To set the parallel port:
1. Access the system setup utility on your computer. On most computers this is done
y pressing the F1, F10, Delete or Esc key during system ooting, i.e. immediately
after switching on the computer.
2. Find the parallel port mode and set it for ECP. If the ECP selection is unavaila le,
the parallel port is pro a ly already set for ECP.
3. Save your changes and exit the system setup utility.
Log on as an administrator
You must have administrator rights on your local computer to install the
Precise 100 Logon 2.1 software.
Install software
Insert the Precise 100 Logon 2.1 software CD. The Master Setup screen will appear.
1. If you have a Precise 100 Reader with USB connector, please connect it to your PC
now. Windows 2000 will detect the new hardware and install the necessary drivers
from the CD. If you have a Precise 100 Reader with parallel port connector, click the
Parallel Driver utton to install the necessary parallel port drivers.
2. If you are using Windows NT you must install the Microsoft Smartcard Base
Components, if not previously installed. If you are using Windows 2000 do not
install the Smartcard Base Components, the system may crash.
To install the Smart Card Base Components
a) Click the SC Base Components utton, a su menu appears.
) Click the Base Components utton in the su menu.
c) Click the Update utton in the su menu and follow the instructions
Connect the fingerprint reader
If you have a Precise 100 Reader with USB connector, skip this section and go to the next
page “Log on as an administrator”. If you have a Precise 100 Reader with parallel port
connector, follow the instructions elow.
1. Make sure that the computer has een turned off.
2. Connect the fingerprint reader to the computer as shown elow.
Installation
Enrolling a User
To enroll a user, see chapter four in the User's Guide. To open the User’s Guide,
click Start > Programs > Precise Biometrics > Documentation and select the
appropriate User’s Guide (either the Precise 100 A User’s Guide or the Precise
100 SC User’s Guide.)
NOTE: The parallel port must e set to ECP
mode, otherwise the fingerprint reader will not
function properly. Please refer to the computer
manual for additional information, or follow the
instructions elow.
NOTE: If the CD does not start automatically, start
the CD from the desktop y dou le-clicking My
Computer > CD > MasterSetup.exe icon.
Logging on
To Logon, see chapter six in the User's Guide. To open the User’s Guide, click Start
> Programs > Precise Biometrics > Documentation and select the appropriate
User’s Guide (either the Precise 100 A User’s Guide or the Precise 100 SC User’s
Guide.)
NOTE: If you have a previous release of Precise Biometrics fingerprint identification software installed on your
computer, please do the following efore you install the Precise 100 Logon 2.1 software: 1) Make sure you have
a ackup password (see the chapter BioManager). 2) To uninstall the old software, read carefully the chapter
Uninstalling in your Precise Biometrics manual and follow the instructions.
NOTE: After the installation of components, you may e asked to restart your computer. Please ignore this and
restart your computer when you reach step 4 in the installation sequence.
3. To install the Precise 100 Logon 2.1 software, click the Precise 100 Logon 2.1
utton and follow the instructions.
4. Restart the computer.
