Philips PET710 Manuale utente
DVD Portable Player PET710/00/05/55/75/37/94
3141 785 30442
Version 1.2
TABLE OF CONTENTS
Chapter
Technical Specification…………………………………………1
Safety Instructions.……………………………………………...2
Instruction for Use.……………………………………………...3
Mechanical Instructions………………………………………..4
Troubleshooting & Service tips……………………………….5
Overall block diagram………………………….………...…... 6
Overall wiring diagram… ……………………………………… 7
Electrical diagram……………………………………………….8
Component layout……………………………………………… 9
Service part list………………………………………………….10
Revision list………………………………………………………11
Service Manual
Copyright 2005 Philips Consumer Electronics B.V. Eindhoven, The Netherlands
All rights reserved. No part of this publication may by reproduced, stored in a
retrieval system or transmitted, in any form or by any means, electronics,
mechanical, photocopying, or otherwise without the prior permission of Philips
1.0TECHNICAL SPECIFICATION
General
Dimensions (WxLxH) : 19.3 x 16.1 x 3.0 cm
7.72 x 6.44 x 1.2 inches
Weight : 0.824 kg / 1.81 lb
Power supply : DC 9V 2.2A
Power consumption : ≤ 20W
Operating temp. range : 0 - 50°C (32 ~ 122°F)
Laser wavelength: 650nm
Video system : /17 versions: NTSC
non /17 versions: NTSC / PAL /
AUTO
Frequency response : 20Hz ~ 20KHz ± 1dB
Signal/noise ratio ≥85dB
Audio distortion + noise ≤ 80(1KHz)
Channel separation: ≥85dB
Dynamic range
≥80dB
Output
Audio out (analog audio)
Output level: 2V ± 10%
Load impedance:
10KΩ
Video out Output level:
1Vp - p ± 20%
Load impedance:
75Ω
Current consumption
DC-IN SUPPLY (9.0V)
Battery Charging Current 1.2A typ.
BATT. SUPPLY (7.2V)
Power Off 0A
Playback with TFT on <1.2A typ.
Playback without TFT on <600mA
Battery playtime >2.5hrs
Headphone out (headphone output load 2x16 ohm)
Maximum output power : >10mW
Frequency response : 20Hz - 20kHz
SNR (A-wght) : 80dB typ.
THD (1kHz) : <1%
Left-Right Channel
Separation :
32dB typ.
Left-Right Channel
Balance :
1dB
Supported disc type
DVD video discs:
Video CD:
Audio CD :
In addition, this unit can play DVD+R & DVD+RW and CD-R &
CD-RW that contains audio titles or MP3 or JPEG files.
You cannot play disc other than the above listed.
(CVD, CD-ROM, CD-Extra, CD-G and CD-I discs cannot be
played on this DVD player)
Software upgrades
For the best performance of your DVD Portable. Check
www.philips.com/support for latest software
upgrades available.
To check the software version of your DVD Portable.
1. Press the SETUP key to enter the setup menu.
2. Press RETURN and then press 1, 2 and 3 on the
remote control.
3. The display will show the software version as the
date of which the software was built on the bottom
of the screen. E.g. 050303
Procedure on how to upgrade the software of the DVD
Portable
1. Download the latest software from the Philips
support site.
2. Unzipped the files and then burn it onto a CD ROM
then playback the CD ROM on the DVD Portable.
Pixel specification
<= 3 (max. 0 bright dots and 3 dark dots)
2.0 SAFETY INSTRUCTIONS
GB
WARNING
All ICs and many other semi-conductors are
susceptible to electrostatic discharges (ESD).
Careless handling during repair can reduce life
drastically.
When repairing, make sure that you are
connected with the same potential as the mass
of the set via a wrist wrap with resistance.
Keep components and tools also at this
potential.
F
ATTENTION
Tous les IC et beaucoup d’autres
semi-conducteurs sont sensibles aux
décharges statiques (ESD).
Leur longévité pourrait être considérablement
écourtée par le fait qu’aucune précaution n’est
prise à leur manipulation.
Lors de réparations, s’assurer de bien être relié
au même potentiel que la masse de l’appareil et
enfiler le bracelet serti d’une résistance de
sécurité.
Veiller à ce que les composants ainsi que les
outils que l’on utilise soient également à ce
potentiel.
ESD
D
WARNUNG
Alle ICs und viele andere Halbleiter sind
empfindlich gegenüber elektrostatischen
Entladungen (ESD).
