ProFlow PFE-HC7110BK Manuale utente
EMAIL: sales@proflow.com.au
PHONE: 1300 879 879
Installation Manual
Electric Fan Controller Kit
PFE-HC7110BK / PFE-HC7111BK
WARNING: PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING. PROFLOW WILL NOT BE
RESPONSIBLE FOR ANY DAMAGE AS A RESULT OF THE INCORRECT INSTALLATION OF THIS
PRODUCT. IT IS RECOMMENDED THAT A QUALIFIED AUTOMOTIVE TECHNICIAN PERFORMS THIS
INSTALLATION.
Control Module Installation
1. Choose an appropriate location to mount the relay. Preferred location will be near the
battery and where the thermostat will be located. Do not mount next to high heat
sources such as near exhaust housings, etc.
2. Use the modules mounting surface as a template to find and mark the mounting holes.
Drill 4x 5/32” holes in the correct locations.
3. Use the supplied screws to secure the unit.
Thermostat Installation
Thread-in Thermostat
1. Locate a 3/8” NPT port either on the radiator, water neck, intake manifold or cylinder
head.
2. Using teflon tape, thread the 3/8” theromstats into the desired location.
Probe Thermostat
1. The thermostat probe must be inserted into the core of the radiator. The best location
for the probe will be near the inlet of the radiator, in between the fins.
2. The probe should be secured tightly in between the radiator fins (full width of radiator).
Included Items
QTY
Fan Control Module
1
Harness with Push in Probe OR Thermostat
1
Blue Butt Connectors
2
Blue 5/16” Ring Terminal
1
Blue #10 Ring Terminal
1
Blue Wire Tap Connector
1
Red Butt Connector
1
12 Gauge Red Wire
1
4” Wire Ties
4
6
EMAIL: sales@proflow.com.au
PHONE: 1300 879 879
2
Wiring
1. Before starting, disconnect the negative terminal on the battery.
2. Red (loose wire): positive battery to positive fan lead.
3. Red (w/fuse): negative fan lead.
4. Black wire: Chassis ground.
5. White wire: Ignition power.
6. Green wire: A/C override circuit. The green wire is designed to work in two different
configurations. When used, this will allow the fan(s) to be turned on when the A/C is
being used (regardless of temperature). This overrides all other functions.
(a) Using the blue wire tap provided, attach the green wire to the positive lead on
the air conditioning compresor.
(b) Manual switch override: attach the green wire to the manual switch (not
included) with a positive feed.
Figure 1: Wiring diagram
Temperature Adjustment
1. Remove the rubber plug.
2. Turn adjustment screw counter clockwise to lower the starting temperature.
3. Turn adjustment screw clock wise to raise the starting temperature.
4. Reinstall the rubber plug.
5. Ensure all loose wires and fittings are secured and tightened. Start the car and wait
until the fan turns on. If it does not, turn the adjustment screw counter clockwise in
small increments until the fan starts.
PROFLOW LIMITED WARRANTY
This Proflow product is warranted to be free from defects in materials and workmanship for a
period of one year from the original date of purchase. No warranty claim will be valid without
authentic, dated proof of purchase. This warranty is to the original retail purchaser and none
other and is available directly from Proflow and not through any point of distribution or purchase.
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali ProFlow Controllori
