5.2：ELECTRICAL
Please ensure that the air compressor is electrically connected in a safe and correct manner.
Any electrical work should be carried out by an electrician and installed in a way which
meets all applicable codes and regulations.
Failure to connect the air compressor correctly to power source may result in serious
personal injury or damage to the equipment.
Please note that under normal conditions, the air compressor will operate intermittently.
Should it be necessary to service, ensure the power source has been shut down to prevent
personal injury or damage to the unit.
If the supply cord is damaged, it must be replaced by a service agent in order to avoid a
hazard.
5-2-1：MOTOR
Wiring must be done in a manner that full voltage is available at the motor terminals during
startup. Use of an incorrect power source will result in premature motor failure and is not
covered by this compressor or motor manufacturer’s warranty.
5-2-2：PRESSURE SWITCH
The pressure switch acts as a pilot device activating the motor. The pressure switch cut
in/cut out has been preset at the factory, do not tamper with the settings. Never bypass or
remove this switch, as serious damage to equipment or personal injury could result from
improper pressure setting. Consult your local distributor or service center if the switch
malfunctions.
5-2-3：GROUNDING INSTRUCTIONS
Do not modify the plug that has been provided, if it does not fit the available outlet, the
correct outlet should be installed by a qualified electrician. The plug must be plugged into
an outlet that is properly installed and grounded in accordance with all local codes. If these
grounding instructions are not completely understood or if in doubt as to whether the
compressor is properly grounded, have the installation checked by a qualified electrician.
5-2-3-1：This product is for use on a nominal 240 volt circuit.
No adapter should be used with this product.
5-2-4：EXTENSION CORDS
The use of any extension cord will cause some drop in voltage and loss of power. For
optimum performance, plug the compressor power cord directly into a grounded wall
socket. Do not use an extension cord unless absolutely necessary. It is better to use a long
air hose to reach area where work is being performed. If use of an extension cord can not
be avoided, refer to the following guidelines ：
Make sure your extension cord is in good condition. Be sure quality is sufficient to carry
the current the unit will draw.
5-2-5：PUMP ROTATION
The compressor is to be wired in a manner that the rotation of the flywheel causes the air
to be blown over the pump. This allows the pump to cool properly.
6
