6
SPECIFIC SAFETY RULES FOR LOG SPLITTER
WARNING: Do not operate your log splitter until it is completely assembled and installed
according to the instructions.
1. IF YOU ARE NOT thoroughly familiar with the operation of the log splitter, obtain instruction from
a qualified person.
2. MAKE SURE wiring codes and recommended electrical connections are followed. When servicing,
use only identical replacement parts. Disconnect log splitter from the power source before making
adjustments or repairs.
3. Place the log splitter on a stable, flat, and level work surface where there is plenty of room for
handling logs.
4. INSPECT THE LOG SPLITTER before each use. Keep guards in place and in working order. Re
place damaged, missing, or failed parts before using.
5. Do not alter the log splitter. Altering the tool or exceeding its design capabilities and capacities could
result in serious injury or fatality and will void the warranty.
6. MAKE SURE THE EXTENSION CORD is no longer than 25 ft.,14 gauge. Ensure the power cord is
rated for outdoor use. Ground the log splitter and avoid contact with grounded surfaces during
operation. See “Electrical Information” for further details.
7. MAKE all adjustments with the switch in the OFF position and the log splitter disconnected from the
power source.
8. Never use the log splitter for any other purpose than splitting wood. Any other use can result in injury.
Use extreme caution at all times.
9. PREPARE LOGS FOR SPLITTING. Make sure the ends of the logs are cut square. Cut off any
branches flush with the trunk.
10. INSPECT EACH LOG before splitting. Make sure there are no nails or foreign objects in the log.
11. Only a single operator should load and operate the log splitter. Keep all others, including children and
pets, a minimum of 20 in. (6.1 m) away from the work area.
12. NEVER TRY TO SPLIT LOGS larger than the rated capacity of the tool. Attempting to do so could
result in personal injury and damage to the tool.
13. Split only one log at a time. Do not attempt to split two logs on top of each other.
14. DO NOT put your hands or feet between the log and the splitting wedge or between the log and the
push rod while the tool is in operation.
WARNING: KEEP HANDS AWAY FROM SPLITS AND CRACKS WHICH OPEN IN
THE LOG. THEY MAY CLOSE SUDDENLY AND CRUSH OR AMPUTATE YOUR
HANDS.
15. Do not attempt to load a log while the push rod is in motion. When loading, place your hands on the
sides of the log, not on the ends.
16. WAIT FOR THE PUSH ROD TO STOP MOVING before loading another log onto the log splitter.
Do not try to remove a split log until the entire splitting cycle is completed.
17. Use only your hands to operate the control lever. Never use your foot, knee, rope, or extension device.
18. Never use your hands to remove a jammed log. If a jam should occur, release the ON/OFF push
button. Follow the instructions in this manual for removing a jammed log.
19. Stack logs as you work. This will provide a safer, less cluttered work area.
