The IEC C13/C14 leads fitted to GABY can be replaced if required.
▪Loosen the required cable gland retainer and extract the required terminals from the
PCB.
▪Remove the earth conductor from the cage clamp connector.
▪Remove the cable from GABY.
▪Replace with the new cable and terminate with crimps, with the earth conductor
connecting to the cage clamp connector.
The PCB tabs accept 4.8x0.5mm Female Crimp Terminals.
The cable must have conductors suitable in cross sectional area for the length of run and
the maximum current rating of GABY, and in any event at least 0.75mm2.
▪Confirm the integrity of the conductors using suitable test equipment.
GABY is tested for earth bond continuity, polarity, insulation resistance and flash (HiPot)
tested before despatch. Upon opening the lid and making any changes these parameters
may have changed and it is the installer’s responsibility to ensure that this safety
integrity has not been compromised.
6. WARRANTY
▪GABY is warranted from defects in material and workmanship under normal use during the
warranty period. During the warranty period Power Inspired will repair or replace at no charge,
the product or parts of it that proves defective because of improper material or workmanship
under normal use or maintenance.
▪The warranty period is 2 years from date of despatch.
▪If you suspect your GABY has a problem that is covered under warranty then you must first
contact us to obtain an RMA number. Once issued you must securely package the unit and
return it to us at the address given under “Contact Information”. Power Inspired will inspect,
test and repair the unit, and send the unit back to you.
▪This warranty does not cover any problems caused by conditions, malfunctions or damage
not resulting from defects in material or workmanship, nor for any losses incurred due to the
failure of the product. Please refer to our Terms & Conditions of Sale located at
https://www.powerinspired.com/commercial/trade-terms-conditions-sale/
