Prestige PE1M2LEDZ Manuale utente

1PE2LEDZ - PE1M2LEDZ / FLRS Owners rev A.

IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is

applicable to most vehicles. However, due to the conguration of some vehicles, some functions AND/OR

SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information.

Owner’s Guide

For Models:

PE2LEDZ

PE1M2LEDZ

Flashlogic FLRS

RF Upgrade Kit

Table of Contents

Using Your Remote Control .......................................................3

Remote Start Valet Mode............................................................4

 2WayRemoteControlNotications.........................................5

Remote Control Programming...................................................5

 ReplacingRemoteControlBatteries ........................................6

3PE2LEDZ - PE1M2LEDZ / FLRS Owners rev A.

Using Your Remote Control

Two Stage Door Unlock (Optional)

If this feature is enabled on your system, pressing the button one time will unlock

only the driver’s door. Press again within three seconds to unlock the remaining

doors.

Activating the Trunk Release Feature (Optional)

If this feature is enabled on your system, pressing and holding the button for 3

seconds will open the vehicle’s trunk or hatch.

Door Lock

To lock the vehicle doors press and release the button.

Door Unlock

To unlock the vehicle doors press and release the button.

Remote Starting Your Vehicle

To activate the remote vehicle start function, press and release the button 2

times within 2 seconds. The vehicle will start and run the predetermined time set up

during installation (5 to 60 minutes selectable).

Remote Start Shutdown

Press and release the button 2 times within 2 seconds to turn the vehicle o󰀨.

Pressing the vehicle’s brake will also shutdown the remote start.

Using the Personal Protection Alarm (Panic) (Optional)

If this feature is enabled on your system, press and hold the button for 3 seconds

to activate the personal protection alarm. To stop the alarm, press and hold the

button on the transmitter again for 3 seconds.

Remote Start Valet Mode

Enter / Exit Valet mode for systems using an Flashlogic FLRS kit.

1. Cycle ignition ON ve times [5x OFF/ON] rapidly. (complete this step

within 7 seconds)

2. Wait, LED 1 (on the FLRS kit) will turn solid RED for 2 seconds.

3. Turn ignition to OFF position.

4. Valet Mode Programming Procedure completed.

NOTE: In Valet Mode, the Remote starter is not functional. On units with Keyless

Entry, Lock and Unlock will remain functional. To exit valet mode: repeat steps 1 to 4.

Entering the Vehicle while it is Running via Remote Vehicle Start

1. Unlock the vehicle’s doors.

2. Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL!

3. Insert the key into the ignition switch and turn to the ON or RUN

position.

4. Press the brake pedal. The remote vehicle starter will disengage and

the vehicle will operate normally.

NOTE: This feature may not be available on all vehicle makes/models. In some

vehicle applications the the remote start will shut down upon entering the vehicle and

the engine will stop running. For these applications it will be necessary to restart the

vehicle normally. Refer to installing dealer for details.

Preheating or Precooling the Vehicle’s interior

Before exiting the vehicle, set the temperature controls to the desired setting and

operation. After the system starts the vehicle, the heater or air conditioner will

activate and heat or cool the vehicle’s interior to your setting.

5PE2LEDZ - PE1M2LEDZ / FLRS Owners rev A.

 2WayRemoteControlNotications

  FUNCTION   BEEPS/LEDFLASHES

Lock 1 Beep / Flash

Unlock 2 Beeps / Flashes

Trunk Release 2 Beeps / Flashes

Remote Start Activation RS Activation Melody

Conrm Remote Start 4 Beeps / Flashes

Remote Start Running 1 Flash per 5 seconds for duration run time

Remote Start Shutdown RS Shutdown Melody

Car Find / Panic 2 Beeps / All LEDs Flash per 3 seconds -

Repeats 9 times

Remote Control Programming

1. Cycle ignition ON ve times [5x OFF/ON] rapidly. (complete this step

within 7 seconds).

2. Press 1 button of each transmitter you wish to program, the LED’s will

ash to conrm each transmitter.

3. Turn the ignition OFF.

NOTE: This system has 1 button programming which programs all channels of the

system.

NOTE: The system will hold up to 4 transmitters in memory, programming a 5th

transmitter will erase the oldest transmitter in memory.

 ReplacingRemoteControlBatteries

5 Button Remote Control - Model 185SP (PE2LEDZ Only)

The CR2032 battery inside each remote control should last approximately 1 year under

normal use. When the battery becomes weak you will notice the remote control range

(the distance from the vehicle the remote control will work) deteriorate and the small LED

on the remote control will dim. To replace the remote control batteries:

1. Using a coin, disassemble the halves of the remote

control.

