Plast-O-Matic CAFE Guida
1
SERIES CAFÉ MULTI-VOLTAGE
ELECTRIC ACTUATORS
Installation, operation, & maintenance instructions
CONTENTS
SAFETY INSTRUCTIONS 6
SPECIFICATIONS 7
DIMENSIONS 8
INSTALLATION 9
WIRING 10
ON/OFF 8
MODULATION 10
INPUT/OUTPUT 12
OPERATION 17
ON/OFF 8
MODULATION 10
INPUT/OUTPUT 12
3
plastomatic.com
CAFE Actuator x1
14mm Double Square
Coupler x1
Documentation
Cable Gland x1
Manual Handle
x1
Large DIN Gasket
x1
Small DIN Gasket
x2
Large DIN Connector x1 Small DIN Connector
(10 o’clock Ground) x1
Small DIN Cap x1
Rubber Gland
x2
Plastic Gland
Shroud x2
Plastic
Shroud x2
Small DIN
Shipping Gasket
x1
For Shipping Purposes Only
Small DIN Screw
x2
Large DIN Screw
x1
Large DIN Screw
Gasket x1
Large DIN Cap
x1
Large DIN Cap
Ring x1
CAFE PARTS LIST
Small DIN
Screw Gasket x2
For Shipping Purposes Only
4
CAFE NITRO Actuator x1
14mm Double Square
Coupler x1
Documentation
Cable Gland x1
Manual Handle
x1
Large DIN Gasket
x1
Small DIN Gasket
x2
Large DIN Connector x1 Small DIN Connector
(10 o’clock Ground) x1
Rubber Gland
x2
Plastic Gland
Shroud x2
Plastic
Shroud x2
Small DIN
Shipping Gasket
x1
Small DIN Screw
x2
Large DIN Screw
x1
Large DIN Screw
Gasket x1
Large DIN Cap
x1
Large DIN Cap
Ring x1
Small DIN Cap x1
ON/OFF CAFE NITRO PARTS LIST
Small DIN
Screw Gasket x2
For Shipping Purposes Only For Shipping Purposes Only
5
plastomatic.com
CAFE NITRO Actuator x1
14mm Double Square
Coupler x1
Documentation
Cable Gland x1
Manual Handle
x1
Large DIN Gasket
x1
Small DIN Gasket
x2
Large DIN Connector x1 Small DIN Connector
(10 o’clock Ground) x1
Small DIN Connector
(6 o’clock Ground) x1
Rubber Gland
x2
Plastic Gland
Shroud x2
Plastic
Shroud x2
Small DIN
Shipping Gasket
x1
Small DIN Screw
x2
Large DIN Screw
x1
Small DIN
Screw Gasket x2
Large DIN Screw
Gasket x1
Large DIN Cap
x1
Large DIN Cap
Ring x1
CAFE NITRO W/ CONTROL PARTS LIST
For Shipping Purposes Only For Shipping Purposes Only
6
Damage caused by non-compliance to these instructions will not be covered by our warranty. Read these instructions
BEFORE installing or connecting the actuator. Electric actuators operate with the use of live electricity. It is recommended
that only qualified electricians or people instructed in accordance with electrical engineering, and familiar with local
electrical, health and safety directives, be involved in the connection of these actuators. It is strongly recommended
that each actuator has its own independent fused system to protect it against the influence of other electrical devices
connected to the system. Follow instructions carefully. This unit is designed to be connected to equipment which can be
hazardous to persons and property if used incorrectly. Remove power to unit before wiring connections. Do not use unit if
plastic enclosure is cracked or broken.
SAFETY INSTRUCTIONS
WARNING/CAUTION/DANGER INDICATES A POTENTIAL
HAZARD. FAILURE TO FOLLOW ALL WARNINGS MAY LEAD
TO EQUIPMENT DAMAGE, INJURY, OR DEATH.
ELECTROSTATIC DISCHARGE (ESD)/ ELECTROCUTION DANGER
ALERTS USER TO RISK OF POTENTIAL DAMAGE TO PRODUCT BY
ESD, AND/OR RISK OF POTENTIAL OF INJURY OR DEATH VIA
ELECTROCUTION.
PERSONAL PROTECTIVE EQUIPMENT (PPE) ALWAYS UTILIZE THE
MOST APPROPRIATE PPE DURING INSTALLATION AND SERVICE.
NOTE/TECHNICAL NOTES HIGHLIGHTS ADDITIONAL
INFORMATION OR DETAILED PROCEDURE.
