WARNING! - Ignoring the following may result in injury or damage
to equipment
SAFETY
Where there is conflict between EMC and Safety requirements, personnel safety
shall always take precedence.
•Never perform high voltage resistance
checks on the wiring without first
disconnecting the drive from the circuit
being tested.
•Whilst ensuring ventilation is sufficient,
provide guarding and /or additional
safety systems to prevent injury or
damage to equipment.
•When replacing a drive in an
application and before returning to use,
it is essential that all user defined
parameters for the product’s operation
are correctly installed.
•All control and signal terminals are
SELV, i.e. protected by double
insulation. Ensure all external wiring
is rated for the highest system
voltage.
•Thermal sensors contained within the
motor must have at least basic
insulation.
•All exposed metalwork in the Inverter
is protected by basic insulation and
bonded to a safety earth.
•RCDs are not recommended for use
with this product but, where their use
is mandatory, only Type B RCDs
should be used.
EMC
•In a domestic environment this product
may cause radio interference in which
case supplementary mitigation
measures may be required.
•This equipment contains electrostatic
discharge (ESD) sensitive parts.
Observe static control precautions when
handling, installing and servicing this
product.
•This is a product of the restricted
sales distribution class according to
IEC 61800-3. It is designated as
“professional equipment” as defined
in
EN61000-3-2. Permission of the
supply authority shall be obtained
before connection to the low voltage
supply.
Safety Information
!
WWW.SDS.LTD.UK | 0117 9381800