2. Remove the old battery, observing the +/- symbols on the

batteries and replace with a new battery.

3. Reassemble the halves of the remote control

4. Test operation of the remote control.

2 Way LED Remote Control - Model 185TWSP (PE2LEDZ Only)

The CR2450 battery inside the 2-way LED remote control should last approximately 6

months under normal use. When the battery becomes weak you will notice the remote

control range (the distance from the vehicle the remote control will work) deteriorate and

give an additional ash upon button presses. To replace the remote control batteries:

1. Using a coin, disassemble the halves of the remote

control.

2. Remove the old battery, observing the +/- symbols on the

batteries and replace with a new battery.

3. Reassemble the halves of the remote control

4. Test operation of the remote control.

7PE2LEDZ - PE1M2LEDZ / FLRS Owners rev A.

2 Way LED Remote Control - Model 18TWLOR (PE1M2LEDZ Only)

The CR2450 battery inside the 2-way LED remote control should last approximately 6

months under normal use. When the battery becomes weak you will notice the remote

control range (the distance from the vehicle the remote control will work) deteriorate and

give an additional ash upon button presses. To replace the remote control batteries:

1. Using a coin, disassemble the halves of the remote

control.

2. Remove the old battery, observing the +/- symbols on the

batteries and replace with a new battery.

3. Reassemble the halves of the remote control

4. Test operation of the remote control.

Voxx Electronics Corporation.

Customer Service 1-800-225-6074

www.PrestigeCarSecurity.com

FCC COMPLIANCE

This device complies with Part 15 of the FCC rules and with RSS-210 of

Industry Canada. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including any interference that

may cause undesired operation.

Warning!

Changes or modications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

PATENTED: www.voxxintl.com/company/patents

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Prestige Avviamento remoto

Prestige

Prestige APSRS Manuale di installazione e funzionamento

Prestige

Prestige PE5B Manuale utente

Prestige

Prestige PE2LED Manuale utente

Prestige

Prestige APS57Z Manuale utente

Prestige

Prestige Platinum+ APS 685 Manuale utente

Prestige

Prestige APS-422E Manuale utente

Prestige

Prestige APS-55C Manuale utente

Prestige

Prestige APS901TWE Manuale utente

Prestige

Prestige APS622E Manuale utente

Prestige

Prestige PE5BZ Manuale utente

Prestige

Prestige PE1BTWZ Manuale utente

Prestige

Prestige Prestige Platinum 128-8129 Manuale utente

Prestige

Prestige PE2RELCDZ Manuale utente

Prestige

Prestige APSRS Manuale utente

Prestige

Prestige APS 750a Manuale utente

Prestige

Prestige APS57Z Manuale utente

Prestige

Prestige PE1BZLR Manuale utente

Prestige

Prestige Prestige 07S3BP Istruzioni operative

Prestige

Prestige PE2RELCD Manuale utente

Prestige

Prestige Platinum+ APS 786 Manuale utente

Prestige

Prestige APS-901E Manuale utente

Prestige

Prestige PLATINUM APS-901C Manuale utente

Prestige

Prestige APS901 - Car Prestige Remote Start Manuale utente

Prestige

Prestige Platinum Prestige APS-750 Manuale utente

Manuali Avviamento remoto popolari di altre marche

AstroStart

AstroStart 803U Manuale utente

Durite

Durite 0-649-20 Manuale

EINHELL

EINHELL BT-PS 1000 Manuale

Linear

Linear ACCESS AK-21 Specifiche tecniche

Soundstream

Soundstream TARANTULA RS.2 Manuale utente

Jaycar Electronics

Jaycar Electronics MB3752 Manuale utente

Ultra Start

Ultra Start 72 Series Manuale utente

ADS

ADS FLASHLOGIC FLRSVW1 Manuale utente

Selecta

Selecta JS012 Manuale utente

Black Widow Security

Black Widow Security BW RAS 400 Manuale utente

Vector

Vector Power City DK080706 Supplemento

Code Alarm

Code Alarm CA-535 Manuale utente

Ozito

Ozito OJS-800 Manuale utente

Profi-Partner

Profi-Partner 46387 Manuale utente

EZ STARTER

EZ STARTER EZ-45 Manuale utente

Viper

Viper 4204 Manuale utente

Essex Electronics

Essex Electronics KE-1701 Manuale utente

EINHELL

EINHELL EGS 3600 Manuale