Philips AVENT SCF358 Manuale utente
ZH-T 使用手冊 65
92 FA
106 AR
EN User manual 2
KO 사용 설명서 18
MS Manual pengguna 33
ZH-S 用户手册 50
SCF358
3ENGLISH
Important
Read this user manual carefully before you use the appliance and save it for future
reference.
Danger
- Do not immerse the cord, plug or appliance in water or
other liquid.
Warning
- Only use the appliance indoors.
- Do not let the power cord hang over the edge of a table
or worktop. Store excess cord in the base of the bottle
warmer.
- Keep the power cord away from hot surfaces.
- Only connect the appliance to a grounded wall socket.
Always make sure that the plug is inserted into the wall
socket properly.
- Before you connect the appliance, check that the voltage
indicated on the bottom of the appliance corresponds to
the local voltage .
- If you need to use an extension cord, make sure it is
a grounded extension cord with a rating of at least
13 amperes.
- Do not use the appliance if the plug, the power cord
or the appliance itself is damaged. If the power cord is
damaged, you must have it replaced by Philips, a Philips
authorized service centre or similarly qualied persons in
order to avoid a hazard.
- Do not place the appliance on or near a hot gas or
electric cooker, or in a heated oven.
- This appliance can be used by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved.
4ENGLISH
- This appliance can be used by children aged from
8 years and above if they have been given supervision or
instruction concerning use of the appliance in a safe way
and if they understand the hazards involved. Cleaning
and user maintenance shall not be made by children
unless they are older than 8 and supervised. Keep the
appliance and its cord out of reach of children aged less
than 8 years.
- Children must not play with the appliance.
- Do not spill water on the power plug.
- Only use the appliance as described in the user manual
to avoid injury due to misuse.
- Do not preheat the appliance.
- Always place a fully assembled bottle with cap in the
bottle warmer before you add water.
- Make sure you add water before you switch on the bottle
warmer.
- Hot water can cause serious burns. Be careful when the
bottle warmer contains hot water.
- The accessible surfaces of the appliance may become
hot during use and are subject to residual heat after use.
- Do not move the appliance when it contains hot water.
- When the food or milk has reached the required
temperature, remove the bottle or container from the
bottle warmer. If you leave food or milk in the bottle
warmer, the temperature of the food or milk increases.
Caution
- This appliance is intended for use in household and
similar applications such as farm houses, bed and
breakfast accommodations, sta kitchen areas in stores,
oces and other work environments, and by guests in
hotels, motels and other residential type environments.
- The food should not be heated for too long.
5ENGLISH
- Always check the food temperature before you feed
your child. Gently swirl the bottle and check by sprinkling
a few drops on the inside of your wrist. (Follow the
instructions in section ‘‘Feed your baby the milk’’.)
- Unplug the appliance when it is not in use.
- The surface of the heating element is subject to residual
heat after use.
- Let the appliance cool down before you clean it.
- Follow the descaling instructions to avoid irreparable
damage.
- Do not try to open or repair the appliance yourself.
Contact the Philips Consumer Care Centre in your
country (see www.philips.com/support).
The production date code YYWW is located in the cord storage compartment in the
base of the bottle warmer.
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable standards and regulations
regarding exposure to electromagnetic elds.
Introduction
Congratulations on your purchase and welcome to Philips Avent! To fully benet
from the support that Philips Avent oers, register your product at
www.philips.com/welcome.
With this bottle warmer, you can safely warm and defrost milk in Philips Avent and
other most common branded feeding bottles and baby food in containers.
To help preserve the quality of your breast milk, it is important to warm the milk
in a safe and controlled way. The built-in sensor tracks the temperature to avoid
overheating.
6ENGLISH
General description
Product overview
A
B
CD
F
E
A Bottle warmer D Keep warm / defrost setting
B Progress indicator E Milk volume setting
C Baby food warming setting F On / o button
7ENGLISH
Explanation of settings
Milk volume
• Select the milk volume you warm. You can set
from 30 ml / 1 oz up to 330 ml / 11 oz. The bottle
warmer warms the milk to approximately body
temperature. It then goes to keep warm mode
automatically for about 60 minutes.
Baby food warming
• Select this setting to warm baby food.
Keep warm / defrost
• The built-in sensor detects the milk / baby
food temperature to switch to the optimal
setting. If the milk / baby food is warm, it will
be warmed gradually and kept at the right
temperature. If the milk / baby food is frozen,
it will be defrosted to liquid state and then
warmed to the right temperature.
