Politec Sandor S Series Guida
1
Installation
And commissioning
manual
Series S
Double Beam
2
Index
Main components list Pag. 3
Installation reccomendations Pag. 4
Mounting the bracket Pag. 5
Installation example Pag. 6
Positioning the beam with respect to others in the perimeter Pag. 7
Alignment Pag. 8
Vertical alignment of the mirror Pag. 8
Horizontal alignment of the mirror Pag. 8
Cabling and terminal connections Pag. 9
Transmitters main P.C.B. Pag. 9
Receivers main P.C.B. Pag. 10
Set-up using the test point on the main Transmitter P.C.B. Pag. 11
Set-up using the test point on the main receiver P.C.B. Pag. 14
Set up examples Pag. 15
Alignment checking Pag. 16
Setting and programming Pag. 17
Functional description of the led’s Pag. 17
Operational characteristics and Link setting Pag. 18
Technical specifications Pag. 19
3
Main component list
N°
Parte Q.ty Description
1 1 Mounting plate
2 1 Front cover
3 2 Front cover
top/end caps
4 2 Trasmitter /
receiver optic
5 1 Flat cable
6 1 Receiver /
trasmitter P.C.B.
7 4 Bracket
4
Installation reccomendations
• Verify that the beam tower is fully watertight once the cover and end caps have
been correctly filled at the end of the installation.
• Use the cable glands supplied on the tower for all cabling must pass through the
lower end cap using the cable glands supplied.
• Avoid any type of obstruction between the transmitter and receiver.
• Avoid installing the receivers beams in a position where direct sunlight, at the same
angle as the receivers beams, can enter directly into optics especially at sunset and
sunrise
• Do not install multiple beams where the transmitter beam can interfere with other
receiver beams. It is always better place either transmitter or receivers back to
back.
• Do not use switched power supplies which can induce noise on the power supply
voltage which can in turn be amplified by the optical sync electronics creating
unwanted problems.
5
Mounting the bracket
Insert the bracket back to
mounting plate
Wall mounting
Diameter 50 mm
Pole
mounting
6
Installation example
Pole
mounting Wall
mounting Wall mounting
With interposed
brakets
7
Positioning beam with respect to others in the
perimeter
Rx
Tx
Tx
Rx
Rx
Tx
Tx
Rx
Tx
Rx
Tx
Rx
8
Alignment
Initial alignment
Once beam columns have been correctly installed point the transmitter optics towards its
corresponding receiver and vice versa, repeat for all the beam pairs.
This is achieved by manually positioning the lens holder horizontally and vertically using
one of the two screws (which ever is more convenient) to be found above the lens.
Vertical alignment
Horizontal alignment
9
Cabling and terminal connections
TRANSMITTERS
MAIN P.C.B.
Always use screened multicore cable for alarm output, power supply 12
dc, relè output, And, Tamper connection
Always use separate power supply 24 V ac cable of proper diameter
10
Cabling and terminal connections
RECEIVERS
MAIN P.C.B.
Questo manuale è adatto per i seguenti modelli
3
Indice
Altri manuali Politec Attrezzatura di illuminazione
