Pertech 220350A II
Federal Communications Commission (FCC) Radio
Frequency Interference Statement
Warning
Changes or modications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and , if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at
his own expense.
Information to the User
This equipment must be installed and used in strict accordance with the manufacturer’s instructions. However, there is no guarantee that interference of radio
communications will not occur in a particular commercial installation. If this equipment does cause interference, which can be determined by turning the equip-
ment off and on , the user is encouraged to contact Pertech immediately.
Pertech is not responsible for any radio or television interference caused by unauthorized modication of this equipment, or the substitution of attachment or con-
nection cables and equipment other than those specied by Pertech. The correction of interferences caused by such unauthorized modication, substitution or
attachment will be the responsibility of the user.
Important Information to the User
In order to ensure compliance with the Product Safety, FCC and additional agency markings requirements, you must use the power supply, power cord, and inter-
face cable which were shipped with this product.
Power Supply
(LPS) output for use in North America, input rated 100 - 240 Vac, .4 A, 50/60 Hz, Output rated 24Vdc, .625 A Maximum and 15W Maximum. Use of this product with
a power supply other than the approved Pertech power supply supplied will require you to test this power supply and the Pertech scanner for FCC and additional
agency mark certications. For more information check with your Pertech representative for current agency requirements.
Interface Cable
A shielded (360 degree) USB certied interface cable must be used with this product. The shield must be connected to the frame or earth ground reference at each
end of the cable.
Use of a cable other than the described here will require that you test this cable with the Pertech scanner and your system for FCC and USB mark certication.
Power cord
For North America a NRTL Recognized detachable power cord must be used. For applications where the power supply module may be located on the oor, a
power cord with Type SJT marking must be used.
For applications outside of North America, Power cords which meet the country of installation’s certication and application requirements must be used.
Use of a power cord other than described here may result in a violation of safety certications which are in force in the country of use.
Disclaimer
Information in this document is subject to change without notice. Consult your Pertech sales representative for information that is applicable and current. Pertech
reserves the right to improve products as new technology, components, software and rmware become available.
No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose with out the express written
permission of Pertech.
Industry Canada
This Class A digital apparatus complies with Industry Canada Standard ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 d’Industrie Canada.
Copyright
Copyright © 2007-2015 by Pertech.
Riverton, Wyoming USA
All rights reserved. Printed in USA. Condential,
Unpublished. Property of Pertech® Inc...
Trademarks
Pertech® is a trademark of Pertech. Other trademarks
and registered trademarks are the property of their respective holders.
Web site
http://www.pertechindustries.com/
