Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
Administrator can authorize up to 10 users and can delete all ngerprint settings on this lock. When entering
ngerprints, press ngerprints at various angles and locations on the ngerprint pad.
The Secure Touch Lock is a simple, easy-to-use ngerprint padlock. Users
can open lock quickly without a password.
When lock is in demonstration state, any ngerprint can open it. Please read
and follow complete instructions before using lock.
The battery is low if the RED light ashes 3 times while unlocking. Five
RED ashes indicate the lock cannot be used again until it is recharged.
Lock can be unlocked while charging.
WARNING: If setting button is pressed in Factory State, lock will set this as
the Admin’s ngerprint entry, even if no print is collected. Please be cautious.
STARTING
Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
2. Press your nger three
times on the sensor
1. Click the bottom setting
button. BLUE light will
blink rapidly
Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
A BLUE light will turn on, then turn o.
This indicates the Administrator ngerprint
has been registered successfully.
A RED light will indicate failure to
register the Administrator ngerprint.
Return to step 2.
Lock Shackle
Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
1. 3 blinking RED lights indicate a
low battery; the lock cannot be
used until the USB charge cable is
connected to a power source
Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
2. Open the micro-USB charge port
cover and insert the micro-USB
cable into the port. Connect the
micro-USB cable to a power source
A RED pulsing light indicates the
battery is charging.
Fingerprint
Pad
Setting
Button
Micro-USB
Charge Port
TSA007 Lock
Cylinder
LED
Instruction
Light
CHARGING LOCK BATTERY FULLY CHARGE BEFORE USING
REGISTERING THE ADMINISTRATOR FINGERPRINT
Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
A solid BLUE light indicates the
battery is fully charged.