PROTECTION AGAINST ELECTRIC SHOCK. CLASS I (EARTHED
DEVICE)
7
plastomatic.com
SPECIFICATIONS
Sizes 3/8"-2" Ball Valves
Actuator CAFE CAFE NITRO
Frequency DC,50Hz/60Hz DC, 50Hz/60Hz
Working Time 0-90° No Load) ±10% 5 seconds preset 5 seconds preset - up to 10 sec via display
Multivoltage Maximum Run
Torque (Nm/ in-lbs.)* 15 / 133
Maximum Break Torque (Nm/in-lbs.) 20 / 177 20 / 177
On/O Duty Rating % 75 75
Modulating Duty Rating % 100 100
IP Rating—IEC 60529 IP67 IP67
Working Angle Standard 90°/180° 90°/180°
Temperature Range (°F / ºC)
Anti-Condensation Heater (W) 3.5 3.5
Input Power (@24VDC)max 35 W 35 W
Discrete Control Input Input Power Input Power
Analog Control Input 0-10V,2-10V,0-20mA,4-20mA
Discrete Output (Volt Free) Relay (ON/OFF) Relay (Programmable)
Discrete Output Activation oset approx. 5° approx. 5°
Analog Control Output – 0-10V,2-10V,0-20mA,4-20mA
Analog Control Impedance – 6.1 KOhm
Analog Load Impedance – 50 KOhm (V) - 600 Ohm (A)
Max Current per Discrete Output (
Resistive
)4 A 4 A
Max Voltage per Discrete Output 240 VAC/DC 240 VAC/DC
Resistance per Discrete Output 25 mOhm 25 mOhm
Communication Control IN/OUT – MODBUS RS 485
Comm. Baud Rate – 9600, 19200, 57600 Baud
Comm Available Registers – 12
Local Signaling Multicolor LED Multicolor LED
Manual Remote Signaling – Supported**
Event Scheduler – Supported**
User Interface – OLED w/full navigation Keypad
Electrical Interconnections Field Attachable Type A,C Field Attachable Type A,C Customization
Supported
Fail Safe – Supported***
Enclosure GF-PP GF-PP
Weight (kg/lbs) 1.25kg / 2.75 lbs. 1.25kg / 2.75 lbs.
Drive Socket 14 mm Double Square 14 mm Double Square
15 / 133
Input Voltage (+1.1 VR / -0.85 VR )24 Vdc, 24 Vac, 110-240 Vac 24 Vdc, 24 Vac, 110-240 Vac
Application Indoor ** Indoor**
-4 to 122 / -20 to 50 -4 to 122 / -20 to 50
Current Full Load: 24Vdc,24Vac 1p
50/60Hz,110-240Vac 1ph 50/60Hz 1.4 A,1.5 A,0.3 - 0.15 A 1.4 A,1.5 A,0.3 - 0.15 A
*20 / 177 (Nm/ in-lbs.) available with voltage specific motors with extended cycle times; consult factory. ** Outdoor
applications consult factory. ***Additional Module Required.
Battery pack for Fail Safe operation is not operator replaceable. Consult factory.
8
. in
. mm
. in
. mm
. in
. mm
. in
. mm
DIMENSIONS
. in
. mm
. in
. mm
9
plastomatic.com
MODEL SIZE L L1 L2 H H1 W W1
IN DN IN MM IN MM IN MM IN MM IN MM IN MM IN MM
CAFE/CAFEN-037 3/8" 16 4.13 104.8 7.40 187.8 4.05 102.9 6.48 164.7 2.75 69.9 3.73 94.6 4.00 101.6
CAFE/CAFEN-050 1/2" 20 4.13 104.8 7.40 187.8 4.05 102.9 6.48 164.7 2.75 69.9 3.73 94.6 4.00 101.6
CAFE/CAFEN-075 3/4" 25 4.75 120.7 7.40 187.8 4.05 102.9 6.90 175.2 3.25 82.6 3.73 94.6 4.00 101.6
CAFE/CAFEN-100 1" 32 5.38 135.5 7.40 187.8 4.05 102.9 7.25 184.1 3.81 96.8 3.73 94.6 4.00 101.6
CAFE/CAFEN-125 1⁄" 40 6.7 170.2 7.40 187.8 4.05 102.9 7.87 199.9 5.00 127.0 3.73 94.6 4.00 101.6
CAFE/CAFEN-150 1⁄" 50 6.75 171.5 7.40 187.8 4.05 102.9 7.87 199.9 5.00 127.0 3.73 94.6 4.00 101.6
CAFE/CAFEN-200 2” 63 7.90 200.7 7.40 187.8 4.05 102.9 7.87 199.9 5.56 141.2 3.73 94.6 4.00 101.6
INSTALLATION
MOUNTABLE IN
ALL ORIENTATIONS
10
INSTALLATION
MOUNTING TO PLAST-O-MATIC BALL VALVE
MOUNTING PLATE DETAIL
Valve Size
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Plast-O-Matic Controllori
