Planet FNSW-3200 Manuale utente

Trademarks

Contentssubject to revision without prior notice.

PLANETisaregistered trademark ofPLANET Technology

Corp. All other trademarks belong to theirrespective owners.

Disclaimer

PLANETTechnologydoes not warrant that the hardwarewill

work properlyin all environmentsand applications,and

makesno warrantyand representation, either implied or ex-

pressed, with respectto the quality,performance,

merchantability, or fitness for a particular purpose.

PLANEThasmade everyeffort to ensurethat this Users

Manual is accurate; PLANET disclaimsliabilityfor anyinac-

curacies or omissionsthat mayhave occurred.

Information in thisUser sManual issubject to change without

notice and doesnot represent acommitment on the part of

PLANET.PLANET assumes no responsibilityforanyinac-

curacies that maybe contained in this UsersManual.

PLANETmakes no commitment to update or keep current

the information in this UsersManual, and reservesthe right to

makeimprovements to this User sManual and/or to the

productsdescribed in this UsersManual, at anytime without

notice.

Ifyou find information in this manual that is incorrect, mis-

leading, or incomplete, wewouldappreciate yourcomments

and suggestions.

- 3 -

FCCWarning

This equipment has been tested and found to comply with the

limits foraClassAdigital device, pursuant to Part 15 of the

FCC Rules. These limits aredesigned to provide reasonable

protection against harmfulinterference when the equipment

is operated in acommercial environment. This equipment

generates,uses, and can radiate radio frequency energyand,

if not installed and used in accordance with the Instruction

manual, maycause harmful interference to radiocommuni-

cations.Operation ofthis equipment in aresidential area is

likely to causeharmful interference in which case the userwill

be required to correct the interference at his own expense.

CEMark Warning

This isaClassAproduct. In adomestic environment, this

product maycause radio interference, in which case the user

maybe required to take adequate measures.

Revision

PLANETFast EthernetSwitch User's Manual

FOR MODEL: FNSW-3200

Part No.: EM-FNSW32V1

- 4 -

TABLE OF CONTENTS

1. UNPACKING INFORMATION.............................................1

2. PRODUCT INTRODUCTION...............................................3

2.1 KEY FEATURES.................................................................3

2.2 FRONT PANEL...................................................................3

2.2.1 Ports Speed.............................................................4

2.2.2 Cabling.....................................................................4

2.2.3 Auto-MDI/MDI-X.......................................................4

2.2.4 StatusLEDs.............................................................5

2.3 THE REAR PANEL.............................................................5

2.3.1 PowerConnector.....................................................5

3. INSTALLATION...................................................................7

3.1 RACK-MOUNT INSTALLATION.............................................7

3.2 DESKTOP INSTALLATION ...................................................7

4. OPTIMIZING CONFIGURATION.........................................9

4.1 PRIOR TO INSTALLATION ...................................................9

4.2 HALF- AND FULL-DUPLEX..................................................9

4.3 FAST ETHERNET.............................................................10

4.4 AUTO-NEGOTIATION .......................................................11

4.5 MAC ADDRESS TABLE....................................................11

4.6 SAMPLE APPLICATION.....................................................12

5. TROUBLESHOOTING.......................................................13

6. PRODUCT SPECIFICATIONS..........................................15

7. RJ-45 PIN ASSIGNMENT..................................................17

- 1 -

1. UNPACKING INFORMATION

Thankyou forpurchasing PLANETEthernet Switches.Before

continuing, pleasecheckthe contents ofthe productpack-

age. This product package should containthe following items:

One Ethernet Switch

One Power Cord

Two Rack-Mounting Bracketswith attachment screws

ThisUser s manual

Please inform yourlocal dealer/supplier immediatelyifany

itemis found to be defective, damaged or missing. Retain the

original packaging (carton), including the packing materials,

and usethemto re-pack the product in the unlikelyevent

there is a need to return it to usforrepairing.

