5a Angled on Wall
800.338.3884 • procaresoftware.com
Wall
Tabs
Screws
Screws
32° 38° 44°
Begin with the base mount
securely fastened to the wall
(fasteners not included).
Place the mount plate as you
see above. Be sure the tabs
are pointed up. Install screws
in the 4 positions noted.
A B
1
4 5 6 7
8 9 10 11
Secure the two plates using
the tension knob. These plates
are designed to be a tight fit,
you may need assistance.
Run cables through the
cut-outs in the mount plate
before installing cord guard.
Place the cord guard over the
cords and align with the holes
on the mount plate.
Secure the cord guard by
installing two screws on the
back side of the mount plate.
Lift the PC/mount plate as
shown. Insert the tabs into the
slots at the top of the base
mount attached to the wall.
Once both tabs are fully
inserted, lower the PC at
an angle. For safety, do not
leave the PC “hanging” on
the mount plate tabs.
Install the perforated
adjustment plate (Part E)
to the mount plate as shown.
Install the studded adjustment
plate (Part D) to the base
mount. Select 1 of 3 angles
by inserting the stud into
one of the 3 holes.
3
Position the PC facedown on
a protected/padded surface.
2
C
Copyright 2020 Procare Software, All rights reserved
