Connecting the Matrix Video Extender Box
6
11 If you still see noise or vertical lines on the LCD, you will need to adjust the
EQ on the LCD itself through the on-screen menus. Press the MISC button
once on the remote to pull up the MISCELLANEOUS OPTIONS menu. In
order to set the EQ on an individual LCD, you will need to move the
“target” to the correct display ID of the LCD you want to adjust. For
example, B1, B2, etc. Press the < or > buttons on the remote until you see a
green box around the display ID.
12 Using the -/+ buttons on the remote, move the CABLE EQUALIZATION line
up or down until you do not see any vertical lines on the LCD. The CABLE
EQUALIZATION line is shipped in the nominal position of 4, so you may only
need to make minor adjustments between the range of 3-5. In most cases,
4 will be sufficient.
13 When you are finished, close the on-screen menus.
14 Repeat steps 5-12 for each LCD in your video wall.
ON
** PICTURE
WALL
SOURCE
BALANCE
MISC
MONITOR
MENU PREV ENTER
- +
OFF SAVE
Clarity Matrix
TOP
Press one of these until you
see a green box around the
display ID of the LCD you
want to adjust.
Miscellaneous
Cable Equalization 1
*
*** Copy Settings to All Displays
