Panasonic EH-HS41 Manuale utente

Order Number PEWT1512A04CE

(

Household

)

Hair Strai

htener

Model No. EH-HS41

CIS

Middle East

Asia

TABLE OF CONTENTS

age

1 Warning………………………………………………

…

2 Specifications………………………………………

…

3 Troubleshooting Guide……………………………

…

4 Disassembly and Assembly instructions………

…

5 Wiring Connection Diagram………………………

…

6 Schematic Diagram…………………………………

…

7 Explode View and Replacement Part List……… 10

copying

and distribution is a violation of law.

1. Warning

Caution:

- Pb free solder has a higher melting point that standard solder Typical the melting point is 50 - 70°F (30 - 40℃)

a higher. Please use soldering iron with temperature control and adjust it to 750 ±20°F (400 ± 10℃).

In case of using high temperature soldering iron, please be careful not to heat too long.

- Pb free solder will tend to splash when heated too high (about 1100°F / 600℃).

Model

Sales Area

Power source / Power consumption

Iron Plate temperature

Body size (mm.)

Weight

Cord length 2.0 m

2.0 m

S3(SF629) Plug

B2(SF822) Plug

B2(SF82) Plug

AC 100-130V ~ 50-60Hz 55W

EH-HS41

Asia

AC 220-240V ~ 50-60Hz 55W

B2 Plug(SF82)

B2 Plug (SF822)

2. Specifications

435 g

378 g

380 g

140-160-180-200-230℃(5 level settings)

287×42×45

S3 Plug(SF629)

3. TROUBLESHOOTING GUIDE

Refer to WIRING CONNECTION DIAGRAM.

LED at 140 º C

No operation

(LED does not light)

< CHECKING PROCEDURE > < CHECKING METHOD > < REMEDY >

Check the Power cord. Check the conductivity

of Power cord.

Check the Power Switch

(0/1)

Hold the On/off switch (Tag Switch)

pressed longer and check if LED

(Power Lamp) lights. LED at * 140ºC

will start blinking (LED will turn from

BLINK to LIGHT after round one

minute).

LED light, but Iron

Plate(Heater)

does not become hot

Check Iron plate of Heater

A : Housing side Replace Heater A ass'y b/k

Check if resistance value between

lead wires of the Housing side assy is

approx. 20.0±1.0

Check the Lead Wire Check connecting of Lead Wire Replace Heater A ass'y b/k

or Heater B ass'y b/k

Replace Heater B ass'y b/k

Check Circuit assembly b/k Replace Circuit assembly

b/k

LED dose not light , Iron

Plate(Heater A,B) Replace Circuit assembly

b/k

Check the Power Switch

button of the Housing side Check the operation of On/off Switch

button of Housing side.

(Check if it works smoothly)

Replace the Power Cord

Figure1

Check Iron plate of Heater

B : Press plate side Check if resistance value between

lead wires of the Press plate side

assy is approx. 20.0±1.0

Replace the Housing A

Replace Circuit assembly

b/k

Temperature dose not

change even though the

Temperature level

adjustment switches

is pressed.

Check the Temperature

level Adjustment Switch

(Tag Switch)

Check Circuit assembly b/k Replace Circuit assembly

b/k

< CHECKING PROCEDURE > < CHECKING METHOD > < REMEDY >

Check Circuit assembly b/k Replace Circuit assembly

b/k

Figure2

All LEDs blinks.

Check Heater A

: Housing side Check connecting of Thermistor Replace Heater A :

Housing side

LED lights, but the Iron

plate (Heater A,B) dose

not become hot.

Check the operation of LED(Temp.

Level Lamp) by pressing Tag switch

of the Temperature level adjustment

switch on Circuit assembly b/k longer

with fingers (Figure2)

Replace Circuit assembly

b/k

4 Disassembly and Assembly instructions

4.1 Disassembly instruction

(1) Remove Shaft Cover from Main Body (4) Remove Pivot spring by gripping

by Slotted screw driver (Minus Driver.) and pulling it out from the Main body

(2) Remove Torx screws at Shaft position.

by Phillips screw driver (Plus driver).

(5) Remove 6 screws for fitting Press Plate side

by Phillips screw drivers (Plus Driver).

(3) Remove Shaft out by tiny-shaped Phillips screw drive

(6) Remove Press Plate Cover at the Hook part

(Plus Driver) and pull it out from the main body. by Slotted screw driver (Minus Driver).

