Primare V10 Manuale utente
>
i
Primare V10 DVD Player User Guide
§0 Preface 14/11/00, 12:11 pm1
>Preface
ii
COPYRIGHT AND ACKNOWLEDGMENTS
Copyright © 2000 Primare Systems AB. All rights reserved.
Primare Systems AB
Idavägen 17D
SE-352 46 Växjö
Sweden
The information in this guide is believed to be correct as of the date of
publication. However, our policy is one of continuous development and so the
information is subject to change without notice, and does not represent a
commitment on the part of Primare Systems AB.
Primare is a trademark of Primare Systems AB. Manufactured under license
from Dolby Laboratories Dolby, Pro Logic, and the double-D symbol are
trademarks of Dolby Laboratories. Confidential Unpublished Works. Copyright
1992-1997 Dolby Laboratories, Inc. All rights reserved. All other product
names are trademarks or registered trademarks of their respective owners.
This product incorporates copyright protection technology that is protected by
method claims of certain US patents and other intellectual property rights
owned by Macrovision Corporation and other rights owners. Use of this
copyright protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited viewing uses only
unless authorized by Macrovision Corporation. Reverse engineering or
disassembly is prohibited.
Class 1 Laser Product
The DVD player is classified as a CLASS 1 LASER product. Use of control
adjustments or Performance of procedures other than those specified herein
may result in hazardous radiation.
CAUTION – INVISIBLE LASER RADIATION WHEN OPEN AND INTERFLOCK
DEFEATED. AVOID EXPOSURE TO BEAM.
FCC Warning: This equipment generates and can radiate radio frequency
energy and if not installed and used correctly in accordance with our
instructions may cause interference to radio communications or radio and
television reception. It has been type-tested and complies with the limits set out
in Subpart J, Part 15 of FCC rules for a Class B computing device. These limits
are intended to provide reasonable protection against such interference in
home installations.
EEC: This product has been designed and type-tested to comply with the limits
set out in EN55013 and EN55020.
This guide was produced by Human-Computer Interface Ltd,
http://www.interface.co.uk
§0 Preface 14/11/00, 12:11 pm2
>
iii
Contents
Introduction
WELCOME TO THE V10 DVD PLAYER ............. (1
USING THE V10 WITH OTHER PRIMARE
PRODUCTS................................................................ (2
TECHNICAL SPECIFICATION............................. (2
Using the V10 DVD Player
FRONT PANEL CONTROLS.................................. (3
FRONT PANEL DISPLAY......................................... (4
SWITCHING ON AND OFF................................ (4
PLAYING A DISC.................................................... (4
LOCATING A POSITION ON THE DISC........ (6
Advanced use
FAST FORWARD AND REVERSE PLAY.............. (7
SLOW MOTION FORWARD AND
REVERSE PLAY.......................................................... (7
SINGLE STEPPING................................................. (8
REPEATING PLAYBACK.......................................... (8
DISPLAYING THE TITLE MENU........................... (9
DISPLAYING SUBTITLES........................................ (9
SELECTING A CHAPTER, TITLE, OR
TRACK BY NUMBER............................................... {10
PROGRAMMING A SELECTION OF
CHAPTERS OR TRACKS ........................................ {10
SAVING A PROGRAM............................................ {11
ZOOMING THE PICTURE..................................... {13
CHOOSING A CAMERA ANGLE....................... {13
Connecting the V10 DVD Player
BACK PANEL CONNECTIONS........................... {15
VIDEO OUTPUTS..................................................... {16
AUDIO OUTPUTS.................................................... {16
CONNECTING TO THE PRIMARE P30
PROCESSOR ............................................................. {16
§0 Preface 14/11/00, 12:11 pm3
>Preface
iv
Configuring the V10 DVD Player
USING THE SETUP MENU................................... {17
CHOOSING THE DEFAULT LANGUAGES....... {18
SETTING THE DEFAULT SCREEN FORMAT .... {19
SETTING THE RATING LEVEL............................. {19
SPECIFYING THE AUDIO OUTPUT................... {21
SPECIFYING ADDITIONAL SETUP
OPTIONS................................................................... {21
LANGUAGE CODES............................................... {23
Index
§0 Preface 14/11/00, 12:11 pm4
>
1
Introduction
Welcome to the Primare V10 DVD Player! This chapter introduces you to its key
features, and explains how you can use it to take advantage of any of the
video and audio formats currently available.
WELCOME TO THE V10 DVD PLAYER
The V10 provides a comprehensive range of features to make it ideal as the
heart of a superb home entertainment system.
Enjoy DVD movies at their best
The Primare V10 DVD Player will show all your favorite movies in DTS, Dolby
Digital, or Dolby Pro logic surround. It supports both PAL and NTSC format,
and if your television does not support both formats it can perform automatic
conversion between them.
Play your existing music collection and Super CDs
The Primare V10 DVD Player can also play your entire CD music collection, as
well as CDVs and 24/96 Super CDs. It will also play recordable CDs, as
well as MP3 encoded music collections on CD-ROM.
No compromise design for superb sound and picture quality
The V10 DVD Player uses the best components available to ensure a trouble-
free operation for many years. The resulting sound quality is comparable to
dedicated CD players in the same price range.
Careful mechanical design for long-life
As with all Primare units, the solid mechanical design further enhances the
functionality and quality, and ensures that the V10 DVD Player will continue to
provide trouble-free operation for years to come.
Intuitive user interface
In keeping with the philosophy of the Primare range of systems, the V10’s
powerful range of features can be controlled through a very simple and
intuitive interface, designed so that it will not distract you from the pleasure of
watching movies or listening to music on your system.
