Philips HQ7617 Manuale utente

ENGLISH 4

FRANÇAIS 13

ESPAÑOL 23

PORTUGUÊS 33

HQ7617, HQ7615

á«Hô©dG

Warning

Please read these instructions before using the

appliance.

◗Only use the HQ800 powerplug supplied to

charge the appliance.

◗The HQ800 powerplug transforms 100-240

volts to 12 volts. Only use the powerplug that

comes with the appliance to guarantee safe

transformation.

C◗Make sure the HQ800 powerplug does not

get wet.

C◗The shaver runs at a safe low voltage of 12

volts. It is watertight and can be cleaned

under the tap. Do not rinse with water hotter

than 80cC.

Charge indications

C◗Charging

As soon as you start charging the empty shaver,

the green pilot light will go on.

A fully charged shaver has a cordless shaving time

of up to 45 minutes.

Charging

Recharge, store and use the appliance at a

temperature between 5cC and 35cC.

The powerplug is suitable for mains voltages

ranging from 100 to 240V.

ENGLISH4

You cannot use the shaver when it is charging,

because the appliance does not work while its

batteries are being charged.

Do not leave the shaver connected to the mains

continuously.

C1Put the appliance plug in the shaver.

2Put the powerplug in the wall socket.

Do not recharge the shaver in a closed pouch.

3When charging for the first time or after a

long period of disuse: leave the shaver to

charge continuously for 12 hours.

Charging normally takes approx. 8 hours.

A fully charged shaver has a cordless shaving time

of up to 45 minutes.

4Remove the powerplug from the socket

and pull the appliance plug out of the

shaver when the batteries have been fully

charged.

Shaving

1Switch the shaver on by pressing the on/off

button once.

C2Move the shaving heads quickly over your

skin, making both straight and circular

movements.

Shaving on a dry face gives the best results.

ENGLISH 5

Your skin may need 2 or 3 weeks to get

accustomed to the Philishave system.

3Switch the shaver off by pressing the on/off

button once.

C4Put the protection cap on the shaver every

time you have used it, to prevent damage.

Replace the shaving heads (type HQ6 Quadra)

every 2 years for optimal shaving results.

Trimming

For grooming sideburns and moustache.

C1Open the trimmer by pushing the slide

upwards.

The trimmer can be activated while the motor is

running.

Cleaning

Regular cleaning guarantees better shaving

performance.

The easiest and most hygienic way to clean the

appliance is to rinse the shaving unit and the hair

chamber every day with hot water (60cC-80cC).

When you clean the appliance, it is not necessary

to take the shaving heads (cutters and guards)

apart. If you want to take them apart, be sure not

to mix up the cutters and guards, since grinding of

the cutters in the guards only guarantees optimal

performance for each matching set. If you

ENGLISH6

accidentally mix up the sets, it could take several

weeks before optimal shaving performance is

restored.

Every day: shaving unit

1Switch the shaver off, remove the

powerplug from the wall socket and pull

the appliance plug out of the shaver.

C2Press the release button (1) and open the

shaving unit (2).

C3Clean the shaving unit and the hair

chamber by rinsing them under a hot tap

(60cC-80cC) for some time.

4Close the shaving unit and shake off excess

water.

Never dry the shaving unit with a towel or tissue

as this may damage the shaving heads.

C5Open the shaving unit again and leave it

open to let the appliance dry completely.

You can also clean the hair chamber without

water by using the brush supplied.

Trimmer

Clean the trimmer every time you have used it.

1Switch the shaver off, remove the

powerplug from the wall socket and pull

the appliance plug out of the shaver.

ENGLISH 7

C2Clean the trimmer with the brush

supplied.

C3Lubricate the trimmer teeth with a drop

of sewing machine oil every six months.

Replacing the shaving heads

Replace the shaving heads every two years for

optimal shaving results.

1Switch the shaver off, remove the

powerplug from the socket and pull the

appliance plug out of the shaver.

C2Press the release button (1) to open the

shaving unit (2).

C3Turn the wheel anti-clockwise (1) and

remove the retaining frame (2).

C4Remove the shaving heads and place the

new ones in the shaving unit in such a way

that the parts with the small holes point

towards the centre of the shaving unit.

ENGLISH8

Make sure that the projections of the shaving

heads fit exactly into the recesses.

C5Reassemble the shaving unit by replacing

the retaining frame. Press the wheel (1)

and turn it clockwise (2).

Replace damaged or worn shaving heads with

Philishave HQ6 Quadra shaving heads only.

Storing

C◗Put the protection cap on the shaver to

prevent damage.

◗The appliance can be stored in the pouch

supplied.

Disposal of batteries

The built-in rechargeable batteries contain

substances that may pollute the environment.

Remove the batteries when you discard the

shaver. Do not throw the batteries away with the

normal household waste, but hand them in at an

official collection point.You can also take the

batteries to a Philips Service Centre, which will

dispose of them in an environmentally safe way.

Only remove the batteries if they are completely

empty.

ENGLISH 9

1Remove the powerplug from the socket

and pull the appliance plug out of the

shaver.

