MMR2 Installation and Service Manual Ver 1 1
Intended Audience
This manual is for technicians trained to install and service Parabit Systems, Inc. MMR2 card readers.
Trademark Acknowledgments
ACS-1EUL, ACS Enterprise, AFH Service, AVA, AXSView Service, MMR2, and SkimGard are registered
trademarks of Parabit Systems Inc. or its subsidiaries in the United States and/or other countries.
Parabit Systems, Inc. and Parabit are trademarks of Parabit Systems Inc. or its subsidiaries in the United
States and/or other countries.
All other trademarks and trade names are the property of their respective owners.
FCC Compliance Statement (United States)
This device complies with Part 15 of the Federal Communications Commission (FCC) Rules. Operation
is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
CAUTION:
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the manufacturer's instructions,
may cause interference harmful to radio communications.
There is no guarantee, however, that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is con-
nected.
Consult the dealer or an experienced radio or TV technician for help
The FCC identifier for this device is FCC ID:2AUGM-MMR2.
This device contains FCC Certified RF module with FCC ID: 2AA9B05.
Co-location of this module with other transmitters that operate simultaneously has been evaluated
using the FCC multi-transmitter procedures.
.
Preface