Screws

(7) Take off Iron Plate from Hook of Press Plate (10) Remove 6 Screws by Phllips screw driver

by slide. (Plus Driver).

(11) Remove Housing A from Housing B in Grip

follow as below drawing.

(8) Take off Press Plate

(9) Remove 2 screws of the Housing side

by Phllips screw driver (Plus Driver). ②When Remove Housing A,

Be careful 2 springs disappear.

Slide Iron Plate

Screws

Housing A

(12) Take off Iron Plate and Circuit assembly b/k from Housing B.

①Take off Iron Plate from Hook of Housing B by slide.

②Take off Circuit by push at Hook of Housing B

Hooks

4.2 ASSEMBLY instruction

(1) Shaft Cover fixing point.

(2) Housing B Assembly Point.

4.3 Lead wire of Iron Plate(Heater A , Heater B) and Circuit arrangement po

(1) Lead wire of Iron Plate(Heater A assembly b/k) and Circuit assembly b/k

arrangement follow as below.

(2) Lead wire of Iron Plate(Heater B assembly b/k) arrangement follow as below.

(3) Shaft Cover must be control direction follow as below.

WhiteWhite Blue

Black

Violet

Gree

Blue

White

Blue

White

Black

5. WIRING CONNECTION DIAGRAM

6. SCHEMATIC DIAGRAM

TH+

TH-

Iron Plate (Heater A sid

Iron Plate (Heater B sid

Altri manuali per EH-HS41

Indice

Altri manuali Panasonic Ferro da stiro

Panasonic

Panasonic EH-HT40 Manuale utente

Panasonic

Panasonic EH-HV11 Manuale utente

Panasonic

Panasonic EH-HV40 Manuale utente

Panasonic

Panasonic EH-HV22 Manuale utente

Panasonic

Panasonic EH-HV10 Manuale utente

Panasonic

Panasonic EH-HV51 Manuale utente

Panasonic

Panasonic EH-HV11 Manuale utente

Panasonic

Panasonic EH-HV20 Manuale utente

Panasonic

Panasonic EH-HW32 Manuale utente

Panasonic

Panasonic EH-HT40 Manuale utente

Panasonic

Panasonic EH-HV21 Manuale utente

Panasonic

Panasonic EH-HV10 Manuale utente

Panasonic

Panasonic EH-HV70 Manuale utente

Panasonic

Panasonic EH-HV52 Manuale utente

Panasonic

Panasonic EH-HV21 Manuale utente

Panasonic

Panasonic EH-HW11-K865 Manuale utente

Panasonic

Panasonic Nanoe EH-PHS9K Manuale utente

Panasonic

Panasonic EH2331 Manuale utente

Panasonic

Panasonic EH1673-A3 Manuale utente

Panasonic

Panasonic EH-HS50 Manuale utente

Panasonic

Panasonic EH-HS95 Manuale utente

Panasonic

Panasonic EH-HV20 Manuale utente

Panasonic

Panasonic EH-2351 Manuale utente

Panasonic

Panasonic EH-2351 Manuale utente

Manuali Ferro da stiro popolari di altre marche

Vitek

Vitek VT-2505 Manuale utente

Morphy Richards

Morphy Richards IB22063 Scheda informativa del prodotto

TZS First AUSTRIA

TZS First AUSTRIA Ida FA-5670-3 Manuale utente

izzy

izzy LN-112 Manuale utente

Vitek

Vitek VT-2310 Manuale utente

Okoia

Okoia HS23 Manuale utente

Arzum

Arzum TRENDCARE AR 5042 Manuale utente

SOLAC

SOLAC PP7251 Manuale utente

VS Sassoon

VS Sassoon VSLE330A Manuale utente

Philips

Philips HP8339 Manuale utente

Philips

Philips HP4666 Manuale utente

Vitek

Vitek VT-8291 Manuale utente

VS Sassoon

VS Sassoon miniPRO Wave Envy Manuale utente

Arzum

Arzum SUPERSTAR TOUCH Manuale utente

Remington

Remington S2880ZBA Manuale utente

cecotec

cecotec Bamba RitualCare 900 Wet&Dry Max Manuale utente

Philips

Philips HPS950 Manuale utente

Andis

Andis Gold CSI-1E Manuale utente