- 2 -

Thispage intentionallyleft blank!

- 3 -

2. PRODUCTINTRODUCTION

FNSW-3200 Ethernet Switchis multi-speed, versatile network

devicescombining both standard and "Big-Pipe" portsunderthe

same hood.

2.1Key Features

w Compliant with IEEE802.3 and 802.3u standards for

100Base-TX

w 32-port Fast Ethernet Switch, pure 10/100Base-TX

w Wire-speed "Store-and-Forward" filtering/forwarding

eliminatesbad data packetswith minimal delay

w 100Base-TX portsautomatically senseand set optimal

line speed from10/20, 100/200Mbps,All 100Base-TX

port support Auto-Negotiation function

w Shared buffermemoryand up to 4K FastEthernet

Switch-entryMAC sourceaddresstable makefor fast

handling of data packets

w Auto-MDI/MDI-Xdetection supports

w Flowcontrol to eliminate packets loss

w Internal, full-range power supplysuitable forworldwide

use

2.2Front Panel

Figure 1: Front View of theFNSW-3200

PWR

FNSW-3200

LNK/

ACT

100M

LNK/

ACT

100M

10/100Mbps Ethernet Switch

123456789

171819202122232425

- 4 -

2.2.1 Ports Speed

n100Base-TX

All 100Base-TX ports comewith auto-negotiation capability.

Theyautomaticallysupport 100Base-TXand 10Base-T

networks.Usersonlyneed to plug aworking network device

into one of the 100Base-TX ports,then turn on the switch.

The portwill automaticallyrunsin 10Mbps, 20Mbps,

100Mbps or 200Mbps after the negotiation with the con-

nected device.

2.2.2 Cabling

100Base-TX ports use RJ-45 sockets--similar to phone

jacks--forconnection of unshielded twisted-paircable(UTP).

The IEEE 802.3u Fast Ethernet standard requires Category 5

UTPfor 100Mbps 100Base-TX.10Base-Tnetworks can use

Cat.3, 4, or 5 UTP (see table A)

Port Type CableType Connector

10Base-TCat 3, 4, 5RJ-45

100Base-TX Cat.5/5eUTP RJ-45

Table A:Supported port list

2.2.3 Auto-MDI/MDI-X

Each numbered port ofFNSW-3200 is MDI/MDI-Xport.

Which automaticallydetectsstraight-through/ crossoverca-

ble types. You can directusestraight cable for the connection

to your workstation orother end nodes. Either straight or

cross-over cable can be used to connect switch, hub orend

nodes without anyhassle.

- 5 -

2.2.4 Status LEDs

One POWER LED to showpower On/Offis on the front panel

and each port hastwo statusLEDindicators, asshown below.

LABEL

STATUS /

COLOR MEANING

DESCRIPTION

Steady

orange 100MLit toindicatethat avalid physical

UTP/STP connection exists on

that port runs in 100Mbps

UPPER

ROW

OFF 10M Remains off and Link ON toin-

dicate theport runs in10Mbps

Steady

Green LinkLit toindicatethat avalid physical

UTP/STP connection isdetected

LOWER

ROW Blink

Green Activity Blink to indicate theport is re-

ceiving data packets

Table B:TheSwitch's Port-LED Functions

2.3The Rear Panel

Figure 2:Rear View for FNSW-3200

2.3.1 Power Connector

The Power Connectorisdesigned to be use with the powercord

included in the product package. Attachthe female end of the

cordto the powerconnector and the male end ofthe cordto a

grounded power outlet. The accepted power range isfrom

100VAC to 240VAC, 50/60Hz.

50-60 Hz

100-240V AC

- 6 -

Note:

The Switchisapower-required device, itmeans,the

Switchwill not work until it is powered. If your networked

PCs willneed to transmit data all the time, please con-

sideruse an UPS (Uninterrupted Power Supply) for your

Switch. It will prevent you fromnetworkdata loss.