Unsorgfältige Behandlung im Reparaturfall kan
die Lebensdauer drastisch reduzieren.
Veranlassen Sie, dass Sie im Reparaturfall über
ein Pulsarmband mit Widerstand verbunden
sind mit dem gleichen Potential wie die Masse
des Gerätes.
Bauteile und Hilfsmittel auch auf dieses gleiche
Potential halten.
NL
WAARSCHUWING
Alle IC’s en vele andere halfgeleiders zijn
gevoelig voor electrostatische ontladingen
(ESD).
Onzorgvuldig behandelen tijdens reparatie kan
de levensduur drastisch doen verminderen.
Zorg ervoor dat u tijdens reparatie via een
polsband met weerstand verbonden bent met
hetzelfde potentiaal als de massa van het
apparaat.
Houd componenten en hulpmiddelen ook op
ditzelfde potentiaal.
I
AVVERTIMENTO
Tutti IC e parecchi semi-conduttori sono
sensibili alle scariche statiche (ESD).
La loro longevità potrebbe essere fortemente
ridatta in caso di non osservazione della più
grande cauzione alla loro manipolazione.
Durante le riparazioni occorre quindi essere
collegato allo stesso potenziale che quello della
massa dell’apparecchio tramite un braccialetto
a resistenza.
Assicurarsi che i componenti e anche gli utensili
con quali si lavora siano anche a questo
potenziale.
“Pour votre sécurité, ces documents
doivent être utilisés par des spécia-
listes agréés, seuls habilités à réparer
votre appareil en panne”.
GB
Safety regulations require that the set be restored to its original
condition and that parts which are identical with those specified,
be used.
NL
Veiligheidsbepalingen vereisen, dat het apparaat bij reparatie in
zijn oorspronkelijke toestand wordt teruggebracht en dat onderdelen,
identiek aan de gespecificeerde, worden toegepast.
F
Les normes de sécurité exigent que l’appareil soit remis à l’état
d’origine et que soient utiliséés les piéces de rechange identiques
à celles spécifiées.
D
Bei jeder Reparatur sind die geltenden Sicherheitsvorschriften zu
beachten. Der Original zustand des Geräts darf nicht verändert werden;
für Reparaturen sind Original-Ersatzteile zu verwenden.
I
Le norme di sicurezza esigono che l’apparecchio venga rimesso
nelle condizioni originali e che siano utilizzati i pezzi di ricambio
identici a quelli specificati.
"After servicing and before returning set to customer perform a
leakage current measurement test from all exposed metal parts to
earth ground to assure no shock hazard exist. The leakage current
must not exceed 0.5mA."
CLASS 1
LASER PRODUCT
3122 110 03420
GB
Warning !
Invisible laser radiation when open.
Avoid direct exposure to beam.
S
Varning !
Osynlig laserstrålning när apparaten är öppnad och spärren
är urkopplad. Betrakta ej strålen.
SF
Varoitus !
Avatussa laitteessa ja suojalukituksen ohitettaessa olet alttiina
näkymättömälle laserisäteilylle. Älä katso säteeseen!
DK Advarse !
Usynlig laserstråling ved åbning når sikkerhedsafbrydere er
ude af funktion. Undgå udsaettelse for stråling.
Whenthepowersupplyisbeingturnedon,youmaynotremovethislasercautionslabel.Ifitremoves,radiationoflaser
maybereceived.
2.1 ESD PROTECTION
PREPARATIONOFSERVICING
PickupHeadconsistsofalaserdiodethatisverysusceptibletoexternalstaticelectrocity.
Althoughitoperatesproperlyafterreplacement,ifitwassubjecttoelectrostaticdischargeduringreplacement,
itslifemightbeshortened.Whenreplacing,useaconductivemat,solderingironwithgroundwire,etc.to
protectthelaserdiodeformdamagebystaticelectricity.
Andalso,theLSIandICaresameasabove.
Solderingiron
withgroundwire
orceramictype
Groundconductive
wriststrapforbody.
