Philips Streamium WAC5 Guida rapida
1. Introduction
The Firmware Upgrade will upgrade WAC5 & WACS5’s firmware to Version
1.2.10.
__________________________________________________________________
2. Key features added
The software release 1.2.10 has provided a solution for CD ejection problem that
has happened on a marginal number of CDs.
__________________________________________________________________
3. Preparation
i) Verifying firmware version
Before upgrading, check the firmware version.
1. Turn on your WAC5 Center
2. Press MENU.
3. Press ▲/▼to select “Information”. Press OK.
4. Press ▲/▼to select “System”. Press OK.
→The display shows the FW (firmware) version number
→Upgrading is necessary if the FW version is an earlier one
Note: The firmware information is also useful when you call Philips Customer
Care Center.
ii) Checking Wi-Fi connection
Wi-Fi connection between Center and Station:
- Check you have pressed STANDBY-ON to turn on WAC5 Center and
WAS5 Station
- On Station, check you can playback tracks in HD mode
- On Station, check the signal indication shows maximum reception
Wi-Fi connection with the Wireless router/Access Point (if applicable):
- Check the Wireless router/Access Point is working if your Center
is connected to PC via a Wireless router/Access Point
__________________________________________________________________
4. Upgrading
You can upgrade the embedded firmware in 2 ways
A) Upgrading from CD-ROM
B) Upgrading from PC
A) Upgrading from CD-ROM
i) Prepare an upgrading CD
1. Check you have the following tools:
• PC (Pentium III 300MHz processor or higher)
• CD-R/RW writer and writing application software
• Blank CD-R or CD-RW disc
• Internet access (broadband or high speed)
2. Click the link to download Firmware Upgrade to your PC
3. Unzip the .zip file
(Note: - Do not rename the filename.
-Visit http://www.winzip.com/ for downloads if you can not
open the .zip file. )
4. Write the extracted files – not the zip file – onto a blank CD-R or CD-RW
disc, using the following settings:
• File System CD-ROM Joliet
• File name length : max 31 chars (ISO Level 2)
• Mode : 2/XA
• Character set : ASCII
• Single sessionWrite Speed : Low
• Finalized the disc. (The application may do this automatically.)
(Note:Make sure you finalize the CD)
ii) Upgrade WACS5
Upgrade WAC5 Center:
1. Check WAC5 Center is on and WAS5 Station is off
2. On Center, insert the upgrading CD into the CD slot loader, with
CD graphic printed side facing you
→Upgrading starts automatically
→The display shows “Updating firmware, please wait……” .
A progress bar appears
→Center will reboot itself twice during the upgrading process
→After about 5 minutes, Center returns to HD mode. The upgrading is
completed
(Note: - Keep your Center turned on during the upgrading.)
Upgrade WAS5 Station:
3. Press STANDBY-ON to turn WAS5 Station
→Upgrading starts automatically
→The display shows “Updating firmware, please wait……” .
A progress bar appears
→Station will reboot itself twice during the upgrading process
→After about 5 minutes, Station returns to HD mode. The upgrading is
completed
(Note: - Keep your Station turned on during the upgrading.)
Helpful hints:
- To check the firmware version, see Preparation: Verifying firmware
version.
- If you have any problem, see troubleshooting.
B) Upgrading from PC
i) Download Firmware Upgrade to your PC
1. Click the link to download Firmware Upgrade to your PC
2. Unzip the .zip file
(Note: - Do not rename the filename.
-Visit http://www.winzip.com/ for downloads if you can not
open the .zip file. )
ii) Upgrade WACS5
Upgrade WAC5 Center:
1. Connect your PC and WAC5 Center using the supplied Ethernet cable
2. Launch the Digital Media Manager (DMM) on your PC
3. Select Preference →Player Firmware →Upgrade Firmware
4. Click Yes to start upgrading
5. Find the Firmware Upgrade file you stored in the PC. Click Open
→You will start transferring the file to WAC5 Center
→After file transferring is finished, upgrading starts automatically on
WAC5 Center
→The Center’s display shows “Updating firmware, please
wait……”. A progress bar appears
→Center will reboot itself twice during the upgrading process
→After about 5 minutes, Center returns to HD mode. The upgrading is
completed
(Note: - Keep your Center turned on during the upgrading.)
Upgrade WAS5 Station:
6. Press STANDBY-ON to turn on WAS5 Station
→Upgrading starts automatically
→The display shows “Updating firmware, please wait……” .
A progress bar appears
→Station will reboot itself twice during the upgrading process
→After about 5 minutes, Station returns to HD mode. The upgrading is
completed
(Note: - Keep your Station turned on during the upgrading.)
Helpful hints:
- To check the firmware version, see Preparation: Verifying firmware
version.
- If you have any problem, see troubleshooting.
__________________________________________________________________
5. Troubleshooting
If the Station’s display shows: "Firmware is damaged, restoring a new copy …"
or "Center is connected, retrieving firmware"
Follow the DON’T below:
a. DON’T restore Center’s setting (Don’t select "Menu" →"Setting"
→"Restore Setting" on Center)
b. DON’T delete Stations from Center (Don’t select "Menu" →
"Station Mgnt" →"Delete Station" on Center)
c. Do NOT change Center’s Wi-Fi setting
Then,
1. If the progress bar is moving on, wait and upgrading will start later on the
Station
2. If the progress bar stops moving and/or Station’s display shows "Error Code
xxx", turn off the Station and then turn it on.
3. If Step 2’s problem still exists, check there is no Wi-Fi interference around and
reduce the distance between Center, Station and Wireless router/Access Point
(if applicable)
__________________________________________________________________
6. Firmware history
Version 1.2.10
• The software release 1.2.10 has provided a solution for CD ejection problem
that has happened on a marginal number of CDs.
Version 1.2.0
• Firmware installed on the set delivered
Altri manuali per Streamium WAC5
5
Questo manuale è adatto per i seguenti modelli
3
Altri manuali Philips Impianto stereo
Philips
Philips FWM2200X Manuale utente
Philips
Philips MCD755/93 Manuale utente
Philips
Philips FW-C71 Manuale utente
Philips
Philips AS405 Manuale utente
Philips
Philips FW 306 Manuale utente
Philips
Philips MCM280D/12 Manuale utente
Philips
Philips FWM154/79 Manuale utente
Philips
Philips FW M575 Manuale utente
Philips
Philips FWD410 Manuale utente
Philips
Philips MC-200 Manuale utente
Philips
Philips PDCC-JW-0817 Manuale utente
Philips
Philips MG-105 Manuale utente
Philips
Philips MCM530/37B Manuale utente
Philips
Philips MC145/37B Manuale utente
Philips
Philips FW-P75/25 Manuale utente
Philips
Philips FW390C Manuale utente
Philips
Philips NTRX300/77 Manuale utente
Philips
Philips MCM196D Manuale utente
Philips
Philips FW-P78/34 Manuale utente
Philips
Philips BTM2310 Manuale utente