In some area, installing asurge suppression devicemay

also help to protect yourSwitch from being damaged by

unregulated surge or current to the Switchorthe power

adapter.

- 7 -

3. INSTALLATION

The Switchdo NOTrequire software configuration. Users can

immediately useanyof the features of this product simplyby

attaching the cables and turning on the power.

Toget the best use oftheseSwitchmodels, manythings need

to be considered first. See Section 4. OPTIMIZING

CONFIGURATION fordetails.

3.1Rack-Mount Installation

Most userspreferto attachthe power cord to the hub before

installation inanetwork rack.Do not plug the other end of the

cord into a poweroutlet until after the hub is installed.

For mounting the Switch in anetworkrack,firstattach the

rack-mount bracketsto the side of the hub with screws.(Both

bracketsand screwsare included in the product package.) Slide

the hub into the rack and align the holes in the bracket with the

corresponding holesin the networkrack.Attach the bracket to

the rackwith the enclosed screws.

3.2Desktop Installation

Tolocate the Switchon adesktop, first attach the four rubber

feet to the bottomof the hub, one in each corner. Place the hub

on aclean, flat desk or tabletop close to apower outlet. Make

sure there is no hindrance behind the fan ofthe hub

Plug in all networkconnections, and then turn the switch on via

plug in the power cord.

Indice

Altri manuali Planet Router di rete

Planet

Planet MGSW SERIES Manuale utente

Planet

Planet WAP-500N Manuale utente

Planet

Planet ADSL 2/2+ VPN Firewall Router ADW-4302A v2 Manuale utente

Planet

Planet MGSW-28240F Manuale utente

Planet

Planet XRT-101A Manuale utente

Planet

Planet WSD-800 Manuale utente

Planet

Planet IGS-801T Manuale utente

Planet

Planet GSW-1602SF Manuale utente

Planet

Planet XRT-401C Manuale utente

Planet

Planet WGSW-2620HP Manuale utente

Planet

Planet GSW-1601 Manuale utente

Planet

Planet VR-300 Series Manuale utente

Planet

Planet XRT-401D Manuale utente

Planet

Planet ADSL Firewall Router ADE-4120 Manuale utente

Planet

Planet EPN-104 Manuale utente

Planet

Planet FNSW-1600S Manuale utente

Planet

Planet WGSW-2620PV Manuale utente

Planet

Planet WDAP-C7210E Manuale utente

Planet

Planet PL-802 Manuale utente

Planet

Planet SGSW-2620 Manuale utente

Planet

Planet AND-4102 Manuale utente

Planet

Planet ADE-3400 Manuale utente

Planet

Planet WGS-804HP Manuale utente

Planet

Planet VIP-280 Manuale utente

Manuali Router di rete popolari di altre marche

Allnet

Allnet ALL0333AU Manuale utente

HomeSeer

HomeSeer HT-SEL Manuale utente

Sercomm

Sercomm Genesis OC3505D Manuale utente

Billion

Billion BIPAC 5102 Series Manuale utente

TP-Link

TP-Link TD-8817 Manuale utente

Motorola

Motorola MR1900 Manuale utente

Digi

Digi IX14 Manuale utente

Cisco

Cisco NCS 540 Manuale

XAVi

XAVi X8821e Manuale utente

BEC

BEC 6200WZL Manuale utente

MikroTik

MikroTik hAP ac3 Series Manuale utente

Korenix

Korenix JetNet 5428G Series Manuale utente

NETGEAR

NETGEAR FS526T - Switch Manuale utente

Korenix

Korenix JetNet 5710G Series Manuale utente

Automated Logic

Automated Logic ZN551 Manuale del proprietario

Cisco

Cisco ASR 1000 Series Manuale dell'operatore

EnGenius

EnGenius ESR-9710 Manuale utente

Cisco

Cisco 805 Series Istruzioni operative e di sicurezza