In fact most of the features of the V10 can be accessed through just six front
panel push buttons. Alternatively the full set of functions, including menu
selection and programmability, is available using the DVD remote control
supplied with the V10.
§1 Introduction 14/11/00, 2:53 pm1
>Introduction
2
USING THE V10 WITH OTHER PRIMARE PRODUCTS
Although the V10 DVD Player is flexible enough to work with virtually any
other equipment you have in your system, it is ideally suited for use with the
Primare P30 Processor and Primare A30.5 multi-channel amplifier. The P30
Processor will decode the DTS or Dolby Digital output from the V10 to
provide five discrete analogue outputs, and the A30.5 provides the
amplification necessary to drive the five separate loudspeakers in a surround
system.
TECHNICAL SPECIFICATION
Video section:
Video signal systems NTSC/PAL, color
Horizontal resolution > 500 lines
SCART 1Vp-p, 75Ω
S-video Y signal 1Vp-p, 75Ω
C-signal 0.286Vp-p, 75Ω
Video signal-to-noise -70dB
Video DAC 10 BIT
Audio section:
Frequency response 44.1kHz, 10Hz – 20kHz
48kHz, 10Hz – 22kHz
96kHz, 10Hz – 44kHz
THD <0.05%
Signal-to-noise -96dB
Analogue output level 1.9Vrms
Power consumption <40W
Dimensions (WxDxH) 430 x 275 x 75mm
Weight 6.5kg
Formats supported: DVD with DTS, Audio CD, CD-Video, Video CD, Recordable CD,
and MP3 CD-ROM
§1 Introduction 14/11/00, 12:11 pm2
>
3
Using the V10 DVD Player
This chapter explains how to operate the basic functions of the V10 DVD Player,
which are available using either the front panel controls or the remote control.
FRONT PANEL CONTROLS
The simplest functions of the V10 DVD Player can be accessed using the three
front panel push buttons, and information about its operation is displayed on
the front panel display:
]A The OPEN button opens or closes the disc tray.
]B The PLAY button plays or pauses a disc.
]C The STANDBY button switches the V10 to standby, or brings it out of
standby.
STANDBYPLAYOPEN
09 53:29
DVD
NTSC
CHAPTER 1 2 3
456
789
10 11 12
13 14 15
>
=
V10 DISC PLAYER
]A ]B ]C
§2 Using 14/11/00, 12:11 pm3
>Using the V10 DVD Player
4
FRONT PANEL DISPLAY
The following illustration shows the information on the front panel display:
09 53:29
DVD
NTSC
CHAPTER DOLBY
DIGITAL
PROGRAMREPEAT
ALL
123
456
789
10 11 12
13 14 15
>
=
]I
]A ]B
]J]H
]F ]G]C ]E]D
]A Disc format.
]B Play mode.
]C Display mode: CHAPTER OR TRACK.
]D Repeat mode: REPEAT 1, ALL, or A-B.
]E Audio format.
]F Program mode.
]G Chapters/tracks.
]H Video format: PAL or NTSC.
]I Currently selected chapter/track.
]J Current playing time.
To dim the front panel display
•Press the DIM button on the DVD or C30 remote control.
The display will dim to a single bar.
To restore the front panel display
•Press the PLAY button twice on the DVD or C30 remote control.
SWITCHING ON AND OFF
To switch on
•Use the switch under the left-hand edge of the front panel.
During normal operation you can leave the V10 switched on and in standby.
To switch to standby
•Press the STANDBY button on the front panel or the STBY button on the
DVD or C30 remote control.
PLAYING A DISC
To insert a disc
•Press the OPEN button on the front panel or the DVD or C30 Remote
Control to open the tray.
The on-screen display shows .
•Place the DVD or CD in the tray. If it is a CD or a single-sided DVD the
label should be uppermost.
§2 Using 14/11/00, 12:11 pm4
<
Using the V10 DVD Player
5
•Press the OPEN button again to close the tray, or gently push the front of
the tray.
The on-screen display shows .
The disc will start playing automatically.
As the disc starts playing the on-screen display identifies the type of disc as
follows:
Symbol Disc
DVD movie.
Audio CD.
Video CD.
Super Video CD.
DTS music CD.
CD-ROM containing MP3 files.
Unrecognised format or disc inserted incorrectly.
To stop play
•Press the STOP button on the DVD or C30 Remote Control.
The on-screen display shows .
The DVD player remembers your current position on the disc and you can
resume from the same position by pressing the PLAY button on the front panel
or DVD or C30 Remote Control.
The on-screen display shows
To pause play
•Press the PLAY button on the front panel or DVD or C30 Remote Control.
The on-screen display shows . You can then resume play by pressing the
PLAY button again.
To reset play
•Press the STOP button twice on the DVD or C30 Remote Control.
The display shows and the disc will be reset to the beginning.
§2 Using 14/11/00, 12:11 pm5
>Using the V10 DVD Player
6
LOCATING A POSITION ON THE DISC
DVD movies are normally divided into chapters corresponding to scenes in the
movie, and you can step between chapters to choose the scene you want to
watch. Audio CDs are divided into tracks.
To step between chapters on a DVD or tracks on a CD
•Press the ” or ’ buttons on the DVD remote control, or the [ or ]
buttons on the C30 Remote Control.
The on-screen display will show or as you step, and the front panel
display shows the current chapter or track number.
If you step between chapters on a DVD while the disc is paused it will wait for
you to press the PLAY button before playing from the chapter you have
selected.
§2 Using 14/11/00, 12:11 pm6
Indice
Altri manuali Primare Lettore DVD
