Populo PES350B Manuale utente
Electric Scooter User Manual
PES350B
Read and understand this entire manual before riding this scooter.
Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact
appearance of actual product. Specifications subject to change without notice.
01
5. Charge Your Scooter
1. Package Contents
4. Assembly and Set-Up
2. Control Panel
CONTENTS
02
03
05
06
6. How To Ride
7. Safety Instructions
06
08
9. Daily Care and Maintenance
3. Specifications
8. Folding and Carrying 13
04
14
10. Troubleshoot 15
02
Battery Compartment
Disc Brake
Brake Light
Buckle
Scooter Bell
Control Panel
Accelerator
Kickstand
Folding Mechanism
Wheel Motor
Charging Port
Headlight
Brake Lever
1 Package Contents
Assembled Electric Scooter
Carefully check package contents. If anything is missing or damaged, please contact Populo for support.
Accessories
Charging Adapter Hex Wrench X 2 Extension Hose
03
2 Control Panel
Mode Display
Cruise control
The scooter has 3 speed modes which can be selected.
To change modes, press the power button twice.
ECO - Approx. 6 mi/h speed
D- Approx. 9 mi/h speed
S - Top speed of 15 mi/h
Speed Display
When the scooter is ridden, the riding speed will be
displayed on the control panel.
Battery Level Display
The battery charging level is indicated by 5 bars on the
control panel. As the battery charging is consumed, less
bars will be displayed.
Power Button
The power button is used to power and configure the
scooter.
Turn On - Press the power button & hold for 2 seconds
Turn O - Press the power button & hold for 2 seconds
Headlight - Turn On, press the power button once
Change Speed - Press the power button twice
NOTE: The scooter will beep and flash over 15mph as speed warning.
Cruise control will be activated when the throttle is
engaged for more than 3 seconds.
Press down the throttle completely or apply the brake
to deactivate the cruise control.
mph
ECO D
S
04
3 Specifications
[1] Item height: Measured from the ground to the top of the scooter.
[2] Travel range per charge: Measured when there is no wind and at 77°F, with the fully charged scooter that ride at a even speed of 9.3 mph on a flat surface with a load of 165.3 pounds .
NOTE: Data and specifications may vary due to dierent models, and are subject to change without notice.
Performance Index Items
Dimensions
Weight
Main
Parameters
Battery Pack
Wheel Motor
Tires Treaded, 8.5” Pneumatic Rubber
Charging Adapter
L × W × H [1]
After folding: L × W × H
Load range
Riding
Requirements Age
Top. speed
Travel range per charge[2]
Max. climbing angle
Operating temperature
Storage temperature (°F)
IP rating
Suitable surfaces
Max. input voltage
Rated capacity
Intelligent battery management
system
Input voltage
Output voltage
Output current
Rated voltage
Rated power
Output power
Charging time
Specifications
42.5×16.7×44.7 (inch)
42.5×16.7×18.9 (inch)
55.1-220 (lbs)
Approx. 14.5 (miles)
Approx. 14 (%)
36 (VDC)
14–104 (°F)
-4–113 (°F)
42 (VDC)
270 (Wh)
350 (W)
Unusual temperature/short circuit/under voltage/over current/dual
overcharge/dual over-discharge protections
100–240(VAC)
42 (VDC)
2 (A)
84 (W)
16–50
IPX4
Cement, asphalt and mud roads; bench lower than 0.4 inch;
crevice narrower than 1.2 inch
Approx. 15 (mph)
Approx. 4 (h)
Item weight Approx. 28.3 (lbs)
05
4 Assembly and Set-Up
2. After the assembly, press the power
button to check if it's working properly.
1. Fasten the handlebar to the steering column, then unfold the steering column and fasten the folding
mechanism. Open the kickstand.
mph
ECO D S
06
5 Charge Your Scooter
6 How To Ride
Wearing helmets and knee pads in case of falls
and injuries when you learn to ride the scooter
RED - charging
GREEN - fully charged
Turn on the scooter and check
the battery charge level.
1.
Lift the rubber
charging port cover.
Plug the power adapter
into the charging port.
WARNING
When charging is complete, unplug
the power adapter and cover with the
rubber charging port cover.
Caution: Please check and make sure all fasteners
are locked before each ride.
mph
ECO D S
07
Releasing the accelerator gently slows the
scooter. For immediate braking control,
squeeze the brake lever.
4
Step on the deck with one foot, with the
other foot slowly push forward to roll and
coast on the scooter.
2.
When the scooter starts to coast, put both feet on the
deck and press the accelerator.
3.
Slightly lean your body and turn the
handlebars in the direction you want to turn.
5
NOTE：The electric scooter will not be engaged until
the scooter reaches a speed of approx. 2mph, for your
safety.
08
DO NOT accelerate when you go downhill.
Look out for doors, elevators and other overhead obstacles.
Ride at a controlled and slow speed while you ride through
uneven surfaces. Slightly bend your knees to absorb the
bumpy impacts.
7Safety Instructions
Watch out for safety risks
DO NOT ride during
rainy / wet weather.
09
DO NOT hang bags or other heavy
accessories on the handlebars.
Keep both feet on the deck at all times.
Always steer clear of obstacles.
DO NOT PRESS THE ACCELERATOR
when you're walking alongside the scooter.
Indice
