Pact CLUB TIMER III Manuale utente
CLUB TIMER III
INSTRUCTION MANUAL
Additional information and help is available on PACT.com.
Turn Timer On/O
Press any button to turn the timer on. It
will turn o when you press GO and RVW
together, or automatically after 15 minutes of
inactivity.
Timer Mode
When you turn the timer on there are no
shots in memory, it will display a “bouncing
ball” on the right side to let you know it’s
working.
DELAY or INSTANT will be lit telling you
whether there will be a delay of 2 to 3.5
seconds after you release the GO button
for the buzzer to sound, or if the buzzer
will sound instantly upon release of the GO
button. If a PAR time has been entered it will
be also displayed.
Press and release the GO button. The buzzer
will sound and the TIME will start counting
up. Each time a shot is red the shot #will
increment, the shot time (last shot red) and
split time will be displayed. In addition, the
FIRST SHOT time will be displayed on the
lower left of the display – unless a PAR time
is entered.
Pressing GO will clear the current string and
start a new string.
Review Mode
Assuming you’ve recorded some shots,
pressing RVW will get you into Review Mode.
Each time you press RVW the timer will
increment to the next shot and display the
time of that shot, and split from the previous
shot.
The UP/DOWN arrows will let you scroll
forward and backward through your shots.
Any time you press GO in Review Mode the
timer will jump to Timer Mode and start a
new string.
Set Mode
Set Mode is used to switch between DELAY
or INSTANT go, and enter or clear a PAR
time.
To enter Set Mode press and release the
UP/DOWN arrows together. You’ll see that
SET appears, and DELAY and INSTANT are
alternating. Press the UP arrow (toward the
display) to freeze it on DELAY. Press the
DOWN arrow to freeze it on INSTANT.
After you’ve set DELAY or INSTANT, PAR will
begin to ash. If you do not want to enter a
PAR time just press GO.
To enter a PAR time press RVW. The current
PAR time (if any) will appear with the
hundredths number ashing. Use the UP/
DOWN arrows to set the number you want.
Press RVW to accept the number and move
to the left (tenths, ones, tens).
When you have the complete par time
entered, press GO to jump back to Timer
Mode. Note that PAR is now lit and the time
you entered is now displayed in the lower left
corner.
When a PAR time is used the FIRST SHOT
feature is disabled. The SPLIT time of the rst
shot after the PAR is the time from the PAR
buzzer to the shot. It is the amount overtime,
not the time between shots.
SHORTCUT: A quick way to clear a PAR time
is to enter Set Mode, set your INSTANT/
DELAY, then press GO. No need to set
everything back to zero.
Adjust Sensitivity
With the proliferation of action shooting
disciplines, the sensitivity of the microphone
has become an issue. Set too sensitive,
the timer will pick up shot echoes or even
its own buzzer. Not sensitive enough and
it can miss shots, a real problem with the
low power rounds. We have included an
adjustment located in the corner of the
battery compartment, however, we strongly
recommend that you do NOT mess with it.
Replacing Battery
It’s best to change the battery with the timer
on, to insure that it resets properly when the
new battery is installed. Should the time lock
into o mode when you install a new battery
just remove the battery and let the timer sit
for a few minutes to dissipate the internal
charge.
Altri manuali Pact Timer
