Prior Scientific ProScan III Manuale utente
ALWAYS MAKE SURE THE POWER TO THE PROSCAN III IS
OFF BEFORE CONNECTING OR DISCONNECTING
ANY COMPONENTS
IMPORTANT SAFETY
INFORMATION
PLEASE READ THE MANUAL BEFORE USING!
THE MANUAL IS AVAILABLE FROM PRIOR SCIENTIFIC AND SHOULD BE
READ AND UNDERSTOOD BEFORE INSTALLATION AND USE.THE
MANUAL IS AVAILABLE FROM WWW.PRIOR.COM
• Adhere to all warnings on the product and in the user manual.
• This product MUST NOT be exposed to open ames, extremely hot or cold
temperature, water or moisture. DO NOT allow objects to fall, or liquids to spill, on
the product.
• The ProScan III is a Class 1 system and must be earthed.
• Connect the AC power cord only to designated power sources as marked on the
product. Make sure the electrical cord is located so that it will not be subject to damage.
• Ensure the connection to the power source and the front panel power switch are
easily accessible.
• Do not connect or disconnect anything to or from the ProScan III unless the controller
is turned off rst.
• DANGER – Never alter the AC cord or plug. The power cord set must be an
appropriately rated and approved cord set in accordance in the regulations of the
country it is used in. If the supplied plug adapter is not the correct tting for your
geographic area or if you are unsure about the relevant regulations, please contact your
supplier for advice.
• Do not attempt to disassemble, tamper or repair this product; it contains
NO user serviceable parts and doing so may void the warranty.Service should
be performed ONLY by authorised service centres.
• Clean only the exterior of this product using a damp, lint free cloth.
• Please contact Prior or an approved representative if you have any questions or
comments.
Filter 1
Filter 2 A Axis Shutter 3 Shutter 2
Encoder Z
Encoder Y
Encoder X
Focus
Stage
RS232-1
RS232-2
Power on/off
Power Socket
USB
Joystick
CANBUS
Shutter 1
TTL
CONNECTIONS
!
! !
!
The ProScan III now utilises Win. 7, 8 and 10 compatible driver which
automatically install.
ENSURE THE CORRECT ENCODER CABLE GOES INTO THE CORRECT PORT
READ THE MANUAL BEFORE USE (WWW.PRIOR.COM)
QUICK SET UP
Encoded connection between ProScan III and encoded Prior Device Connection between ProScan III and Prior Device
COMPUTER
Control Stage Focus Illumination
QUICK SET UP
ProScan III Quick Start Guide © Prior Scientic 2015
W4641 REV A
ALWAYS MAKE SURE THE POWER TO THE PROSCAN III IS OFF BEFORE
CONNECTING OR DISCONNECTING ANY COMPONENTS!
! !
Altri manuali per ProScan III
4
Altri manuali Prior Scientific Controllori
