Philips AJ3110/12 Manuale utente
Clock Radio AJ3110
User manual
Manuel d'utilisation
Gebruikershandleidingen
R
E
P
E
A
T
A
L
A
R
M
/
S
L
E
E
P
O
F
F
R
E
P
E
A
T
A
L
A
R
M
/
S
L
E
E
P
O
F
F
7
8
9
!
0
@
1
2
3
4
5
6
#
$
%
Important notes for users in the U.K.
Mains plug
This apparatus is fitted with an approved 13 Amp plug. To change a fuse
in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI
approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut
off and an appropriate plug fitted in its place. If the mains plug con-
tains a fuse, this should have a value of 3 Amp. If a plug without a
fuse is used, the fuse at the distribution board should not be greater
than 3 Amp.
Note: The severed plug must be disposed of to avoid a possible shock
hazard should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue
= neutral (N), brown = live (L). As these colours may not correspond
with the colour markings identifying the terminals in your plug, pro-
ceed as follows: (To continue on the next page)
• Connect the blue wire to the terminal marked N or coloured
black.
• Connect the brown wire to the terminal marked L or coloured red.
• Do not connect either wire to the earth terminal in the plug,
marked E (or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. See Copyright
Act 1956 and The Performer’s Protection Acts 1958 to 1972.
ENVIROMENTAL INFORMATION
All unnecessary packaging material has been omitted. The packaging can
be easily separated into three materials: cardboard, polystyrene and
plastic.
Your set consists of materials which can be recycled if disas-
sembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging, dead batteries
and old equipment.
Disposal of your old product
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a
product it means the product is covered by the European
Directive 2002/96/EC.
Please inform yourself about the local separate collection sys-
tem for electrical and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste. The correct disposal of your
old product will help prevent potential negative consequences for the
environment and human health.
English
CONTROLS
1SET TIME - sets the clock time
2SLEEP -
activates the radio for sleep function
3ALARM SET/OFF -
sets the alarm time
- stops the active alarm for 24 hours
4ALARM indicator -
lights up when alarm is activated
5DISPLAY - shows the clock/ alarm time and status of the set
6Frequency indicator - shows the radio frequency of your selected waveband
7HOUR/MINUTE -
adjusts the hours/minutes for the clock and alarm time
8REPEAT ALARM/SLEEP OFF
- switches off the active alarm for a 8-9 minute period
- switches off the radio sleep function
9VOLUME - adjusts the sound level
0BAND - selects FM/AM waveband
!TUNING - tunes to radio stations
@RADIO/ALARM
–RADIO
ON switches on the radio
–
OFF switches off the radio/alarm
–ALARM -
RADIO activates the radio for alarm
–ALARM -
BUZZER activates the buzzer for alarm
#Battery door -
opens to store a 9 volt 6F22 type battery (not included) for
clock memory backup
$Power cord -
connects to wall outlet
%Pigtail -
FM antenna to improve FM reception
CAUTION
Use of controls or adjustments or performance of procedures other than
herein may result in unsafe operation.
This set complies with the radio interference requirements of the
European Community.
INSTALLATION
POWER SUPPLY
1
Check if the power supply, as shown on the type plate located on the bot-
tom of the set, corresponds to your local power supply. If it does not, consult
your dealer or service center.
2
Connect the power cord to the wall outlet.
3
To disconnect the set from the power supply completely, remove the
plug from the wall outlet.
CLOCK MEMORY BACKUP
The clock memory backup allows your alarm and clock time settings to be stored
for up to a day when there is a power interruption e.g. power failure. The com-
plete clock radio and display illumination will be switched off. As soon as the
power supply returns, the display will indicate the correct time.
1
Remove the battery door to insert a 9 volt 6F22 type battery (not included) for
backup.
2
Replace the battery door.
NOTE:
If no backup battery is installed or the power interruption is prolonged, you
will need to set the clock and alarm time again.
For users in the U.K., please follow the boxed instructions ‘Important
notes...’ on this sheet.
Batteries contain chemical substances, so they should be disposed
of properly.
Standby power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1W
RADIO
You can use this set solely as a radio!
1
Adjust RADIO/ALARM to
RADIO
ON to switch on the radio.
2
Select your waveband by adjusting the BAND switch
.
3
Adjust TUNING to tune to your desired station
.
4
Turn the VOLUME control to adjust the volume level
.
