10
This document contains information and data which is proprietary to Presidio that shall not be duplicated, used, or disclosed - in whole or in part
- for any purpose other than to evaluate this product.
AIO3.0 User’s Manual PRES058-150422 REV 4
After confirmingthedevice is fullyfunctional select an intended installation location that will assurethe
device can be securelyfastened to the vehicle and that the device has theleast obstructed view of thesky.
Thedevice comes withan auxiliarymountingcase that comes withinternalmagnets that will support
most installations. For those cases where a magnet will not secure the device one can use tie-wraps or
whateverother appropriate means tosecure the deviceto the vehicle. The installation location isvehicle
dependent however care should be taken that the GPs andCellular antennas must be located facing away
from themounting structure. Position the GPS antenna (Side with the three LED’s) so that it is not
obstructedwith metal. Someinstallation locationsmayrequire thatthe devicebepointingtowards the
ground.
3.1.2 Non-Vehicle Installations
As above, confirm thedevice is fullyfunctional before installation. Installation locations are based on the
asset structure and the same careshould be taken to provide the least amount ofobstruction to the GPS and
Cellular antennas withinthedevice. Do not install thedevice withina total metal containerorstructure.
3.2 OPERATING PROCEDURES
After the Device has been set-up, tested, and installed it is monitored and controlled by the mapping
application. Refer to the Map AGenT Users Guide for complete operating and tracking
functions of the AIO3.0.
3.3 PROBLEM PROCEDURES
There are no user servable parts within the AIO3.0 device. It is imperative that the device be tested prior
to deployment to ensure the unit is fully functional. If the AIO3.0 fails during deployment confirm the
device is powered on and that the batteryis charged. If so tryto communicate with it usingthe mapping
application, if you are successful than most likely the installation location may have caused the unit to
notfunctionproperly. Select a new installationlocation and test unit as necessary.
3.4 MALFUNCTIONING GPS
If duringdeployment the devicedoes not report a navigation report and it isknown to haveworked prior
to deployment then in mostcases the GPS antennais blockedandthe unit cannot receive adequatesignal
to calculateposition. Several external factors can cause thisissuewhich mayor maynot be resolved
once the vehicle moves from its current position. If the device continues to not report position data then
the device has malfunctioned and it should be removed and returned to Presidio for evaluation and/or
repair.
