OSTBA FM302 Manuale utente
Instruction Manual
Model No.: FM302
Before operating this unit, please read these instructions completely.
IMPORTANT: safety advice
To avoid electric shocks, do not use this device in the vicinity of water. Do
not immerse the mains lead in water or other liquid.
Please read through the information and safety advice contained in these
operating instructions carefully and thoroughly before you use the stand
mixer for the first time.
Do not kink or clamp the mains lead. To avoid any risk of stumbling, do not
allow the mains lead to hang over the edge of a table or a counter.
Make sure that the voltage shown on the rating plate corresponds with that
of the mains supply.
The rating plate can be found on the bottom of the motor block. The stand
mixer is only to be connected to an AC supply.
The motor must always be switching off before the stand mixer is connected
with the mains supply.
Do not use outdoors. Only suitable for use indoors.
This device should not be set up in close proximity to a naked flame, easily
flammable materials (cur-taints, textiles, etc. ), a radiator, an oven, or some
other heat source.
Before use, place the device on a horizontal and flat surface.
Place this device as close as possible to the power source so that you can
disconnect the plug quickly and easily.
The device must be operated with the type of power specified on the rating
plate.
If you are unsure about the details of the available power supply, ask your
dealer or the local power supply company.
Do not attempt to repair the device yourself, since you will be exposed to
hazardous live components or other hazards by opening and removing the
covers.
Repairs should only be carried out in a qualified workshop.
This is not a toy! Keep away from children. The device should be used and
stored out of the reach of children.
Careful supervision is required when the device is used by or in the vicinity
of children.
The device should only be used for its intended purpose.
Never operate empty and without supervision.
During use, do not touch moving parts with your fingers.
Please note that when passing the device on to a third party, the operating
instructions must be included.
No liability is accepted for damage due to improper use or the failure to
observe our operating instructions/safety notes.
Unplug the appliance when not in use or before cleaning.
If the supply cord is damaged, it must be replaced by the manufacturer or
its service agent or a similarly qualified person in order to avoid a hazard.
Switch off the appliance before changing accessories or approaching parts
which move in use.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capacities, or lack of experience and
knowledge unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your
appliance. Always read and obey all safety messages.
This is the safety alert symbol. This symbol alerts you to potential hazards that
can kill or hurt you and others. All safety messages will follow the safety alert
symbol and either the word “DANGER” or “WARNING.” These words mean:
You can be killed or seriously injured if you don’t immediately follow
instructions.
All safety messages will tell you what the potential hazard is, tell you how to
reduce the chance of injury, and tell you what can happen if the instructions are
not followed.
ELECTRICAL REQUIREMENTS
Volts: 120V~ 60Hz 550W
The wattage rating for your stand mixer is printed on a tag under the mixer base.
It is also listed on the trim band. If the power cord is too short, have a qualified
electrician or serviceman install an outlet near the appliance. The maximum
rating is based on the attachment that draws the greatest load (power). Other
recommended attachments may consume scantly less power.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, electrical shock.
WARNING
NOTE: Do not scrape the bowl while the stand mixer is operating.
The bowl and beater are designed to provide thorough mixing without frequent
scraping. Scraping the bowl once or twice during mixing is usually sufficient.
Turn the stand mixer off before scraping.
The stand mixer may warm up during use. Under heavy load with extended
mixing time, you may not be able to comfortably touch the top of the stand
mixer. This is normal.
TECHNICAL INFORMATION
• Voltage/frequency : 120V~ 60Hz 550W
• Bowl capacity: 5.5 QT
• KB: 5 Minutes (Never use this appliance constantly for more than 10
minutes!)
• Never use mixer, blender, meat grinder function with food at the same
time(only use one by one to protect the machine)
BEFORE FIRST USE
All parts of the stand mixer are to be thoroughly cleaned before being used for
the first time. (see section: Cleaning).
Take out the required length of cable from the cable tidy on the base of the
blender and connect the device to the mains supply.
TRIAL USE
Revolve the locking switch, then lift the machine arm.
Put the mixing bowl onto the base, and lock it as the arrowhead denotes.
Fix the dusty cover onto the mixing blade, then lock the blade into the machine
Revolve the locking switch, then push the upper cover down and make the arm
down. Make sure the arm is fixed together with the base, then Revolve the
locking switch up to lock the arm solidly.
Plug-in the cord, and turn the switch slowly from speed”1” to speed ”8” ( every
speed try for a few seconds).
After the trial, turn the switch to speed “OFF”.
Turn the locking switch and lift the arm, then take apart the mixing blade from
the blade connector try again.
OPERATION GUIDE
To mix or Knead dough :
• Suggestion flour and water at a ratio of 5 : 3.
• Dry flour max: 600g
• Dough max: 1KG
•Use speed 1 mix for 5 minutes for making dough.
• When filling the food in mixing bowl, please ensure that the maximum
quality is not exceeded.
• The dough blade or mixing blade should be used.
Whisking egg whites or cream
•Switch on speed 6 to speed 8, whisk the egg whites without
stopping for about 5 minutes, according to the size of the eggs until
stiff.
• Maximum quantity of 20 eggs.
• For the whipped cream, whip 250ml fresh cream at speed 6 to 8 for about 5
minutes.
• When filling the agitator kettle with fresh milk, cream, or other ingredients,
please ensure that the maximum quality is not exceeded.
• The egg beater should be used.
Mixing shakes, cocktails, or other liquids
•Mix the ingredients according to the available recipe, from speed 1
to 6for about 5 minutes.
• Do not exceed the maximum quantity for the mixing bowl.
• The mixer beater should be used.
• Maximum operating time 4 minutes, When the machine on its rating power
(650 watts).
CLEANING
Before cleaning, please ensure that the Switch knob is at the “OFF” position and
that the plug has been disconnected from the socket.
After use, allow the device to cool down before you start to clean it.
To clean the exterior of the device, use a moist cloth and a mild detergent.
When cleaning the interior and exterior and protective dust cover do not use any
abrasive detergents or alcohol.
To clean the device, never submerge it in water.
The dough beater, mixer beater, mixing bowl are not dishwasher
The accessories must be cleaned only in warm water and washing-up liquid.
The plastic accessories, Mixing bowl lid, egg beater can be cleaned with warm
PACKING LIST
• Main body 1 set • Egg whisk 1 set
• Mixing bowl 1 pc • Mixing blade 1 set
• Dough hook 1 set • Instruction manual 1 pc
•Warrantycard1pc
Hong Kong TopChef Appliance Limited
Room P, 4/f, Lladro Centre, 72 Hoi Yuen Road Kwun Tong Kowloon
Website: www.ostba.cc
E-mail: [email protected]
5013380
MADE IN CHINA
Indice
Altri manuali OSTBA Miscelatore