C2Let the shaver run until it stops, open the

trimmer, undo the screws and open the

shaver.

3Remove the batteries.

Do not connect the shaver to the mains again

after the batteries have been removed.

Troubleshooting

1Reduced shaving performance

BCause 1: the shaving heads are dirty.

BThe shaver has not been rinsed long enough or

the water used was not hot enough.

◗Clean the shaver thoroughly before you

continue shaving (see 'Cleaning').

BCause 2: long hairs are obstructing the shaving

heads.

C◗Turn the wheel anti-clockwise (1) and remove

the retaining frame (2).

C◗Clean the cutters and guards.

Do not clean more than one cutter and guard at

a time, since they are all matching sets. If you

accidentally mix up the cutters and guards, it may

ENGLISH10

take several weeks before optimal shaving

performance is restored.

◗Remove the hairs with the brush supplied.

◗Put the retaining plate back onto the shaving

unit.

BCause 3: shaving heads are damaged or worn.

◗Remove the retaining frame.

◗Remove the old shaving heads from the

shaving unit and replace them with new ones

Damaged or worn shaving heads (cutters and

guards) must only be replaced with the original

Philishave HQ6 Quadra shaving heads.

◗Put the retaining plate back onto the shaving

unit.

2The shaver does not work when the

ON/OFF button is pressed

BCause: the batteries are empty.

◗Recharge the batteries.

3Shaving unit has come off shaver

C◗If the shaving unit becomes detached from the

shaver, check whether the hinge spring is still

properly attached, i.e. has not come loose and

does not show any cracks or damage. If the

hinge spring is still properly attached, the

ENGLISH 11

shaving unit can be easily put back on the

shaver again. However, if the hinge spring has

come loose, is cracked or damaged, please

contact your Philips dealer or the nearest

Philips service centre to avoid damage to your

shaver.

Accessories

The following accessories are available:

- HQ6 Quadra Philishave Shaving Heads.

- HQ8000 powerplug.

- HQ100 Philishave Action Clean (shaving head

cleaner).

- HQ101 Philishave Action Refill (shaving head

cleaning liquid).

- HQ110 Philishave Head Cleaner (shaving head

cleaning spray).

Information & service

If you need information or if you have a problem,

please visit the Philips Web site at

www.philips.com or contact the Philips Customer

Care Centre in your country (you will find its

phone number in the worldwide guarantee

leaflet). If there is no Customer Care Centre in

your country, turn to your local Philips dealer or

contact the Service Department of Philips

Domestic Appliances and Personal Care BV.

◗Keep these instructions for use for future

reference.

ENGLISH12

Questo manuale è adatto per i seguenti modelli

Indice

Lingue:

Altri manuali Philips Rasoio elettrico

Philips

Philips HQ8160 Manuale utente

Philips

Philips HQ7762/16 Manuale utente

Philips

Philips S7000 series Guida all'installazione

Philips

Philips QP2520/60 Manuale utente

Philips

Philips HQG267 Manuale utente

Philips

Philips HQ6853/16 Manuale utente

Philips

Philips PQ208 Manuale utente

Philips

Philips Easy Shave HQ6849 Manuale utente

Philips

Philips BT720x series Manuale utente

Philips

Philips NORELCO BT5210 Manuale utente

Philips

Philips QP6520 Manuale utente

Philips

Philips RQ 1060 Manuale utente

Philips

Philips S7000 series Manuale utente

Philips

Philips Norelco HS8420 Manuale utente

Philips

Philips QG3340 Manuale utente

Philips

Philips Norelco S7370 Manuale utente

Philips

Philips 8846XL Manuale utente

Philips

Philips HQ7300 Manuale utente

Philips

Philips QG3380 Manuale utente

Philips

Philips MicroAction 4852XL Manuale utente

Philips

Philips QuadraAction 7825XL Manuale utente

Philips

Philips HQ4441, HQ4421, HQ4411, HQ4407, HQ4406,... Manuale utente

Philips

Philips AquaTouch AT750 Manuale utente

Philips

Philips RQ1160/21 Manuale utente

Manuali Rasoio elettrico popolari di altre marche

Norelco

Norelco Quadra 7610X Manuale utente

Braun

Braun WaterFlex WF2s Manuale utente

Daga

Daga MT-400 Manuale

Remington

Remington BHT100 Manuale utente

Kompernass

Kompernass KH 5537 Manuale utente

Remington

Remington BHT6100 Manuale utente

MIA

MIA Aqua Body Manuale utente

Matheo

Matheo MLR 15 Manuale utente

CTC Union

CTC Union Clatronic HSM 3441 NE Manuale utente

Remington

Remington XR7000 Manuale utente

Eldom

Eldom G47 Manuale utente

Braun

Braun silk-epil 5 Manuale utente

SEVERIN

SEVERIN SÉRIE E700 0533 Guida utente

Remington

Remington PR1355 Manuale utente

Aurora

Aurora AU 3543 Manuale utente

Braun

Braun InterFace 3614 Manuale utente

Wahl

Wahl 8061 5-STAR Manuale utente

Norelco

Norelco 4404LC Manuale utente