3. IDs are excluded. LED 0.5s On, 0.5s Off (Enter
auto inclusion)
Adding a node ID allocated by Z-Wave Controller means inclusion. Removing a node ID
allocated by Z-Wave Controller means exclusion.
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
LE Indication
To distinguish what mode the AN34 is in, view from the LED for identification.
State Type LE Indication
Motor
activate
No matter up or down, close or open, Led will flash every second
while Motor activate.
When S1 or S2 close to L, the LED will flash even when the motor
stop by itself, this is to let user know the S1 or S2 still close and not
been release yet.
No node ID Under normal operation, when the AN34 has not been allocated a
node ID, the LED flashes on and off alternately at 2-second intervals.
By pressing S1 S2 or Include button, it will stop flashing temporarily.
Learning When AN34 is in learning mode, LED flashes on and off
alternately and repeatedly at 0.5 second intervals.
Overload When overload state occurs, the AN34 is disabled and LED flashes
on and off alternately at 0.2 second intervals. AN34 will send
alarm_type=8 alarm_Level=0xFF to Group1, Overload state can be
cleared by disconnect and reconnect the AN34 to the main power
Choosing a Suitable Location
1. Do not locate the AN34 facing direct sunlight, humid or dusty place.
2. The suitable ambient temperature for the AN34 is 0°C~40°C.
3. Do not locate the AN34 where exists combustible substances or any source of
heat, e.g. fires, radiators, boiler etc.
4. After putting it into use, the body of AN34 will become a little bit hot of which
phenomenon is normal.
Moving Range Calibration
1. It is important to carry out a shutter calibration process before you control the
shutter to move. ress inclusion button over 3 seconds and release before the 6th
second, the roller shutter controller will start the shutter calibration process. The
process is composed of three continue stages. The shutter move to the TO in first
stage, and move to the BOTTOM in second stage, and move to the TO again in
third stage. Then AN34 will know the total range of U and DOWN.
2. During the shutter calibration process, any emergencies happen you can press
and release the include button to stop the process.
3. If user found the direction is reverse, this may cause by the wrong connection of
NC and NO to the motor, please exchange NC and NO connection and execute
calibration process again.
4. For safe issue, please select the motor which can stop by itself when go to bottom
end or top end.
Installation and operation
3
