6/12
SETUPOPTIONS-LIGHTING FIXTURE CONFIGURATION
To browse through or change a fixture’s configuration, after
ENTER button has been
pressed for about 3 seconds, the display of
AddR means the entrance of the menu. To set or browse through a fixture’s settings, press buttons of UP and DOWN. After
button ENTER is pressed, a sub-menu is entered showing current parameters while indication flashing.
Press button UP or
DOWN tochangevalues(plusorminus)
Pressbutton
ENTER
to saveyour settingsorenterintotheupper level menuand theindication stops fromflashing.
Press
FUNC toenterinto theupperlevelmenu(parametersnotsaved)orbrowsethroughthe upperlevelmenu.
After FUNC is pressed for more than 1second or buttons notpressed for more than 1 minute, it will go back to the main menu
displaying thefixture’sname.
Aftertheexitofthemenus,thecurrentlampcolorwillbeshown.
WhileDMX signalsareavailable,SignalLEDindication willbe on,otherwiseoff..
TO SETTHE DMX STARTADDRESS
Eachdevice must be given a DMX start address so that the correct lighting fixture responds to the correct control signals. This DMX
start address is the channel number from which the lighting fixture starts to “listen” to the digital control information being sent out
from the controller. The device has Two Channel Modes. 1 Channel Mode has 1 channel, so set the No. 1 lighting fixture’s address
001,No. 2lightingfixture’saddress002,No.3 lighting fixture’saddress003,and soon.4 ChannelModehas4channels, soset the No.
1lighting fixture’saddress001,No.2lightingfixture’saddress005, No.3 lightingfixture’s address009,andsoon.
Launch the lighting fixture. Pressbutton ENTER formorethan3 secondsto unlockthepaneltill
isdisplayed
.
Pressbutton FUNC, UPor DOWN to find“ ”menu.
Thenpress ENTER to showDMXaddressandpress UP or DOWN to setDMXaddress.
Atthis time, the address will flashcontinuously.Pressbutton ENTER to confirmand it means the setting has been
enabled and saved. After powered next time, the latest setting will be used.
Pressbutton FUNC,it willreturnto theupper menu onebyone.
