Oypla DIY 4641 Manuale utente
User Manual
3 Ton Jack Stands
USER MANUAL Model No: 4641
•This product is not a toy, and is only to be used for its designated purpose.
•Never carry out any alterations or modifications to this product.
•Only use this product on stable, level and dry ground.
•Always keep your hands and feet away from the immediate working area.
•Before using the product, make sure all fastenings are tightly in place and that
everything is in order, and checked periodically.
•Leaving this product outside exposed to weather, especially direct sun, rain and
salt air, will speed with the weathering process. This can be slowed by removing
the product from these conditions, or covering it with a suitable cover.
•When not in use the lift must be stored in the lowest position n in a dry location.
•This product is not intended for use by persons (including children) with reduced
physical, sensory and mental capacities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
product by persons responsible for their safety.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product. Do this regularly to keep the
product clean of any oil or grease.
•If the product is damaged or has any defects, please contact [email protected]
USER MANUAL Model No: 4641
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
Operating Instructions
Parts List:
If you are missing any of the below parts please contact cservice@oypla.com
Please be aware that you will be referring to this parts list throughout the assembly
process.
1. Refer to your vehicle owner’s manual for the correct jack
lifting point. This area of the vehicle should be specified by the
vehicle manufacturer.
2. Position the stands under vehicle at points specified by
vehicle manufacturer.
3. To adjust the stands, hold the control lever up while lifting
saddle shaft to the desired height. Push the control lever
downwards to lock pawl into teeth located in central column.
Make sure the pawl is fully engaged with the teeth.
4. Carefully lower the load onto the stands.
USER MANUAL Model No: 4641
Imported by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 4641
Indice
Altri manuali Oypla Jack
