Pro-Elec PEL01345 Manuale utente
1
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
• When using electrical appliances basic safety precautions should always be
followed.
• Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
Safety Information for Installation and Operation
• Avoid excessive force when installing.
• Always install on a surface that can support the weight of the xture.
LED LANTERN WITH PIR SENSOR
Model: PEL01345 and PEL01348
2
INSTALLATION
• Turn off or isolate the mains supply.
• Remove the two domed nuts on the mounting plate
and remove the wall mount plate.
• Offer the wall mounting plate to the wall in the
desired position with reference to the supply wiring
and mark the location of the 2 mounting holes.
Note: The cut out in the ange must go to the bottom
and the plate is marked UP.
• Drill the wall where marked taking care not to drill through hidden wiring or
pipework and t the wall plugs.
• Insert the supply wiring through the
grommet and place the mounting plate
against the wall and attach with the screws
into the wall plugs.
• The lantern diffuser may also be removed from the bracket if
required to aid visibility when making the wiring connections.
3
• Offer up the bracket unit so that the mains supply
wiring can be connected to the terminal block as
follows:
Connect the positive supply wire (brown or red) to the
terminal marked L.
Connect the neutral supply wire (blue or black) to the
terminal marked N.
• Ret the lantern bracket to the wall plate and replace the two domed nuts.
• Replace the lantern diffuser if removed earlier, by
locating the lugs and rotating to locate securely
and slide in the glazing sheets.
• Fit an appropriate lamp E27 Max 11W (not supplied).
• Restore the mains power supply.
• Attach the capping to the main assembly by engaging the
lugs and turn it to locate securely.
• Fit the nial onto the capping by turning it until it locks into
place.
4
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical
& Electronic Equipment (WEEE). Any WEEE marked products must not be mixed with
general household waste, but kept separate for the treatment, recovery and recycling
of the materials used. Contact your local authority for details of recycling schemes in
your area.
Made in China. PR2 9PP
Man Rev 1.1
SPECIFICATIONS
CLEANING AND MAINTENANCE
OPERATION
• Clean only with a damp cloth with a little liquid detergent. Do not use any
chemicals, abrasives or solvents that may damage the product.
• When the lamp is powered on it will light when motion is detected only during low
light levels.
Voltage 220-240V~50Hz
IP rating IP44
Lamp type E27 11W Fluorescent or LED
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Pro-Elec Lanterna
Pro-Elec
Pro-Elec PEL01356 Manuale utente
Pro-Elec
Pro-Elec PEL01343 Manuale utente
Pro-Elec
Pro-Elec PEL01356 Manuale utente
Pro-Elec
Pro-Elec PEL01340 Manuale utente
Pro-Elec
Pro-Elec PEL01358 Manuale utente
Pro-Elec
Pro-Elec PEL01364 Manuale utente
Pro-Elec
Pro-Elec PEL01354 Manuale utente
Pro-Elec
Pro-Elec PELL0263 Manuale utente