5
Adjust RADIO/ALARM to OFF to switch off the radio.
To improve reception:
FM:
Extend and position the pigtail fully to obtain optimal reception.
MW:
Uses a built-in antenna inside the set. Direct the antenna by adjusting
the position of your set
.
SETTING THE CLOCK AND ALARM TIME
The time is displayed using the 24-hour clock.
1
Press and hold SET TIME or ALARM SET/OFF.
2
Press HOUR or MINUTE repeatedly, or hold down on the respective button to
adjust the hours and minutes.
3
Release SET TIME or ALARM SET/OFF, and HOUR/MINUTE when you
reach the correct setting.
™
The set clock time will show on the display and start to run.
SELECTING THE ALARM MODE
GENERAL
If you wish to use the alarm, you must set the alarm time first. You can choose
from two different alarm modes to wake you up: by radio or buzzer.
•
Select your choice of alarm mode by adjusting RADIO/ALARM to
ALARM -
RADIO or
ALARM -
BUZZER.
™
The Alarm indicator lights up.
Helpful hints:
•
If you have selected the radio mode, make sure you have adjusted the
volume loud enough to wake you.
•
The buzzer is set at a fixed volume and cannot be adjusted.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24 hour alarm reset option will be automatically selected after
1 hour and 59 minutes, from the time your alarm time first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain the
same alarm setting for the following day:
•
Press ALARM SET/OFF during the alarm call.
™
The Alarm indicator remains on.
CANCELING THE ALARM COMPLETELY
To cancel the set alarm time before it goes off, or during the alarm call:
•
Adjust RADIO/ALARM to OFF position.
™
The Alarm indicator turns off.
REPEAT ALARM
This repeats your alarm call at 8-9-minute intervals.
1
During the alarm call, press
REPEAT ALARM/SLEEP OFF
.
2
Repeat if desired for up to 1 hour and 59 minutes. To deactivate it, press
ALARM SET/OFF, or adjust RADIO/ALARM to OFF position.
SLEEP
About Sleep
This set has a built-in timer which enables the set to be automatically switched
off during radio playback after a set period of 1 hour and 59 minutes. This allows
you to lie back, listen and fall asleep. The maximum sleep time is 1 hour and 59
minutes.
Setting SLEEP
1
Set RADIO/ALARM to OFF position.
2Set the sleep time to activate the sleep function by selecting one of the following
ways:
•
Simply press SLEEP to set your sleep time to 59 mintues.
• Hold down SLEEP, then press MINUTE repeatedly to adjust sleep time from 59
minutes downward.
• Hold down SLEEP and press HOUR to get one more hour sleep time (1:59 hours).
™
To cancel sleep, press
REPEAT ALARM/SLEEP OFF
.
SAFETY & MAINTENANCE
•
Install the unit near the AC outlet and where the AC power plug can be easily
reached.
•
The apparatus shall not be exposed to dripping or splashing.
•
If you do not intend to use the set for a long time, withdraw the power plug
from the wall outlet. In addition to this, it is advisable to remove the battery
from the clock radio. This will prevent any danger of leakage and the clock
radio will not be damaged.
•
Do not expose the set to humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
•
To clean the set, use a soft, slightly dampened chamois leather. Do not use
any cleaning agents containing alcohol, ammonia, benzene or abrasives as
these may harm the housing.
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Philips Radiosveglia
Philips
Philips AJ3123 Manuale utente
Philips
Philips AJ3115/96 Manuale utente
Philips
Philips AJL308/17 Manuale utente
Philips
Philips AJ 3010 Manuale utente
Philips
Philips AJ100/37B Manuale utente
Philips
Philips AJ3936/00 Manuale utente
Philips
Philips AJ3916/79 Manuale utente
Philips
Philips AJM180 Manuale utente
Philips
Philips AJ3916 Series Manuale utente
Philips
Philips AJ3650/12 Manuale utente
Philips
Philips AJ3123 Manuale utente
Philips
Philips AJ3122 Manuale utente
Philips
Philips AJ3510 Manuale utente
Philips
Philips 7000 series Manuale utente
Philips
Philips AJ 3936 Manuale utente
Philips
Philips AJ-3950 Manuale utente
Philips
Philips AJB4300 Manuale utente
Philips
Philips AJ7030D/12 Manuale utente
Philips
Philips R7606 Manuale utente
Philips
Philips D3630 Manuale utente
