DCH-5100P Multi-Format Professional HDTV Processor
8
Pro Broadband Inc.
set in ‘CI Source’ previously. All free programs are marked with ‘Free’ in the first row.
To select which program to be de-encrypted, press the <> or < >-key to roll up and down
the program names and press <ENTER>-key to change the status of the corresponding
program (only encrypted program could be selected). Three different statuses could be set:
Slot 1 (de-encrypted with upper CAM inserted)
Slot 2 (de-encrypted with lower CAM inserted)
Bypass (no de-encryption).
The status will be shown in the first row on the LCD display. Confirm this setup when leaving
this sub menu, press <ENTER>-key to save or press <EXIT>-key to scrap.
The de-encrypted program could be delivered to other functional portions, like A/V
decoder, ASI1, ASI2, SDI, Mux and TS/IP output (refer to section 5.2.3~5.2.8 for more).
CAM name: under this sub menu, you can see the names of CAM modules.
5.2.3 Decoder
You can configure the parameters of Video and Audio of the program decoded by AV
decoder.
Status: OK or Alarms indicates the status of the decoder. You can use the <ENTER>-key to
check detailed information.
Source: Press the <ENTER>-key and use the < > or < >-key to roll up or down to select
the signal source of ASI output, there are 5 type of signal source optional:
CI De-encrypted: the de-encrypted transport stream from CI functional portion will
be delivered to the ASI output port on the back panel.
TUNER: the transport stream from Tuner will be delivered to the ASI output port on
the back panel.
ASI1 Input: the transport stream comes from ASI1 input port will be delivered to the
ASI1 output port on the back panel.
ASI2 Input: the transport stream comes from ASI2 input port will be delivered to the
ASI2 output port on the back panel.
Mux TS: the transport stream comes from built-in Mux will be delivered to the ASI
output port on the back panel.
(The Mux TS is valid only when the built-in Mux function is enabled and turned on.
Refer to section 5.2.7 and section 5.3.6 for how to set the built-in Mux.)
Press <ENTER>-key to save or press <EXIT>-key to scrap. A few seconds after the
source being selected, the TS will be delivered to the ASI output port on the back panel.
Program: under this sub menu, you will see all program names detected by DCH-5100P. The
programs could be coming from ASI input, Tuner, TS/IP input, the internal CI de-encryption
portion, BISS De-encryption portion or MUX TS. Use the < > or < >-key to roll up or down