Conductivemat
Thegroundresistance
betweenthegroundline
andthegroundislessthan10
1M
English
CAUTION
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
13,4,1,2
Up / down / left / right cursor
OK
Confirms selection
2MENU
Displays MENU page
MONITOR
Selects display mode
OSD
On Screen Display on / off
SOUND
Virtual surround sound on / off
3;
Pauses playback
2
Starts / resumes playback
9
Press twice to stop playback
J( / §
For previous (J( ) or next (§)
chapters, tracks or titles
5/ 6
Search backward (5 ) or search
forward (6)
4TV ON
TV on indicator
50OPEN
Opens disc door to insert or
remove disc
6POWER/CHG
Power and charging indicator
REMOTE
Remote sensor
7ON .POWER .OFF
Switches the player on / off
8VOLUME F
Volume control
9PHONES 1 & 2
Headphones jack
0AUDIO OUT
Audio output jack
!VIDEO OUT
Video output jack
@COAXIAL
Digital audio output jack (coaxial)
#DC IN 9V
Power supply socket
3.0 INSTRUCTION FOR USE
PET710_ENG.QXD 2/3/05 10:05 Page 2
English
Left of player
Right of player
Main unit controls
Front of player
PET710_ENG.QXD 2/3/05 10:05 Page 3
English
13,4,1,2
Up / down / left / right cursor
OK
Confirms selection
2VOL++ // −−
Volume control
3J( / §
For previous (J( ) or next (§)
chapters, tracks or titles
;
Pauses playback
2
Starts / resumes playback
9
Press twice to stop playback
5/ 6
Search backward (5 ) or search
forward (6)
4OSD
On Screen Display on / off
.
Slow motion
5AUDIO
Audio langauge selector
ZOOM
Enlarges video image
6A > B
To repeat or loop a sequence
in a title
PLAY-MODE
Selects play order options
70 - 9
Numeric keypad
8MUTE
Muting player volume
REPEAT
Repeats chapter / title / disc
9RETURN
For VCD menu page
ANGLE
Selects DVD camera angle
0SUBTITLE
Subtitle language selector
LANGUAGE
Language selector
!MENU
Displays MENU page
@SETUP
Enters SETUP menu
Remote Control
PET710_ENG.QXD 2/3/05 10:05 Page 4
English
PET710_ENG.QXD 2/3/05 10:05 Page 5
4.0 MECHANICAL INSTRUCTIONS
Fig.2
Fig.1
13 screws
soldered
1. Back View as Fig.1
Remove 13 screws to disassemble the base as Fig.2
2. Soldered short pattern for laser diode as Fig.3
3.
Fig.3
Remove DVD driver and main board as Fig.4,5
Disconnect DVD driver and main board
Fig.4
Disconnect
4. Remove key board and other parts as Fig.6
Fig.6
5. Remove top cover as Fig.7,8
Fig.5
Remove DVD driver and main board
Disconnect
Fig.7
Fig.8
3 screws
6. Remove IF board shield as Fig.9
7.
Fig.9
Remove IF board as Fig.10
Disconnect IF board as Fig.10
Fig.10
disconnect
9. Remove LCD and HV board as Fig.12
Fig.12
Fig.11
Remove 5 screws to disassemble LCD shield as Fig.11
5 screws
8.
5.0 TROUBLESHOOTING & SERVICE TIPS
5.1 Procedure to change region code
1. Power on player and open DVD Door.
2. Press <Set Up> at Remote Control. In <Set Up Menu> select <Preferences>.
3. For PET710 – Press successively 2 5 2 3 1 5. ▼.
4. Display will show <Region Code 2> for Europe;
5. Press key to input preference region code (see below table).
6. Switch off and re-switch on the product.
7. Verify Region code change done.
Region Code Region
1 USA
2 EUROPE
3 ASIA PACIFIC
4 AUSTRALIA,
NEW ZEALAND,
LATAM
5 RUSSIA, INDIA
6 CHINA
REMARKS:
1. Password is CONFIDENTIAL.
2. Region code is printed on product type plate. Due to DVD legislation region codes different to
assigned region may not be released.
Altri manuali per PET710
4
Questo manuale è adatto per i seguenti modelli
12
Indice
Altri manuali Philips Altro
Philips
Philips CR2025/00B Manuale utente
Philips
Philips FC6409 Manuale operativo
Philips
Philips CD80R431 Manuale utente
Philips
Philips HR2342 Manuale utente
Philips
Philips 47PFL5604H - annexe 2 Manuale utente
Philips
Philips VisaPure Advanced SC53XX Series Manuale utente
Philips
Philips CKA5720 Manuale utente
Philips
Philips CKW7740N Manuale utente
Philips
Philips HR2370 Manuale utente
Philips
Philips D2999 Manuale utente
