OSS OSS-579 Manuale utente

OSS-579 Gen5 Adapter Card

INSTALLATION GUIDE

OSS-579 Gen5 Adapter Card

www.onestopsystems.com

One Stop Systems

Table of Contents

1 Technical Information .......................................................................................................4

1.2 Product Information................................................................................................................... 4

1.3 General Specification ................................................................................................................. 5

1.4 Features ................................................................................................................................ 5

1.5 Block Diagram.......................................................................................................................... 6

1.6 Dimensions.............................................................................................................................. 6

1.7 Supported Use Cases .................................................................................................................. 7

1.7.1 x16 Use Case........................................................................................................................ 7

1.7.2 x8 Use Case ......................................................................................................................... 7

1.7.3 x16-x8,x8 Use Case ................................................................................................................ 8

1.8 Card Dipswitch Settings............................................................................................................... 9

1.8.1 x16 Host mode...................................................................................................................... 9

1.8.2 x8 Host mode ....................................................................................................................... 9

1.8.3 Target mode ........................................................................................................................ 9

1.9 LED Indicators.........................................................................................................................10

2 Hardware Requirements .................................................................................................. 11

3 Software Requirements ................................................................................................... 11

4 Unpacking.................................................................................................................... 12

5 Setup / Installation ......................................................................................................... 13

5.1 Installation Overview .......................................................................................................................13

5.2 Set Dipswitches .......................................................................................................................13

5.2.1 Set Target Card Dipswitches.....................................................................................................13

5.2.2 Set Host Card Dipswitches .......................................................................................................13

5.3 Prepare OSS Backpklane .............................................................................................................14

5.4 Install Target Card....................................................................................................................14

5.5 Install Host Card ......................................................................................................................15

6 Cable Installation ........................................................................................................... 16

7 Powering UP the unit ...................................................................................................... 17

8 Hardware Check ............................................................................................................ 17

8.1 Verify Board LEDs.....................................................................................................................17

8.2 Verify Adapter Card LEDs............................................................................................................18

9 Post Installation............................................................................................................. 19

9.1 Linux ...................................................................................................................................19

9.2 Windows ...............................................................................................................................22

10 How to Get More Help ..................................................................................................... 25

10.1 Contacting Technical Support.......................................................................................................25

10.2 Returning Merchandise...............................................................................................................25

10.3 Third Party Hardware & Software Support Policy ................................................................................25

OSS-579 Gen5 BP 2

One Stop Systems

10.4 Online Support Resources ...........................................................................................................25

OSS-579 Gen5 BP 3

One Stop Systems

1 Technical Information

1.2 Product Information

PCIe x16 Gen 5 host interface board with PCIe dual QSFP-DD cable connectors that can be configured as x16 or two x8 cable

ports.

•The cable adapter operates in host or target mode controlled with DIP switch settings.

•With the OSS-PCIe5-HIB732-x16-H installed in a PCIe slot in PCIe Gen 5 motherboard and the OSS-PCIe5-HIB732-x16-T

installed in an external target chassis full 128 GB/sec (full duplex) PCIe Gen 5 bandwidth is enabled using dual custom

QSFP-DD copper cables up to 2m in length.

•All PCIe devices in the remote chassis appear to the host CPU as directly connected PCIe peripherals on the PCIe switch

fabric.

OSS-579 Gen5 BP 4

One Stop Systems

1.3 General Specification

Form Factor PCIe 5.0 x16 add-in card

Dimensions 6.6” x 2.65” (16.76 x 6.73 cm) at 0.063” (1.6mm) thickness

Bandwidth 32GT/sec per lane, 128 GB/sec (full duplex) with x16 lanes

Connectors PCIe x16 card edge connector

Dual QSFP-DD connectors with custom pin-out (OSS cables required)

1 additional internal x8 PCIe ARF connector

Bracket Standard and low-profile brackets available

PCIe Switch Broadcom PEX 89072

•32 GT/sec 72 lane PCI Express Gen 5 Switch

•DMA Controller

•SSC Isolation

Switch Latency 150 nsec

Cable Types Supports the following cable types:

•Custom QSFP-DD PCIe CMI copper cables; .5m, 1m, 2m, 3m

•Remote power and reset control

Cable Connection Modes One x16 host connection via edge card to:

•One x16 cable connection

•Two x8 cable connections

Power 20 W Max

1.5A @3.3V

1.2A @12V

[email protected] aux

Operating Temperature 0 C to +40 C

Storage Temperature -40 C to 85 C

Operating Humidity 10% to 90% relative humidity non-condensing

Storage Humidity 5% to 95% relative humidity non-condensing

Agency Compliance Designed to meet the following agency standards:

•FCC—Part 15 Class A, 47CFR; Canada ICES-003, issue 4, Class A; Japan: VCCI, Class

A; CE Emission 2004-108EC

•UL/IEC 62368-1; Canada: CSA C22.2 No. 62368-1; Argentina: IEC62368-1; IEC 62368-

1 (CB Certificate and CB Test Report)

•CE Mark (EN55022 Class A, EN62368-1, EN55024, EN61000-3-2, EN610000-3-3)

•CISPR 22, CISPR 24, Class A; Australia/New Zealand AS/NZS CISPR 22, Class A

•RoHS 3 Compliance (Directive 2015/863/EC)

Drivers / Software Requires no software / driver installation

Supported Operating Systems Windows 10 & Windows 10 Pro

Windows 2012 Server and higher

Centos 7

Ubuntu 16x and higher

1.4 Features

•Operates at PCIe Gen 5 speeds up to 32 GT/sec per lane.

