Correct Method of Use
Operate the product following reading the manual surely.
The proper charging of a battery can be initiated only after carefully reading the manual.
When the equipment is operated without reading the manual outside the advised standard of operation, we take no responsibility for any consequent
problems like a breakdown of the product and/or the damage of a battery.
Look around the surroundings again before installing a product and operating an equipment.
This equipment uses the high voltage and high current. Please be advised to look around the surroundings again and check the danger of a current leakage
and an electric shock and and re. Also look around the surroundings not to get the closed work space.
Don't use the product at the closed and humid place. Please use at the airy place.
At the moment of the regeneration and charge of a battery, the sulfate attached on the lead of a battery is mixed with distilled water and is restored, and
the hydrogen gas(sulfurous acid gas) happens. The health may be harmful in case of being exposed to this gas at the closed space for a long time.
Don't be used at the closed working area, please be advised to be ventilated.
Please use the power outlet which is ground-functioned.
Please surely use the power outlet which is ground-functioned. As the product is the equipment which uses the high voltage and high current, the danger of
a current leakage and an electric shock may be caused. Please use it following installing the earthing device in case of using the outlet which is not ground-
functioned. Also Don't use other electric products with ground wires.
Connect carefully and properly the terminal of a battery.
Please connect the connector tongs of the product with the terminal of a battery exactly and tightly. If the connection is loosen up and is not connected
correctly, the operation of regeneration and charge will not be implemented properly. the current leakage and the electric shock may be caused.
The interval between the product and the battery to be restored should be kept more than 1M at least.
If the battery begins being regenerated and charged, the hydrogen gas(sulfuric acid) happens in the electrolyte of the internal battery. Only if the interval
between the product and the battery is close, the component of sulfuric acid occurred in the battery can corrode the circuit board being owed into the
internal product. To protect this state, the interval between the product and the battery should be kept more than 1M.
The air vents of the product is installed reversely against the battery, so the gas in ow of the product should be prohibited thoroughly.
Input the same value as the specification of a battery at the moment of the set-up.
Please check the specication of the battery on the exterior of a battery before carrying out the discrimination and regeneration, charge of a battery.
The proper operation can be implemented only if the same setting value as the specication on the exterior of a battery.
The damage and overcharge & undercharge of a battery may be caused in case of the wrong setting value.
Make sure to wear protective gear for safety, and prepare washing utensils in advance.
During working, make sure you should prepare an eye cleaning kit, water and soap close to you, in case your skin, clothes or eyes get in contact with acid
or electrolyte. During touching battery, make sure to wear globe and glasses. Do not touch your eyes with your hands while working on batteries.
If your skin or clothes get in contact with electrolyte, make sure to clean immediately with clean water and soap. If electrolyte gets into your eyes,
immediately rinse them with clean water for about 10 minutes and contact your closest hospital.
Please check the impurity concentration of the electrolyte before restoring and charging the repair-typed battery.
Please surely check the impurity concentration of the electrolyte following extracting the electrolyte of the internal Cell separately. If the concentration of the
electrolyte is not transparent, is almost gray or black, and if the lump of the black impurity is oating in the electrolyte, it means that the interior lead plate of
the Cell is corroding and has already corroded. the regeneration and charge of a battery can not be carried out.
Replenish the flood type battery with only distilled water after regenerating and charging.
Only if the regeneration is completed, and the value of a specic gravity is not clear, or only if the distilled water is replenished too much, and the value of a
specic gravity is not clear with the electrolyte overowing, the sulfuric acid is replenished in the internal Cell, and never replenish the sulfuric acid other than it.
Please be advised to have help from an expert at the moment of replenishing the sulfuric acid.
Surely open the Cell Cap(supplementary lid for distilled water) and check whether the electrolyte is or is not
there before carrying out the regeneration or charge of the repair-typed battery.
Generally if all of the electrolyte of the internal Cell is evaporated, the regeneration and charge of the Cell is no longer possible. Only if the dried battery
with all of the distilled water being evaporated is regenerated or charged, the explosion may be caused. So surely open the Cap the Battery Cell before
operating the product and check whether the electrolyte is in or is not there.
