2PMT EVO 2.0 S
General Safety Instructions
• The current project report must be used for all
specifications concerning ballasting, dimensions
of the module surface and roof surface area.
• It is possible to build over a pitch change
at the peak of the roof up to a roof pitch of
1.5° without additional components. The
prerequisite for this is that the transition from
base to connecting floor profile runs exactly
above the peak and can act as a “joint”.
• Peaks with a gradient >1.5° must be built over
using ridge connectors or be left free. Low
points must not be built over. Otherwise the
roof cladding may be damaged. In the event
of noncompliance, PMT reserves the right to
exclude liability.
• Before installation, the compatibility of the
system with the roof must be determined.
• Systems may only be installed and
commissioned by persons who can guarantee
that the work will be carried out in accordance
with regulations on account of their
professional competence (e.g.training or current
work) or experience.
• Before installation, verify whether the product
meets the static requirements applicable on
site. For roof systems, also check the load-
bearing capacity of the roof. National and
local building regulations, standards, and
environmental protection regulations must be
complied with.
• For roof pitches greater than 1°, we strongly
recommend that the system is connected to the
roof structure in order to prevent a “caterpillar
effect” caused by thermal linear expansion. For
roof pitches of 5° and above, it is imperative
that the system must be structurally fixed to the
roof.
• Occupational safety and accident prevention
regulations, corresponding standards, and
trade association regulations must be complied
with.
• The module manufacturers' assembly
instructions must be complied with.
• In the event of non-compliance with our general
safety instructions or assembly instructions
or not using all system components, including
installation and upgrading using components
that have not been supplied by us, we accept no
liability for resulting defects and damages and
warranty is rendered void in this instance.
Please not that our general safety instructions
must be complied with.