When the entire progress indicator is on but not ashing, the milk / food is ready
for feeding. Feed your baby when the milk / food is warmed. Do not rewarm the
milk / food after it has cooled down, as bacteria may start to develop in it.
Warm milk
1 Place the bottle in the bottle warmer. Fill with drinking water to the level of
the milk. If you have a large volume of milk, ll with water to approximately
1 cm below the top of the bottle warmer.
2 Select the desired setting based on the milk volume and press the on / o
button to switch on.
7
210
7oz
210ml
8ENGLISH
3 The progress indicator ashes gradually to show the progress of milk
warming.
4 When the entire progress indicator lights up continuously, the milk is ready
for feeding and the bottle warmer automatically switches to keep warm
mode.
5 The bottle warmer switches o automatically after about 60 minutes,
including warming time. The progress indicator turns o.
60 min
Tip
• If you want the milk warmer, keep the bottle in the appliance until it reaches the desired
temperature after the entire progress indicator lights up.
• If you are using a milk bag, select the keep warm / defrost setting because it takes less
power to warm milk bags.
• If you are using a silicone bottle, it takes longer time to warm milk. Keep it in the bottle
warmer for 3-4 minutes after the entire progress indicator lights up.
Recommended setting for dierent containers
Container Recommended Setting
Plastic Milk volume setting
Glass Milk volume setting
Silicone Milk volume setting + 3-4 minutes
Milk bag Keep warm/ Defrost setting
Check the instructions of your milk bag and make sure it can be warmed in a bottle
warmer.
9ENGLISH
Note
• The time to warm milk depends on the volume, initial temperature and milk bottle
material.
Feed your baby the milk
Press the on / o button to switch o the appliance and take out the milk bottle.
Note
• If you are using a small milk bottle, such as a 2 oz milk bottle, be careful of the hot water
when you take out the bottle.
Always check the temperature of the milk before you feed your baby. Gently swirl
the bottle and check by sprinkling a few drops on the inside of your wrist.
Reuse the bottle warmer right away for another bottle
If you want to warm another bottle, let the bottle warmer cool down for a few
minutes. To speed up, ll the bottle warmer with fresh cold water.
When you switch on the bottle warmer, the progress indicator ashes gradually to
indicate that the appliance is warming again.
Note
• If the progress indicator is on but not ashing, the bottle warmer is still too hot to warm
another bottle. Switch o the bottle warmer and let it cool down for a few minutes.
10 ENGLISH
Warm baby food
1 Place the baby food container in the bottle warmer. Fill with drinking water
to the level of the baby food. If you have a large volume of baby food, ll with
water to approximately 1 cm below the top of the bottle warmer.
2 Select the baby food warming setting and press the on / o button to switch
on.
3 The progress indicator ashes to show it is in the warming process.
Note
• Due to variations in baby food consistency, it is not possible for the appliance to detect
precisely how long the baby food should be warmed.
4 Stir the baby food while the jar or container is in the bottle warmer. For
optimal result, check its temperature while it is warming up.
» Be careful not to burn your ngers when holding the container or jar while
stirring.
5 When the entire progress indicator lights up continuously, the baby food
is ready for feeding and the bottle warmer automatically switches to keep
warm mode.
Altri manuali per AVENT SCF358
6
Indice
Lingue:
Altri manuali Philips Scalda biberon
Philips
Philips SCF256 Manuale utente
Philips
Philips AVENT scf356 Manuale utente
Philips
Philips AVENT SCF355/07 Manuale utente
Philips
Philips SCF355 Manuale utente
Philips
Philips AVENT SCF355/02 Manuale utente
Philips
Philips SBCSC215/87 Manuale utente
Philips
Philips AVENT scf356 Manuale utente
Philips
Philips SCF355/05 Manuale utente
Philips
Philips SCF355 Manuale utente
Philips
Philips AVENT SCF358 Manuale utente
Philips
Philips AVENT SCF355/00 Manuale utente
Philips
Philips SBC SC205 Manuale utente
Philips
Philips SCF 215 Manuale utente
Philips
Philips SCF287 Manuale utente
Philips
Philips SCF355/04 Manuale utente
Philips
Philips SCF355 Manuale utente
Philips
Philips SCF355 Manuale utente
Philips
Philips AVENT scf356 Manuale utente
Philips
Philips AVENT scf356 Manuale utente
Philips
Philips SCF355 Manuale utente
