Usage scenario:
•Indoors or windows and away from direct sunlight.
•Away from extreme temperature sources and large metal objects.
(2) Operation：
•push the locker of Remote control.
•Insert the battery noting the polarity (A23 battery);
Oplink Communications
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Oplink Communications
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following
test methods have been applied in order to prove presumption of conformity with the essential requirements
of the R&TTE Directive 1999/5/EC:
- EN 60950-1: 2006+A11:2009+A1:2010+A12:2011
- EN 300 220-1 V2..1 (201-0)
- EN 300 220-2 V2..1 (201-0)
- EN 301 489-1 V1.9.2(2011-09)
- EN 301 489-3 V1.4.1 (2002-08)
- EN 62479: 2010
- In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain
authorization to use the device for setting up outdoor radio links and/or for supplying public access to
telecommunications and/or network services.
- This device may not be used for setting up outdoor radio links in France and in some areas the RF output
power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed information
the enduser should contact the national spectrum authority in France.
DEVICE DISPOSAL
1. Dispose of batteries properly and in accordance with applicable local laws. Do not burn batteries.
They may explode.
2. Recycle electrical products. Check with your local authority for recycling information. Do not dispose electrical
products with household waste.
OPERATING AND STORAGE
- Operating and storage: 0º to 50º C
Indice
Altri manuali Oplink Accessori