•Delivers 128 GB/sec (full duplex) bandwidth with x16 lanes.

•No drivers required.

•Utilizes custom QSFP-DD cables with sideband signals to support power control and remote reset (CMI functionality) x8

lanes per cable, 2 x8 cables used for x16 link.

•Can operate either Host or Target mode with the correct dipswitch settings.

OSS-579 Gen5 BP 5

One Stop Systems

1.5 Block Diagram

1.6 Dimensions

OSS-579 Gen5 BP 6

One Stop Systems

1.7 Supported Use Cases

1.7.1 x16 Use Case

Using two link cables connected between a host computer and a Gen5 backplane or an OSS expansion unit.

1.7.2 x8 Use Case

Using one link cable connected between a host computer and Gen5 backplane or an OSS expansion unit.

OSS-579 Gen5 BP 7

One Stop Systems

1.7.3 x16-x8,x8 Use Case

A single host computer connected to two OSS Gen5 backplanes or two expansion units via x8 link connection.

OSS-579 Gen5 BP 8

One Stop Systems

OSS-579 Gen5 BP 9

1.8 Card Dipswitch Settings

The following photos are three different dipswitch-mode settings on the OSS-579 adapter cards.

1.8.1 x16 Host mode

X16 Host mode requires two link cables

1.8.2 x8 Host mode

X8 Host mode uses only one link cable

1.8.3 Target mode

Target mode will only work on OSS backplane (Upstream slot #0).

HOS

T I

TARGET

= HOST= OFF

#PWR

OFF

MAGMA

oss

OFF

PRTCFGO

PRTC

FGl =

PRTC

FG2

DBG2

DBG3

OFF

..{ " I

l • I . • •,

,is111c·

...

t.~)

.,"

'°

""''

)

1,'

•

t I

•

r J •

..,

x16 Host

HOS

T I

TARG

ET = HOST =

OFF

#PWR

OFF

MAGMA

055

= - -

OFF

PRTCFGO

OFF

PRTCFGl

PRTCFG2

DBG2

DBG3

OFF

• . r

.,,

1' • •,

«s111c·

1.~)

·•""1

Iii

• t v

r•

I•,

•

I I

~:• III , •

•

..,

I "

Host

TARGET

= TARGET=

2 #PWRON #PWRT

OFF

MAGMA

oss

OFF

PRTCFGO

= ON

5 PRTCFGl =

F Target

OSS

6 PRT

CFG2

= ON

DBG2

= ON

DBG

3 =

OFF

One Stop Systems

1.9 LED Indicators

579 LED Color NAME Normal

State Description

D1 Green Debug LED1 ON Reserved for Atlas switch heartbeat –

currently not implemented

D2 Green Debug LED2 ON currently unused

D3 Green Debug LED3 ON Power good 1.25V (switch serdes power)

D5 Green Aux Power ON 3.3V AUX power ON

D6 Green PGD - Power

Good ON All power good

D9 Green Link LED ON

Link Status:

-- Cbl link status (D8 -bottom cable)

indicates bottom cable link status only if in

x8x8 mode, rate as above.

-- Cbl link status (D9 –top cable) indicates

x16 link status of both cables or top cable in

x8x8 mode.

CR3 Red PEX Fatal Error OFF When ON= Error or Faulty

D7 Green PTGD - Port

Good ON

Card Edge Link status:

--ON (steady state) indicates Gen5 link

--Blink rate 2 Hz indicates Gen4 link

--Blink rate 1 Hz indicates Gen3 link

--Blink rate 0.5 Hz indicates Gen2 link

--Blink rate 0.25 Hz indicates Gen1 link

OSS-579 Gen5 BP 10

Indice

Altri manuali OSS Adattatore

OSS

OSS OSS-PCIe-HIB38-x8-DUAL Manuale utente

OSS

OSS OSS-PCIe-HIB38-x4 Manuale utente

OSS

OSS OSS-CPCIe3-3U-10GbE-x4-QUAD Manuale utente

OSS

OSS OSS-XMC-HIB25-X8 Manuale utente

Manuali Adattatore popolari di altre marche

PCB Piezotronics

PCB Piezotronics 090B274 Manuale utente

Auvidea

Auvidea J20 Manuale del prodotto

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manuale utente

Akribis

Akribis ITF-21-BISS-MIT Manuale utente

Tenda

Tenda W54U Manuale utente

ROHO

ROHO AGILITY Manuale utente

PROLiNK

PROLiNK WN2001 Manuale utente

Hawking

Hawking HUF2 Manuale utente

Airlink101

Airlink101 AWLC4030 Manuale utente

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manuale utente

Philips

Philips SWA4554S/10 Manuale utente

JVC

JVC TS-C9D2B Manuale di istruzioni

NETGEAR

NETGEAR A6100 Manuale utente

D-Link

D-Link DWA-121 Manuale utente

Philips

Philips SWA2037 Manuale utente

Basalte

Basalte 0610-20 Manuale utente

Yealink

Yealink EHS40 Manuale utente

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manuale utente